Insta360 Titan Professional 360 VR 3D Camera Installation Guide
- June 13, 2024
- Insta360
Table of Contents
Insta360 Titan Professional 360 VR 3D Camera Installation Guide
Scan to learn more about the product https://insta360.com/r/manual_titan
Insta360 Titan Overview
- For the first use, you need to remove the rubber cap to make the port visib e.
2 Before You Start
- Activate the battery and install antennas: The first time you use the camera, please connect the included power adapter (input: 19V 9A) to the camera to power it on, so that its battery is activated.
• While installing the antennas, please connect the corresponding antennas to
corresponding ports.
• When charging the battery inserted into this camera using the included power
adapter, the battery is not charged at battery temperatures below OOC (32 OF )
or above 450C (113 a F ), which is not a malfunction. As the battery
temperature decreases, it can be charged aga•n.
3. Specifications
4. Download the Official App
Scan the QR code below or visit https://www.insta360.com/r/download_insta360titan to download Insta360 Titan’s offcial control app.
5. Connect and Control your Titan
You can connect to your Titan via wire, WiFi or Insta360 Farsight. You can
connect using an iPad, phone, or computer to control the camera.
If you wish to connect via wire, you must use a network cable or local area
network (LAN). It is strongly recommended that the camera be remotely
controlled through Farsight, which has the most stable signal and the farthest
communication distance.
5.1 Farsight Connection
• Farsight Overview
Press and hold the power button of the transmitter for 3 seconds to power It
on. And then connect the camera and the transmitter with a network cable. When
the camera and the transmitter starts up successfully, the IP address on the
OLED screen of the camera will be displayed as 192.168.1 OO.XXX (2M253).
Press and hold the power button on the receiver for about 3 seconds to turn it
on, and then connect your phone / tablet / computer to the receiver with a
suitable cable.
* Note:
When the receivers connected to a phone or tablet, pull open the bottom lever
to adjust the length of the receiver so that the phone or tablet can be placed
properly onto the receiver.
When the receiver is connected to a computer a LAN port, you can use a network cable to connect the receiver and the computer; when the receivers connected to a computer with a USB port, you can use a Micro-USB cable (or use a USB Ethernet network adapter and a network cable) to connect the receiver and the computer; when the receiver is connected to a phone / tablet, use the included compatible cable to connect the receiver and the phone / tablet .
5.2 Wired Connection -—DHCP mode
5.3 Wired Connection ——Direct connection mode
5.4 Wireless Connection —— connect client devices to camera’s AP hotspot
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>