cubetape C190POS Dimensioning Products User Guide

cubetape C190POS Dimensioning Products

Quick Start Guide for C190SHP, C190POS, C190DSK – Page 1

Contents of C190SHP:

Cubetape C190 POS

C190DSK Cradle

Quickstart Guide

C190CRC USB Cable

Installation:

• USB Cable
• Cradle

DIP switches beneath cradle:

| OFF| ON| DEFAULT
---|---|---|---
RESERVED| —| —| OFF
COMMS MODE| USB-VPC| USB-HID| ON
RESERVED| —| —| OFF
RESERVED| —| —| OFF

Powering On/Off and Bluetooth Pairing:

• Power on Cubetape by pressing and holding m button for 3 seconds Power off Cubetape by pressing and holding m button for 6 seconds
• To pair with cradle, scan the pairing barcode on the front of the cradle
• Connection is successful when the Blue LED indicators on Cubetape and the cradle are permanently ON. If the Blue LED indicators continue to flash, re-scan the Bluetooth pairing barcode on the cradle.
• Cubetape will remain ON while it has an active Bluetooth connection, otherwise it will power OFF after around 3 minutes

Pairing barcode

Operations and Measuring:

Extend the tape, press the ‘m’ button to scan the barcode measurement on the tape

• Blue LED indicators are on permanently when connected
• To scan a barcode ID, press ‘m’

Correct

Incorrect

Quick Start Guide for C190SHP, C190POS, C190DSK – Page 2

Charging:

• Place device in the cradle
• Low battery warning will signal with amber LED flash and amber LED on cubetape will be solid when charging
• Device LED

• RED ON – CUBETAPE charging

• RED OFF – CUBETAPE charged

• Battery

• Tape Cassette

• Battery Compartment
• Tape Compartment

C190POS General Settings

Bluetooth Cradle Mode (Default)

Bluetooth SPP Mode

Bluetooth HID Mode

Bluetooth Reset
Suffix TAB (Default)

Suffix CR

Off floor or Inside Measure ON

FCC STATEMENT :

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.

Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

FCC Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.  This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
This device complies with Industry Canada license – exempt RSS standard( s).
Operation is subject to the following two conditions:

1. This device m ay not cause interference, and
2. This device must accept any interference, including interference t hat m ay cause undesired operation of the device.”

References

• Ship Smart with Cubetape's Dimensional Weight Scanner

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>