Shenzhen Founder Industrial RGB-25M LED Strip Light User Manual
- June 5, 2024
- Shenzhen Founder Industrial
Table of Contents
Shenzhen Founder Industrial RGB-25M LED Strip Light User Manual
INSTALLATION
- Make sure the back surface of the tv is clean.
- The strips can be bend, do not fold the light strip.
- Stick the strip on the back of TV
ON/OFF
17 Single color cycle
Brightness adjust/Speed adjust
Choose a single color, press °color will fade.
Choose a single color, press ( )color will flash.
10 Kind of single color
3/7 color fade
3/7 color flash
Pair/ Unpair the lights
On dynamic mode, press the light will stagnant at current color press the
light will continue at current mode.
SPECIFICATIONS
LED STRIPS
Input DC 5V (USB port) / 1
Power 4.5 W
LED Chip 3528 RGB
Color 17 static colors,
Beam Angle 120°
LED Strip 18 chips/meter
Back Adhesive Red 0.4 mm thickness sponge adhesive
REMOTE CONTROL
Control Mode Remote RF control
Control Distance: Max. 20 Meters Max. 20 Meters
Battery Type CR2025
OTHERS LED
Working Temperature -20°C — 45°C
Working Humidity 0% — 80% RH
Life Span 40,000 hours
Troubleshooting
| Symptom Possible | Causes | Solution |
|---|---|---|
| Lights turn on or flicker after TV turned off. | TV USB port still be powered | |
| when TV is off | Turn off the TV |
or shut down the power of TV
TV lights turn off or flash after a few minutes.| TV USB port can not supply
enough power| Lower brightness to avoid this issue
If the issue still exsit even its brightness was lowered, please test the TV
light with a wall adapter and report it to us for assistance.
TV lights change its color on its own.| Please pair the TV light with remote
to avoid RF signal interference if the TV light automatically changed its
color by
itself, (It usually happens when you have more than one TV lights)
- Unplug all TV lights you have.
- Plug in the TV light you’re pairing, immediately press and hold “ENCODE” button for 3 seconds once TV light plugged in.
- The TV light will flash once or twice, then pairing successful. How to unpair?
Repeat the above steps but hold down the “ENetratrE” button.
Remote does not work| Replace the remote battery.
Contact us for a remote replacement.
TV light falls down| Dust pollution| Keep TV back surface dust-free, and
replace the adhesive tape
FCC Statements
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Warning: changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment
The devices has been evaluated to meet general RF exposure requirement the device can be used in portable exposure condition without restriction
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>