FTX 2.0X TEXAN FURY ELECTRIC POWERED OFF-ROAD TRAIL VEHICLE User Manual

FTX 2.0X TEXAN FURY ELECTRIC POWERED OFF-ROAD TRAIL VEHICLE

Congratulations on your purchase of the FTX Outback Mini 2.0X Texan or Fury electric trail vehicle.

This 1/18th scale model has been factory assembled and all electrics installed and set up to make it the easiest possible introduction to the sport of driving RC cars.
WARNING: Read the ENTIRE instruction manual to become familiar with the features of the product before operating. Failure to operate the product correctly can result in damage to the product, personal property and cause serious injury. This is NOT a toy and must be operated with caution and common sense. Failure to operate this product in a safe and responsible manner could result in damage, injury or damage to other property. This product is not intended for use by children without direct adult supervision. It is essential to read and follow all the instructions and warnings in the manual, prior to assembly, set-up or use, in order to operate correctly and avoid damage or serious injury.

Safety Precautions and Warnings

• You are responsible for operating this model such that it does not endanger yourself and others, or result in damage to the product or the property of others.

• This model is controlled by a radio which is possibly subject to interference which can cause momentary loss of control so it is advisable to
  always keep a safe distance to avoid collisions or injury.

• Age Recommendation: 14 years or over. This is not a toy. This product is not intended for use by children without direct adult supervision.

Carefully follow these directions and warnings, plus those of any additional equipment associated with the use of this model, chargers, ESC and motors, radio etc.

• Never operate your model with low transmitter batteries.
• Always operate your model in an open area away from cars, traffic or people.
• Never operate the model in the street or in populated areas.
• Always keep the vehicle in direct line of sight, you cannot control what you cannot see!
• Keep all chemicals, small parts and anything electrical out of the reach of children.
• Although splash-proof the car and electronics are not designed to be subjected to extended moisture exposure or submersion. To do so will result in permanent damage.
• Avoid injury from high speed rotating parts, gears and axles etc.
• Exercise caution when using tools and sharp instruments.
• Do not put fingers or any objects inside rotating and moving parts.
• Take care when carrying out repairs or maintenance as some parts may be sharp.
• Do NOT touch equipment such as the motor, electronic speed control and battery, immediately after using your model because they can generate high temperatures.
• Always turn on your transmitter before you turn on the receiver in the car. Always turn off the receiver before turning your transmitter off.
• Keep the wheels of the model off the ground, and keep your hands away from the wheels when checking the operation of the radio equipment.
• Prolong motor life by preventing overheat conditions. Undue motor wear can result from frequent turns, rapid change of direction
  forwards/backward, continuous stop/starts, pushing/pulling objects, driving in deep sand and tall grass, or driving continuously uphill.

FAMILIARIZING YOURSELF WITH YOUR 2.4GHZ RADIO SYSTEM

You car is equipped with a 2.4Ghz radio system that once bound with the ESC will provide you with interference-free use. Please read and understand the instructions snd functions before operating.

• Steering Wheel: Proportionally operates the model left to right
• Battery Case: Requires 4 x AAA Batteries
• Power Switch: Used to turn the radio ON/OFF
• Steering Dual Rate: This allows you to change the amount of steering servo travel compared to the amount of physical steering wheel movement
• Throttle Dual Rate: This allows you to change the amount of throttle movement compared to the amount of physical throttle trigger movement
• Throttle/Steering Trims: Used to adjust the center trim of the throttle/steering for straight wheels and neutral throttle
• Steering Reverse: This allows you to electronically switch the direction of the steering servo travel. For example, if you move the steering wheel to the right and the steering servo moves to the left, use the reverse button to switch the steering to the right.
• Throttle Reverse: This allows you to electronically switch the direction that the motor operates in relation to the throttle trigger. For example, if you pull the trigger to accelerate forward, but the model goes in reverse, use the reverse button to switch to make the model accelerate forward
• Throttle Trigger: Controls the speed and braking ability of your model. Pull back to accelerate, release to decelerate and push forward for the brake
• LED Indicators: Show battery power level. Replace batteries when the power indicator blinks or the buzzer beeps

**BATTERY INSTALLATION

**

1. Slide the battery cover off as shown and install 4 x AAA size batteries, positioning the polarity as indicated on the battery box.
2. Replace cover after batteries are installed.

Notes:

• Use batteries of the same type
• Remove batteries when not in use
• Always check battery power before use
• Dispose of exhausted batteries properly
• Only charge rechargable batteries when using charge jack

RUNNING YOUR CAR

1. TURN ON THE RADIO CONTROLLER

2. TURN ON THE RECEIVER ON YOUR CAR

3. CHECK THE STEERING PERFORMANCE
   Ensure good steering movement.

4. CHECK THROTTLE TRIGGER RESPONSE

5. TO TUNE THE STEERING TRIM

6. TO TUNE THE THROTTLE TRIM

7. TO TUNE THE STEERING DUAL RATE CONTROL DIAL

8. STEERING/THROTTLE REVERSE

Steering Reverse:
Allows you to switch the direction of the steering. Turn wheel left or right and hold in position. Press REV for 2 seconds and the steering direction will be reversed.
Throttle Reverse:
Allows you to switch the direction of the throttle. Pull back or push forward the throttle trigger. Press REV for 2 seconds and the throttle direction will be reversed.

BINDING THE TRANSMITTER AND RECEIVER

Your FTX transmitter will come ready bound to the vehicle directly from the factory. However should you need to rebind the radio to the vehicle please follow these simple instructions:

• PLUG IN THE BATTERY TO ESC AND TURN ON POWER
• TURN ON THE TRANSMITTER
• USE A PIN TO PUSH THE BIND BUTTON

Please Note: You must re-bind when binding to a different transmitter. Also do not attempt to bind if there are other compatible transmitters within 400ft when attempting to bind to your transmitter as you may accidentally bind to these.

Charging/Installing the Battery.

Always store your model with the battery pack unplugged and removed. Always charge your battery away from the vehicle. The included 150mAh USB charger will take approx 4 hours to charge a fully discharged battery, but always remove it from the charger if it becomes warm to the touch. Always disconnect the charger from the mains supply and the battery pack when not in use. Keep children away from charger and battery during the charging process.

Notes on Battery use:

Always allow the battery cool after use, before recharging. Always inspect the battery before charging. Any bare wires, split heat shrink or leakage is a sure sign of abuse. Never attempt to charge dead or damaged batteries. Do not disassemble the battery or cut the connector wires.If the battery connector gets hot enough to melt there is most likely a serious problem with your model, driveline, battery wires or speed controller. Find and correct the problem before installing another charged battery pack. NEVER charge the battery unattended incase of overcharging, you need to be able to monitor the battery during charging Charge away from flammable objects and on a non- flammable surface incase the battery becomes too hot.

MAINTAINING YOUR CAR

After running your car, the following procedures should be performed regularly and will help to maintain your car’s performance.

• Inspect your car for any obvious damage.
• Check the gears for wear, debris or broken/slipping teeth.
• Check the wheels and tighten the wheel screws properly.
• Check for loose screws in the chassis.
• Check the wiring for frayed or damaged wires or connectors.
• Check the steering servo which will wear out over time and require replacement.
• Check all batteries.
• Keep the chassis clean and free of sand, dust and moisture.
• Remove and clean the motor if necessary. (Never attempt to re-assemble the motor, you will damage it and void the warranty).
• Clean the car body with a soft lint-free cloth.
• Remove all batteries when not in use.

TROUBLESHOOTING

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>