SERVER 07405 Express Pumps Instruction Manual

: June 5, 2024
: SERVER

Table of Contents

SERVER 07405 Express Pumps
ASSEMBLY
SAFETY
DISASSEMBLY
CLEANING
TROUBLESHOOTING
PUMP COMPONENT PART NUMBERS
GENERAL SERVICE, REPAIR OR RETURNS
NEED HELP?
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

SERVER 07405 Express Pumps

MODELS:

07405
07634
07937
07988
07959

Used with pouches up to 1½ gallons.

Thank You
for purchasing our Server Express® Pump.
Express™ pouched condiment systems are sealed and sanitary, achieve excellent evacuation and have only a few parts for easy clean-up.
SIMPLIFY CONDIMENT MANAGEMENT— GO POUCHED

ASSEMBLY

WASH ALL PARTS PROPERLY BEFORE USE.

INSERT PINCH VALVE into pump housing.

TIP: Squeeze the pinch valve open before installation to ensure it isn’t stuck shut.

INSTALL DOME

Press dome into housing fully.
Ensure valve flap covers bottom opening. INSTALL TUBE

Lubricate with a small amount of clean water.
Rotate and position until both pegs on housing fit into holes on tube. INSERT CONNECTOR

Lubricate with a small amount of clean water.
Rotate and position until both pegs on connector fit into holes on tube.
Connector must point away from end of discharge tube. INSERT DISCHARGE FITTING

into pump housing discharge tube.
Place loop of fitting around peg on end of discharge tube to secure.

SAFETY

IMPORTANT
Clean, rinse, sanitize, and dry parts daily or regularly to comply with local sanitization requirements.
According to food and safety regulations, most foods must be stored and/or served at certain temperatures or they could become hazardous. Check with local food and safety regulators for specific guidelines. Server Products, Inc. cannot be responsible for the serving of potentially hazardous product.

NSF International lists this pump as:
“Not acceptable for dispensing potentially hazardous foods.”

DISASSEMBLY

CLEANING

FLUSH & RINSE all pump surfaces with hot water.
Place lower end of pump into container of hot water and operate pump until all remaining product is expelled and only hot water is discharged.
DISASSEMBLE & CLEAN all washable parts with soap and hot water. Use brush to clean any confined areas.
RINSE fully with clear water.
SANITIZE all parts according to local sanitization requirements. All parts in contact with food must be sanitized.
AIR DRY all parts fully.

Dishwasher safe
Do not use abrasive, caustic or ammonia based cleansers.
Do not use cleansing agents with high concentrations of acid, alkaline or chlorine.
Do not use metal scrapers or cleaning pads that could scratch surfaces.

TROUBLESHOOTING

DIFFICULT TO ATTACH PARTS?

Wet parts with clean water to help fit.

PRODUCT DOESN’T PUMP?

Ensure pinch valve is inserted in housing.
Ensure connector is snapped fully in place to fitment in pouch.
Ensure pump is properly installed in unit.
Clean pump thoroughly.

DOME POPS OFF?

Clean thoroughly. Food residue could prevent a tight seal between dome and housing.
Ensure dome edges are flush with housing.

PUMP COMPONENT PART NUMBERS

SERVER 07405 Express Pumps FIG 10 SERVER PRODUCTS LIMITED WARRANTY

This Server product is backed by a two-year limited warranty against defects in materials and workmanship. See Server-Products.com for details.

GENERAL SERVICE, REPAIR OR RETURNS

Before sending any item to Server Products for service, repair, or return, contact Server Products customer service to request a Return Authorization Number. Merchandise must be sent to Server Products with this number. Service is extremely prompt. Typically, units are repaired and ship out within 48 hours of receipt.
Merchandise being returned for credit must be in new and unused condition and not more than 90 days old and will be subject to a 20% restocking charge.