Brondell SMB-25 Side-Mounted All Metal Adjustable Spray Instructions

May 21, 2024
brondell

PRODUCT OPERATION
Using the Side-Mounted Bidet

SMB-25 Side-Mounted All Metal Adjustable Spray

Extend spray wand to desired location using nozzle control handle.
To engage a wash on SMB-15, slowly turn control knob clockwise to ON position.
To engage a wash on SMB-25, very gently push water pressure control handle forward to ON position.
• The further forward the handle is pushed, the higher the water pressure will be. Take care not to initiate water at full pressure, as discomfort or injury can occur.
• Note, if hot water supply is not connected, turn pressure control handle to “COOL” (indicated by blue dash) to increase water pressure as needed.Brondell SMB-25 Side-Mounted All Metal Adjustable Spray - Turn On
Water
Readjust spray wand as necessary or use control handle to create an oscillating motion for wider cleaning range.Brondell SMB-25 Side-Mounted All
Metal Adjustable Spray - Turn off Water
Once finished, pull water pressure control handle back to OFF position and retract nozzle using nozzle control handle. (For SMB-15, turn control knob counterclockwise to OFF position).Brondell SMB-25 Side-Mounted All Metal
Adjustable Spray - Retract Water

WARNING: Risk of scalding. High water temperature can cause severe burns.


Be sure to set the water temperature for your hot water heater at or below 120 °F (49 °C) and use extreme caution when mixing hot and cold water during use.
Brondell is not liable for any misuse of product or failure to use caution when connecting to hot water.
Side-Mounted Bidet Dual Temperature (SMB-25) Only:Brondell SMB-25 Side-
Mounted All Metal Adjustable Spray - WARM
To adjust water temperature (when both hot and cold water are connected), slowly push pressure control handle forward and incrementally turn handle clockwise towards “WARM” (indicated by red dash) until the desired temperature is reached.
NOTES: There may be a delay in the warm water reaching the bidet attachment as the cold water in your pipes clears and is replaced with hot water (similar to the delay when you turn your faucet on). If only connected to cold water, make sure that the temperature dial on the bidet attachment is turned as far as it can go towards the “COOL” setting for best pressure adjustability.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

brondell User Manuals

Related Manuals