Magene HRM60 Heart Rate Monitor User Manual

: June 5, 2024
: Magene

Table of Contents

Safety Warnings and Product Information
- Battery-related warning
- Health-related warnings
Our Product
Wearing the Heart Rate Sensor
Pairing and Settings
Battery Replacement
Documents / Resources
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)

Magene HRM60 Heart Rate Monitor User Manual

Safety Warnings and Product Information

Warning
Failure to notice the potential dangers listed below may lead to severe harm or even fatal accidents.

The product uses a CR2032 button cell battery. Failure to follow the instructions listed below may shorten the battery’s shelf life, damage the device, or cause fire, chemical burns, battery leakage, or the risk of injury.

Do not disassemble, modify, puncture, or damage the device or the battery.
Do not expose the device or the battery to fire, explosion, or other hazards.
Do not place or store the device near a dryer, in a car under direct sunlight, or in other high-temperature environments.
Do not immerse the battery in water or other liquids.
Do not use any sharp object when removing the button cell battery.
Keep the battery out of reach of children. Swallowing the battery may cause chemical burns, soft tissue perforation, or even death. Seek immediate medical help if the battery is swallowed.

If you are implanted with electronic devices in your body, such as a pacemaker, consult your physician before using the heart rate sensor.
Data on the heart rate sensor is for reference only and cannot be used for the medical diagnosis, monitoring, treatment, or prevention of any disease. Magene is not responsible for the consequences of any data error.

Our Product

The heart rate sensor monitors your heart rate during sports. It supports ANT+ and Bluetooth wireless protocols, allowing you to send heart rate data to a mobile app, bike computer, sports watch, or any other smart device that supports standard ANT+ and Bluetooth protocols. By recording each and every heartbeat, it enables scientific and pleasant training.

Wearing the Heart Rate Sensor

To avoid errors in the collected heart rate data, make sure to place the heart rate sensor in the proper direction. Wear the heart rate monitor directly on your skin, just below your chest. It should be snug enough to stay in place during your activity

Wet the electrode areas on the reverse side of the strap.
Align the buckle on the left side of the sensor with the mother buckle on the chest strap.
Wrap the chest strap around your chest and adjust the length to a comfortable position.
Align the buckle on the right side of the sensor with the female buckle on the chest strap, and the electrode is close to the skin.
After the sensor is properly worn, it will automatically turn on, the front LED flashes (turns off after 10 times), select the correct ANT ID or Bluetooth ID on the bike computer, watch, and APP, and the heart rate data will be transmitted.

Pairing and Settings

Pairing the heart rate sensor with an ANT+ device

Wear the heart rate sensor before you can pair it with a compatible device.

Keep the sensor within 3 meters of the device to be paired and over 10 meters away from other ANT+ devices.

When the initial pairing is complete, the compatible device will automatically identify the enabled sensor.

Pairing the heart rate sensor with a Bluetooth device

Wear the heart rate sensor before you can pair it with a compatible device.

Keep the sensor within 3 meters of the device to be paired and over 10 meters away from other Bluetooth devices.

The sensor cannot be found by directly using Bluetooth on a phone and can only be connected to a Bluetooth device or an app at the same time.

When the initial pairing is complete, the compatible device will automatically identify the enabled sensor.

Battery Replacement

Use a coin to rotate the arrow mark on the battery cover anticlockwise from the locking position to the opening position. You can then open the battery holder.
Remove the used battery.
Place a new battery into the battery holder. Align the arrow mark to the opening position and press down the battery cover (see figure below). After pressing the whole cover into the battery holder, use a coin to rotate the arrow mark clockwise to the locking position.
You may have to re-pair the heart rate sensor after battery replacement.