BUSCH-JAEGER M2240 Video Indoor Station Instructions
- June 5, 2024
- BUSCH-JAEGER
Table of Contents
ABB/BUSCH-JAEGER
Instructions
M2240 Video Indoor Station
The end-user license agreement is available by scanning the QR code.
| DANGER
Dangerous currents flow through the body when coming into direct or indirect
contact with live components. This can result in electric shock, burns, or
even death. Work improperly carried out on current-carrying parts can cause
fires.
— Disconnect the mains voltage prior to mounting and dismantling!
— Permit work on the 100-240 V mains network to be carried out only by
specialist staff.
---|---
| Note
Creating and saving image captures and user data can violate privacy rights!
When installing and operating devices, always observe the applicable legal
regulations.
FCC statement
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Only operate the
device in accordance with the instructions supplied. Changes or modifications
to this unit not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Additional statement for Intentional Radiators:
This device complies with FCC radiation exposure limits set forth for an
uncontrolled environment. In order to avoid the possibility of exceeding the
FCC radio frequency exposure limits, human proximity to the antenna shall not
be less than 20cm (8 inches) during normal operation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>