SENA SC2 Mesh Intercom System User Manual
- June 5, 2024
- Sena
Table of Contents
SENA SC2 Mesh Intercom System
SC2
Charging
SC2
- Red LED: Charging
- Blue LED: Fully charged
Power On/Off
Sc2
Press and hold the Multifunction Button for 1 second
Volume Adjustment
- (+) Button- Increase the volume
- (-)Button- Decrease the volume
Battery Check
Phone, Music Pairing
- Press the Center Button for 10 seconds
- Press the () Button to enter into Phone Pairing9
- Search for Bluetooth devices on your mobile phone. Select the SC2 in the list of the devices detected on the mobile phone
- Enter 0000 for the PIN. Some mobile phones may not ask for the PIN
Music Operation
- Play or pause music: Press the Center Button for 1 second.
- Trackback: Press the (-) Button for 1 second.
- Track forward: Press the (+) Button for 1 second.
Music Operation
- Play or pause music: Press the Center Button for 1 second.
- Trackback: Press the (-) Button for 1 second.
- Track forward: Press the (+) Button for 1 second.
Mobile Phone Call Making and Answering
- Answering a call: Tap the Center Button
- Ending a call: Press the Center Button for 2 seconds.
- Voice dial Press the Center Button for 3 seconds.
- Speed dial: Press the (+) Button for 3 seconds.
- Rejecting a call: Press the (+) Button for 2 seconds.
Mesh Intercom
Mesh Intercom On/Off : Tap the Mesh Button
- Radio On/Off
- Turn on the FM radio: Press the (-) Button for 1 second.
- Turn off the FM radio: Press the (-) Button for 1 second.
- Radio Scan Up FM Band
- Start scanning: Press (+) Button for 1 second.
- Stop scanning: Press (+) Button for 1 second.
- Radio Seek Stations
- Seek up stations: Double tap the (+) Button.
- Seek down stations: Double tap the (-) Button.
- Setting
Configuration Menu: Press the Center Button for 10 seconds.
FCC Compliance Statement
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment on and off, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antennae
- Increase the separation between the equipment and the receiver
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC RF Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. End users must follow the specific operating
instructions for satisfying RF exposure compliance. The antenna used for this
transmitter must not transmit simultaneously with any other antenna or
transmitter, except in accordance with FCC multi-transmitter product
procedures. When equipped, the distance between the antenna and one’s head
surface is 40.9mm.
FCC Caution
Any changes or modifications to the equipment not expressly approved by the
party responsible for compliance could void user’s authority to operate the
equipment.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>