cudy LT400 4G LTE Router Installation Guide
- June 5, 2024
- cudy
Table of Contents
cudy LT400 4G LTE aoauter Installation
Package Content
- 1 x 4G LTE Router
- 1 x Power Adapter
- 1 x Quick Installation Guide 1 x Ethernet Cable
- 2 x SIM Adapters
Quick Installation
Insert the Standard SIM card into the slot until you hear a click.
Connect power adapter and turn on the router. Waiting for 2 minutes for it to start. Check the following LEDs’ status.
If Internet LED is on , means connected to the internet successfully. If internet LED is off, please follow the instructions of Customize The 4G Router.
Customize The 4G Router
Connect the router via ethernet cable or Wi-Fi. Network name and password is printed on the bottom of the router. Launch a web browser and enter http://cudy.net/ (or http://192.168.10.1/) in the address bar, use admin as password to login.
Below page would pop up if your SIM card needs PIN to unlock. Please enter your PIN and click Save & Apply, then wait 15 seconds to connect to the Internet.
Then please check 4G information card of the status page. If the status is connected, means connected to the internet successfully
If 4G is not connected, or if you want to customize the router yourself, click Quick Setup and follow the step-by-step instructions to configure the router.
Note
If you are not sure about APN parameters, please contact your internet
provider. If you meet any other problems, don’t hesitate to contact our
technical support team support@cudy.com
LED and Button
Need Help?
Q1. What should I do if I cannot access the web management page?
A1
If the computer is set to a static IP address, change its settings to obtain
an IP address automatically.
A2
Make sure http://cudy.net/ or
http://192.168.10.1/
is correctly entered in the web browser.
A3
Use another web browser and try again.
A4
Reboot your router and try again.
A5
Disable and enable the active network adapter in use.
Q2. How do I restore the router to its factory default settings?
A1
With the router powered on, press and hold the RST/WPS button for 5 seconds
before release. Wait the router resets.
A2
Log in to the web management page of the router, and go to Advanced Settings
Reset , click Perform Reset and wait until the reset process is complete.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>