Sunbeam SAP0900WH Air Purifier User Guide
- June 5, 2024
- Sunbeam
Table of Contents
SAP0900WH Air Purifier
SIMPLY FRESH
AIR PURIFIER
User Guide
SAP0900WH
Contents
Sunbeam’s Safety Precautions
1
Get To Know Your Air Purifier
2
Control Panel & Features
3
Product Specifications
4
Getting Started
4
Operating Instructions
4
Care And Maintenance
4
How To Replace The Hepa Filter
5
Troubleshooting
5
Sunbeam’s Safety Precautions
When using electrical appliances, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons. These precautions include: · Read all instructions before using the appliance. · To avoid fire or shock hazard, plug the appliance directly into appropriate electrical outlet. · If the filter is covered by a bag when shipped, remove plastic bag before use and keep away from children. · Keep the cord out of heavy traffic areas. To avoid fire hazard, never put the cord under rugs, near heat registers, radiators, stoves, or heaters. · To protect against electrical hazards, do not immerse the appliance or use near water or other liquids. · This appliance is not intended for use by children or by persons with reduced physical, sensory, or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Close supervision is necessary when any appliance is used near children. Children should be supervised to ensure that they do not play with the appliance. Keep the appliance and its cord out of reach of children. · Always turn the appliance off before unplugging it. · Always unplug the air purifier before moving or cleaning the unit, opening the filter chamber cover, changing the filters and whenever the unit is not in use. To disconnect the unit, be sure to pull the plug and not the cord. · Never drop or insert any objects into the openings
of the unit. · Do not operate any appliance with a damaged
cord or plug. If the motor fan fails to operate or the unit has been dropped
or damaged in any manner, return appliance to manufacturer for examination
and/or repair. · Use appliance only for intended household use as described in
this manual. Any other use not recommended by the manufacturer may cause fire,
electric shock, or injury to persons. · Do not use outdoors. · Never place on
a soft surface such as a bed or sofa as this could cause the unit to tip over
and block the air inlet or outlet grilles. · Keep unit away from heated
surfaces and open flames. · Do not place anything on top of unit. · Never use
detergents, gasoline, glass cleaner, furniture polish, paint thinner or other
household solvents to clean any part of the appliance. · This appliance should
only be used in a room with temperatures between 10° C and 40° C. · WARNING:
To reduce the risk of fire or electric shock, do not use this appliance with
any solidstate speed control device. · CAUTION: To prevent risk of electric
shock, remove cord plug from outlet before opening appliance. To prevent risk
of fire, inspect and clean equipment regularly as noted in this manual.
SAVE THESE INSTRUCTIONS
HOUSEHOLD USE ONLY
If you have any concerns regarding the performance and use of your appliance, please visit the Sunbeam website or contact the Sunbeam Consumer Service Line. Ensure the above safety precautions are understood.
1
Get To Know Your Air Purifier
1
2 3 4
5 6
BOTTOM VIEW
1. Top Air Vent 2. Control Panel 3. Nightlight 4. 360 Air Intake 5. True HEPA
Filter Chamber Cover 6. Chamber Cover OPEN/CLOSE Button
2
Control Panel & Features
On/Off Button A dual function button, turns unit on or off and selects Fan
Speed Settings.
I II III
Fan speed settings · For optimum air filtration, it is
recommended to operate the air purifier continuously on speed II (Medium). Its
durable motor has been designed to give many years of use. · For quieter
operation (such as in a bedroom), select speed I (Low). · When high levels of
air pollution are present, select speed III (High) to quickly circulate and
filter the air in the room.
Timer For your convenience, you can set the air filtration time for 2, 4, or 8
hours. Once it reaches set time, the unit will automatically turn off. If you
want to cancel the set time, simply press this button to cycle through until
the light goes off.
Nightlight The ( )illuminates when the nightlight feature is activated.
Filter Replacement Indicator The ( ) starts blinking when it is time to
replace the filter.
