Birchwood Lighting 820-00135 Trimless Mud Flange Instruction Manual
- October 30, 2023
- Birchwood Lighting
Table of Contents
Birchwood Lighting 820-00135 Trimless Mud Flange Instruction Manual
Installation Instructions
ROUGH-IN WIDTH
PERIMETER FLUSH FIXTURES
| TR/TL
165| 2.563”
225| 3.000”
325| 4.000”
500| 5.750”
Note: To be installed by qualified electrician per N.E.C and all local Codes.
-
See continuous run matrix for rough-in opening length.
-
Ensure wall is extended 6” above ceiling.
-
Adjust wall brackets to align with wall studs or blocking support.
-
For continuous runs, remove wall brackets and mud flange. For
-
Install fixture(s) into roughedin opening and install screws thru wall brackets and mud flange. For continuous runs, do not completely tighten screws until alignment splines are positioned between panel or end cap and make wire joiner brackets are tightened.
Note: ensure fixture does not warp when tightening screws. Check by making sure lens fits ensure proper fit. -
Bring conduit to fixture thru access panel or end cap and make wire connections inside fixture. Access panel can be temporarily removed to simplify wiring
-
Install lens prior to finishing to ensure proper fit
-
Remove lens to finish mud and painting.
-
Reinstall reflector/liner and lens.
Support
BIRCHWOOD LIGHTING
3340 E La Palma Ave, Anaheim, CA 92806
tel 714 550-7118
fax 714 550-7151
www.birchwoodlighting.com
For Birchwood Lighting’s limited product warranty, go to
www.birchwoodlighting.com. For a printed copy of the warranty, you may call
800 961-5321.
© 2022 Birchwood Lighting, Inc. All rights reserved.
Note: This document is subject to change without notice.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>