PoEWit WAP-1 Wi-Fi 6 Wireless Access Point with 8×8 User Guide
- June 4, 2024
- Poewit
Table of Contents
PoEWit WAP-1 Wi-Fi 6 Wireless Access Point with 8×8
Wi-Fi 6 Wireless Access Point with 8×8
WARNING
BEFORE PROCEEDING, EXAMINE AP MOUNTING TO ENSURE THERE IS AN AIR GAP BETWEEN THE BACK OF THE AP HOUSING AND THE MOUNTING SURFACE. AIR FLOW IS IMPORTANT TO MAINTAINING A LOW TEMPERATURE.
-
After mounting the WAP-1, connect an Ethernet cable (Cat5/6) from the LAN1 port to the Router.
• Note: To achieve full power and wireless transmission, ensure the PoE source is 802.3bt. Features will be limited when using 802.3at.
• Note: A blue LAN1 LED indicates a link of 2.5Gbps. An amber
LED indicates a link of 100/1000Mbps. -
To configure the device, download the PoEWit App from Google Play or the Apple App Store.
|
---|---
• Note: The WAP-1 and the mobile device running the PoEWit
App must be on the same external IP address and the same local subnet.
- Once powered On, the WAP-1 will automatically connect to the internet, and the Power LED will appear blue when the device is ready for operation.
- There are two installation scenarios depending on whether or not there is a wireless network already installed.
4a) With an Existing AP on the Network:
- Connect to the existing AP using your mobile device.
- Open the PoEWit App to discover and configure the new WAP-1.
First Scnario
4b) With No Existing AP on the Network:
- Connect to the newly-installed WAP-1 using the default SSID and Passcode.
Default SSID and Passcode: SSID| Passcode
---|---
poewit_2.4G_1| 3301Andrews
poewit_5.0G_1| 3301Andrews
poewitguest_2.4G| WelcomeGuest
poewitguest_5.0G| WelcomeGuest - Open the PoEWit App to discover and configure the new WAP-1.
- Once the settings are saved, the WAP-1 will reboot and lose connection to the mobile device. Allow 30 to 60 seconds for the WAP-1 to reestablish power.
- Once power is restored, connect to the new SSID you setup.
Second Scenario
