BRESSER 9820210FRE000 Kinder Wanduhr Freek Vonk Instruction Manual

: June 6, 2024
: BRESSER

Table of Contents

GENERAL WARNINGS
PARTS OVERVIEW
MOUNTING/POSITIONING
EC Declaration of Conformity
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

BRESSER 9820210FRE000 Kinder Wanduhr Freek Vonk Instruction Manual

ABOUT THIS INSTRUCTION MANUAL

These operating instructions are to be considered a component of the device. Please read the safety instructions and the operating instructions carefully before use. Keep these instructions for renewed use at a later date. When the device is sold or given to someone else, the instruction manual must be provided to the new owner/user of the product.

This product is intended only for private use.

GENERAL WARNINGS

CHOKING HAZARD!
Keep packaging material, like plastic bags and rubber bands, out of the reach of children, as these materials pose a choking hazard.
RISK of ELECTRIC SHOCK!
This device contains electronic components that operate via a power source (batteries). Children should only use the device under adult supervision. Only use the device as described in the manual; otherwise, you run the risk of an electric shock.
RISK of FIRE/EXPLOSION!
Do not expose the device to high temperatures. Use only the recommended batteries. Do not short-circuit the device or batteries, or throw them into a fire. Excessive heat or improper handling could trigger a short-circuit, a fire or an explosion!

NOTE!
Do not immerse the unit in water.
Do not subject the unit to excessive force, shock, dust, extreme temperature or high humidity, which may result in malfunction, shorter electronic life span, damaged batteries and distorted parts.
Do not disassemble the device. In the event of a defect, please contact your dealer. The dealer will contact the Service Centre and can send the device in to be repaired, if necessary.
Use only the recommended batteries. Always replace weak or empty batteries with a new, complete set of batteries at full capacity. Do not use batteries from different brands or with different capacities. Remove the batteries from the unit if it has not been used for a long time.
The manufacturer is not liable for damage related to improperly installed batteries!

SCOPE OF DELIVERY (Fig. 1)

Wall clock (A), instruction manual
Required batteries: 1 x 1.5V battery (Size AA/LR6) Batteries not included with purchase.

PARTS OVERVIEW

Wall clock (Fig. 2)

Dial plate
Clock hands (seconds)
Clock hands (hours)
Clock hands (minutes)
Wall mount
Battery compartment
Setting wheel

GETTING STARTED/POWER SUPPLY

Insert one battery (1.5V, AA/LR6) into battery compartment (6).
Turn the setting wheel (7) until the desired time is set.

MOUNTING/POSITIONING

NOTE!
Make sure you have mounted or placed the device in a safe way. Otherwise the device may fall down and heavy damages can occur for which the manufacturer is not liable. The wall clock can be mounted on walls with the wall mount (5)

CLEANING AND MAINTENANCE
Before cleaning the device, disconnect it from the power supply (remove batteries)!
Only use a dry cloth to clean the exterior of the device. To avoid damaging the electronics, do not use any cleaning fluid.
Protect the device from dust and moisture. The batteries should be removed from the unit if it has not been used for a long time.

DISPOSAL
Dispose of the packaging materials properly, according to their type, such as paper or cardboard. Contact your local waste-disposal service or environmental authority for information on the proper disposal.
Do not dispose of electronic devices in the household garbage! As per Directive 2012/19/EC of the European Parliament on waste electrical and electronic equipment and its adaptation into German law, use delectronic devices must be collected separately and recycled in an environmentally friendly manner

The integrated battery must only be removed for disposal. Opening the device housing can damage the unit.
Drain the battery completely before disposal. Remove all the screws in the housing and open the device housing. Remove the connections to the battery and remove it. Cover the open contacts with tape and package the battery in such a way that it cannot shift in the packaging.

EC Declaration of Conformity

Bresser GmbH has issued a „Declaration of Conformity“ in accordance with applicable guidelines and corresponding standards. The full text of the EU declaration of conformity is available at the following internet address:
www.bresser.de/download/9820210FRE000/CE/ 9820210FRE000_CE.pdf

Warranty and Service
The regular warranty period is 2 years and begins on the day of purchase. To benefit from an extended voluntary warranty period as stated on the gift box, registration on our website is required.
You can consult the full warranty terms as well as information on extending the warranty period and details of our services at www.bresser.de/warranty_terms.