TiGHT AV AU-BT2-DA Dante 2×1 Bluetooth Adapter User Manual
- June 4, 2024
- TIGHT AV
Table of Contents
TiGHT AV AU-BT2-DA Dante 2×1 Bluetooth Adapter
Product Introduction
Thanks for choosing the AU-BT2-DA. It supports 2X1 channels of Bluetooth audio to be distributed through your Dante network. AU-BT2-DA is featuring Audinate’s original Dante Ultimo chip.
Features
- Plug and Play
- Dante and AES67 support
- 24-bit audio support
- 2X1 audio channel
- Support 802.3af PoE
- Bluetooth 5.0
- The maximum Bluetooth LoS transmission distance is 20m
Packing List
- 1 x AU-BT2-DA
- 1 x User Manual
Panel Description
-
RJ45: Dante network communication port.
The green steady light indicates a link; the yellow flashing light indicates data traffic. The green light will flash to identify the device when clicking the Dante Controller “Identify” button (an eye-shaped symbol) on the host computer -
Bluetooth Paring Button: 1 x blue backlit key, for Bluetooth pairing.
Bluetooth pairing process
After the device is powered on, press the pairing button to enter pairing
mode. The blue backlight of the button flashes quickly.
After the Bluetooth device is successfully paired, the blue backlight will
have a steady light.
If the Bluetooth is not connected to any device within one minute, the blue
backlight stops flashing and turns off, The paring button needs to be pressed
again to reinitiate paring process.
When a device is successfully paired, press and hold the button for more than
5 seconds to unpair the device. The backlight will turn off. and the unit will
return to the initial state.
Customer Service
We provide limited warranty for the product within five years counting from
date of purchase (The purchase invoice shall prevail).
Note: Please contact your distributor immediately if any damage or defect in
the device is found.
Technical Specification
Dante
Sample Rate| 48 kHz
Bit Depth| 24
Model Name| Bluetooth 2X1
Dante Device Latency| 1, 2 or 5ms (configurable using Dante Controller)
Network Transport
| Dante Audio over IP AES67 RTP
Model Name| AU-BT2-DA
Control
Control Part| (1) Bluetooth button
General
Power| 802.3af PoE
Operation Temperature| -5 to +55℃
Storage Temperature| -25 to +70℃
Power Consumption| 1.9W(Max)
Dimension (WHD)| 115x 34 x 28
mm
---|---
Net Weight| 70g
Compliance| FCC, CE
Environmental| RoHs, WEEE