brondell CS-30 CleanSpa Hand Held Bidet Instruction Manual
- June 5, 2024
- brondell
Table of Contents
brondell CS-30 CleanSpa Hand Held Bidet Instruction Manual
Parts Included:
- Bidet Sprayer Head
- T-valve w/Shut Off
- Flat Rubber Washer
- Spiral Metal Bidet Hose
- Sprayer Holster & Screws for Mounting (wall & toilet options)
Before Installation
Check water supply line: If the line that connects the toilet tank to the water shutoff valve is a rigid pipe, you will need to purchase a flexible hose to replace it before installing the CleanSpa. The length of the hose and size of the connectors will vary.
Installation
-
Turn off water supply valve for the toilet (at the wall) and flush toilet (holding down handle) to completely empty the tank. (Image 1)
-
Disconnect flexible water supply line directly under the toilet tank. Put the Flat Rubber Washer inside the top of the T-valve w/Shut Off. Connect T-valve w/Shut Off at the toilet tank, and reconnect the flexible water supply line to the bottom of the T-valve. Be sure not to over tighten connections. (Image 2)
-
Attach one end of Spiral Metal Bidet Hose to open end of T-valve w/Shut Off and the other end to the Bidet Sprayer Head. (Image 3)
-
Mount Sprayer Holster: (Note: when mounting Bidet Sprayer Head, make sure the spray button is pushed out towards the spray head as pictured, this is the “off” position)
a. Wall Mount – using only the Sprayer Holster piece, find appropriate spot on wall near toilet and use screw (included) to attach Holster to wall.
b.Toilet Mount – attach Sprayer Holster piece to toilet mount piece using small screw (included). Hang mount on side of toilet in desired location. (Image 4)
-
Turn water supply valve back on at the wall and check for leaks using plumbers tape when necessary. Wait 5 minutes and check again. If no leaks, then you are done!
Operation
-
Open the T-valve Shut Off Valve to allow water to flow to the Bidet Sprayer Head.
-
Direct the hand held Bidet Sprayer Head in the appropriate direction and press the button to release the water wash. (Image 5)
-
To adjust the wash spray, gently turn the head of the Bidet Sprayer counter-clockwise to go from a shower spray to a single stream.
-
To stop water wash, push Bidet Sprayer Head button into the “off” position (button pushed out towards the spray head)
IMPORTANT!
Manufacturers Recommendation: After each use, TURN OFF the T-valve Shut Off Valve to close the water supply to the Bidet Sprayer Head. Failure to turn off after each use may weaken the Bidet Hose/Sprayer Head or cause flooding. Manufacturer is not responsible for damage which may be caused by failure to follow the above recommendation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>