3
Product Specifications
CADR Fan Speeds
Smoke: 153 m3/hr 3
Noise Level on High Speed 55dB(A) max
Power Consumption
38W
Getting Started
1. Gently place the air purifier on its side to expose the filter chamber
cover.
2. Open the cover following the instructions in How to Replace the HEPA
Filter on page 5. Pull the filter out of the air purifier and remove the
plastic bag.
3. Insert the filter back into the unit and close the cover.
4. Your unit is equipped with a True HEPA filter that will last for
approximately 12 months.
Operating Instructions
1. Place the unit on a dry, stable and firm surface. Make sure not to block
the top air vent and air intake grille.
2. Plug unit into appropriate electrical outlet.
3. Select desired fan speed setting: III (Hi), II (Medium) and I (Low) by
pressing the ON/ OFF ( ) button to cycle through the speeds until it reaches
desired speed setting.
4. Note: For optimum air filtration, it is recommended to operate the unit
continuously on speed II (Medium). Its heavy-duty motor was designed to
provide many years of use.
5. Important: Always turn off and unplug the unit when not in use.
Care And Maintenance
Before cleaning the air purifier, turn off and unplug.
Clean the exterior surface with a clean, damp cloth.
The top air vent can be cleaned of dust with a small, soft brush.
If you would like to clean the inside of the filter compartment, ONLY use a
dry, soft cloth to wipe it down.
WARNING: Do not allow moisture to come into contact with the main housing of
the air purifier.
NEVER use detergents, gasoline, glass cleaner, furniture polish, paint
thinner, or other household solvents to clean any part of the appliance.
4
How To Replace The Hepa Filter
It is recommended to replace the True HEPA filter every 8-12 months. 1. The
Filter Replacement Indicator light ( ) starts blinking when it is time to
replace the filter.
Turn off and unplug air purifier. Replace the HEPA filter with a new one. 2.
To replace:
Gently place the air purifier on its side to expose the filter chamber cover. Push the Button toward arrow direction to unlock and open the cover.
III II I
8H 4H 2H
Pull the used HEPA filter out and insert a new one.
8H 4H 2H
III II I
3. Close and lock the cover. Place the air purifier on a flat surface. 4.
Plug the unit into an electrical outlet. Reset the Filter Replacement
Indicator by pressing and
holding the On/Off ( ) and Timer ( ) buttons simultaneously for 3 seconds
until you hear a beep and the light goes off. *Replacement filters (SAPF0900)
can be purchased through local service centres.
Troubleshooting
Problem Why is my unit not working? Why is there a decrease in air flow?
Why is the unit making a loud noise?
Solution
Check if unit is properly plugged in and outlet is working. Make sure unit is
turned ON. Make sure the filter is properly installed.
Make sure nothing is blocking air intake grille and filtered air outlet. Check
condition of the filters and replace if necessary. Check filter to remove any
plastic wrapping/ packaging.
Make sure the unit is firmly positioned in place. Open filter chamber cover
and verify that any plastic packaging was removed from the filter.
5
Suite 1, Level 1, 13 Lord Street, Botany NSW 2019 Australia
www.sunbeam.co.nz 0800 786 232 Level 6, Building 5, Central Park, 660-670
Great South Road, Greenlane, Auckland New Zeland
Need help with your appliance?
Contact our customer service team or visit our website for information and
tips on getting the most from your appliance.
Australia
| visit phone mail
www.sunbeam.com.au
1300 881 861
Suite 1, Level 1, 13 Lord Street, Botany NSW 2019 Australia
New Zealand | visit phone mail
www.sunbeam.co.nz
0800 786 232
Level 6, Building 5, Central Park, 660670 Great South Road, Greenlane,
Auckland.
Newell Australia Pty Ltd | ABN 68 075 071 233 Sunbeam is a registered trade
mark. Made in China to Sunbeam’s specification. Due to minor changes in design
or otherwise, the product you buy may differ slightly from the one shown here.
Approved by the appropriate electrical regulatory authorities. ©Copyright
Sunbeam 2021. 03/21
SAP0900WH_21EM1 (ANZ) GCDS-SUN1668174-LD
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>