Poewit WAP-1 Ceiling mounted recessed trail Type A User Manual

Poewit WAP-1 Ceiling mounted recessed trail Type A

Ceiling-mounted for Recessed T-rail (Width:24mm, 15/16″)

Step 1. Assemble T-Bar bracket and M3 8 screws to the AP.
Step 2. To rotate the AP and insert the T-bar bracket into recessed T-rail per arrow direction shown in the diagram

Mounting on concrete wall or concrete ceiling with security bracket Type

A

Mounting on concrete wall or concrete ceiling with security bracket
Step 1. Drill two holes with 32mm pitch on concrete wal
Step 2. Insert plastic anchors, wall bracket and 13″20 self tapping screws to the wall
Step 3. Assemble the housing bracket and M38 screws to the AP

Mounting on concrete wall or concrete ceiling with security bracket

Step 4. Insert the housing bracket at the bottom into the wall bracket on the wall and rotate the AP per arrow direction shown in the diagram.

Instruction to release security bracket Instruction to release security

bracket

Step 1. Push down release clip from both side of security bracket
Step 2. Rotate AP counterclockwise to release from security bracket

Troubleshooting

The following table shows the status of the AP’s LED indicators.

If the AP fails to connect to the cloud server, please check the following:

1. Ensure that the Ethernet cable is plugged into the LAN 1(PoE) port, and LANI LED is NOT OFF.
2.  If the AP fails to get a valid IP address from the local DHCP server, ensure that the DHCP service is ENABLED on your router
3.  Ensure there is Internet connectivity on the local LAN network to which the AP is connected

Getting AP online

Step 1: Power up

If using PoE, plug one end of the Ethernet cable into the PoE switch or injector and plug the other end into the LAN 1(PoE) port. If using power adapter (optional), insert the power adapter plug into the AC power outlet and the other end into the DC IN port of AP

Step 2: Connect to the network

If using PoE, make sure the PoE switch or injector is connected to your LAN network with  Internet access. If using power adapter, plug one end of an Ethernet cable into LAN 1(PoE) port and the other end to an Ethernet port of your Switch or Router on the network.

Step 3: Check the LED status

Wait for a few minutes until the Power LED turns solid Blue and LANI LED Blue or Amber. The AP is then online for operation.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>