Deltatrak 2239X 4G Data Logger User Manual
- June 5, 2024
- Deltatrak
Table of Contents
Deltatrak 2239X 4G Data Logger
Display Instruction
Start
Long press “Start/stop” button till “REC” has been showed on the LCD interface, device is ready to monitor. At the same time, the record quantity also will be showed on the LCD interface.
Stop
Long press “Start/Stop” button till “REC” disappear from LCD interface, the device has been stopped.
Check data
Short press “Data” button, to show some information:
MAX temperature value
MIN temperature value
Mode Switch
- Long press “Mode” button, to enter flight mode: In flight mode, the logger only records data and doesn’t send data to platform. LCD will be shut down, display nothing.
- Long press “Mode” button again, to quit flight mode: Data report, LCD show, everything back to normal
Usage scenarios
Put the device in the container with goods together. This device complies with
Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may
cause undesired operation. Changes or modifications to this unit not expressly
approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device and its antenna(s) must not be co-located or operated in
conjunction with any other antenna or transmitter.
To maintain compliance with FCC’s RF exposure guidelines, This equipment
should be installed and operated with minimum distance of 20cm from your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>