brondell CleanSpa Luxury Hand Held with Holster Installation Guide

Installation Guide

PRODUCT INSTALLATION

Before Installation

You must have a CleanSpa hand-held bidet or equivalent product with a %” connection sprayer hose in order to install the Hand-Held Bidet Holster with Integrated Shut Off.

IMPORTANT
Please be advised that the provided cold water T-valve should be installed at the fill valve under the toilet tank, NOT at the cold water supply coming from the wall.

Check Water Supply Line
If the pipe that connects the toilet tank fill valve to the water shutoff valve at the wall is rigid, you will need to purchase a flexible water supply hose to replace it before installing the Hand-Held Bidet Holster with Integrated Shut Off. The length of the hose may vary and the top connection size should be %” ballcock to connect to the T- valve t h a t you will install under the toilet tank and the bottom connection will vary (most common are %” and %” female compression).

Installation

Please read these instructions carefully before installing your Hand-Held Bidet Holster with Integrated Shut Off. Failure to do so could result in flooding, leaking, or damage to the product.

1. Existing Toilet Seat Removal
   a . Lift hinge covers and use a flathead or Phillips head screwdriver to remove the mounting bolts. Alternatively, you may need to loosen the mounting bolts underneath the seat.
   b. Remove the toilet seat and set the seat, mounting bolts, and hardware aside.

2. Turn Off Water Supply Valve and Flush Toilet
   a . Turn the water supply valve off to stop the flow of water.
   b . Flush the toilet and hold down the handle to completely empty the tank.
   c. Disconnect the water supply hose from the toilet tank.
   Do not disconnect from the water supply valve.
   d. If you have a hand-held bidet sprayer already connected to your toilet tank, remove the existing T-valve and hand-held bidet sprayer connection hose.

3. Connect Cold Water T-Valve to the Toilet Tank Fill Valve
   a . Install the included %” cold water T-valve with the large rubber washer provided to the incoming water connection on the bottom of your toilet tank.
   b . Connect the cold water supply line coming from the wall to the bottom of the T-valve.

4. Connect Cold Water Hose to T-Valve Connect one end of the Cold Water Braided Metal Hose to the remaining open side of the installed T-valve.

Installing the Hand-Held Bidet Holster

1. Install Hand-Held Bidet Holster on Toilet
   a . Place Hand-Held Bidet Holster on the toilet so the mounting slots line up with the holes in the toilet fixture.
   b . Replace the toilet seat on top of the Hand-Held Bidet Holster and secure using the original toilet seat hardware. Make sure to tighten so that the holster and seat do not move.

2. Connect Cold Water Hose to Hand-Held Bidet Holster Attach the open end of the Cold Water Braided Metal Bidet Hose to the incoming water connection on the side of the holster.

3. Connect Hand-Held Bidet Sprayer to Holster
   a . Connect your hand-held bidet sprayer to the sprayer hose.
   b. Connect the open end of the sprayer hose to the 2″ connection at the bottom of the holster.
   c. Place the hand-held bidet sprayer in the holster slot.

4. Turn on Water Supply & Check for Leaks
   a . Open the main water supply valve slowly and check for leaks,
   b. Wait 5 – 1 0 minutes, check again, and if there are no leaks, continue.

NOTE: If there is any leaking, check all rubber washers and make sure all water connections are tight and secure. If necessary, you can use plumbers’ tape for any leaking connections.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>