HUSKY LED Tripod Work Light Instruction Manual

HUSKY LED Tripod Work Light

FEATURES

Input Voltage Rating: AC 120V, 60Hz

• Output Rating: 40W

Hidden & Foldable TripodBuilt-in 2 Power Outlet (Total 8A Max Output)
Note: Reset fuse in driver in case of overload 8A, thus only this work light lighten up, disconnect the extra light or electrical equipment, they will be work when the fuse cool down, normally it takes 10 seconds.

• Built-in 2 USB and Type-C (Total 5V 2.1 A Output)
• Included Cell Phone Holder
• Included Fastener / Small Tools Holder
• 6FT 16/3 SJTW Professional Power Cord Enable to Group Up to 10 Units When Connected tandemly
• With Carrying Handle on the Top
• Blow Mold Case, Easy to Carry and Store
• 2 LED Panels, up to 300 Degree Beam Angle

Steps for Switching:

1. One Side Lights On ( 2000 Lumens )
2. Another Side Lights On (2000 Lumens )
3. Both Sides Lights On (Total 4000 Lumens)
4. Off

WARNING: WEAR SAFETY GOGGLES USER AND BYSTANDER.
LEDs are extremely bright and direct exposure to eyes may cause injury. Avoid shining LEDs into eyes.
California Proposition 65 Warning: This product contains chemicals, including lead, known to the state of California to cause birth defects or other reproductive harm. Wash hands after handling.

IMPORTANT SAFETY INSTRUCTIONS

Read and understand all Safety and Operating instructions in this manual before using this product.
Warning: When using outdoor use portable luminaires, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and personal injury, including the following:

1. Ground Fault Circuit Interrupter (GFCI) protection is to be provided on the circuit(s) or outlet(s) to be used for the wet location portable luminaire. Receptacles are available having built-in GFCI protection and are able to be used for this measure of safety.

2. Use only with an extension cord for outdoor use, such as an extension cord of cord type SEW, SEOW, SEOOW, SOW SOOW, STW STOW, STOOW, SJEW, SJEOW, SJEOOW, SJW SJOW, SJOOW SJTW, SJTOW, or SJTOOW.
   SAVE THESE INSTRUCTIONS.

3. Never use around heavy volatile fluids such as gasoline.

4. Do not use with an extension cord near water; or in areas where water may accumulate. Keep the worklight at least 16 ft. from pools or spas. Keep plugs dry. Only use this worklight with GFCI-protected outlets when in wet locations.

5. Use only three-wire outdoor extension cords that have three- plugs and grounding receptacles that accept the appliance’s plug.

6. This product has a polarized plug (one blade is wider than the other) as a feature to reduce the risk of electric shock. This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Never use with an extension cord unless plug can be fully inserted. Do not alter the plug.

FCC Statment

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference. (2) this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>