LANAFORM LA120119 Vapolux Cool Mist Air Humidifier Instruction Manual
- June 5, 2024
- LANAFORM
Table of Contents
LANAFORM LA120119 Vapolux Cool Mist Air Humidifie
Product components
Device display
Instructions
Instruction manual
The photographs and other images of the product in this manual and on the packaging are as accurate as possible, but do not claim to be a perfect reproduction of the product. Thank you for purchasing the New Vapolux cool mist humidifier by LANAFORM. The New Vapolux humidifier helps you to restore an appropriate humidity level and eliminate the discomfort associated with dry air. The ventilation system diffuses water in the form of cool vapour and thus provides the level of humidity required. This vapour takes the form of a mist coming out of a diffusion nozzle.
PLEASE READ ALL THE INSTRUCTIONS BEFORE USING YOUR HUMIDIFIER, ESPECIALLY THIS BASIC SAFETY INFORMATION
- Only use this device according to the instructions given in this manual.
- This equipment is not intended for use by people, including children, with limited physical, sensory or mental abilities, or by people lacking experience or knowledge, unless they are supervised or have been instructed beforehand on how to use the equipment by someone responsible for their safety. Children should be supervised to make sure they do not play with the device.
- Check that your mains voltage is the same as that of your device.
- Always place the New Vapolux humidifier on a hard, flat, horizontal surface. Always keep it away from walls and heat sources such as stoves, radiators, etc.
- If it is not placed on a horizontal surface, the device may not work properly.
- Do not connect or disconnect the plug of the device with wet hands.
- If the power cable is damaged, it must be replaced by a similar cable available from the supplier or the latter’s after-sales department.
- Do not leave the device exposed to direct sunlight.
- Fill the reservoir only with clean and fresh, distilled or demineralised water.
- Do not take apart either the device as a whole or even its base unit. Do not switch on the device when there is no water in the reservoir.
- Do not shake the device. This might make the water spill over into the base unit and prevent it from working.
- Never touch the water and components when the unit is running.
- If there is an unusual smell when it is being used as described in these instructions for use, switch the device off, unplug it and have it examined by the supplier or the latter’s after-sales department.
- Do not use essential oils with this device.
- Do not pour hot water above 40°C into the reservoir.
- Unplug the device before cleaning it or removing the reservoir.
- Do not wash the entire unit with water and do not immerse it in water. Consult the cleaning instructions in these instructions for use.
- Never scrape the transducer with a hard tool. The New Vapolux humidifier must be cleaned regularly. To do this, consult the cleaning instructions in this handbook and follow them.
- Unplug a device that has fallen into water immediately before retrieving it.
- An electrical device must never remain plugged in without supervision. Disconnect it when you are not using it.
- Keep the power cable away from hot surfaces.
- Never use this device in a room where aerosol products (sprays) are used or in a room or where oxygen is being administered.
- Do not put items of clothing or towels on top of the device. If the nozzle is obstructed, this may cause the device to malfunction.
- When moving the device, lift it up by the base and not by the water reservoir.
- Do not use the humidifier if the air in the room is already sufficiently humid (relative humidity of at least 50%). The ideal relative humidity level for human comfort is in fact between 45% and 55%.
- Excess humidity manifests itself in the condensation on the cold surfaces or the cold walls of the room. To measure the room’s humidity correctly, use a hygrometer available in most specialist shops and hypermarkets The New Vapolux humidifier is designed for indoor and domestic use only.
PRODUCT COMPONENTS
- Diffuser sprinkler tip
- Water reservoir
- Base of the device
- Control panel and display screen
- Demineralisation cartridge (filter)
- Water reservoir lid
DEVICE DISPLAY
- “ON/OFF” button
- Button for producing negative ions
- Button for adjusting level of emission intensity
- Button for adjusting relative humidity level
- Button for adjusting timer
- Negative ion production display
- Button for adjusting relative humidity level
- Timer display
- Level of emission intensity display
INSTRUCTIONS FOR USE
Features
- Cool mist humidifier
- LCD screen
- Automatic detection and display of ambient relative humidity
- Capacity for programming desired humidity level
- Timer: 12 hours with programming in 1-hour stages
- 3 levels of vapour emission intensity:l ow, medium, high
- Negative ion production
- Remote control
- Capacity of water reservoir 4.5L
- Maximum flow rate of cool mist: 400ml/hour
- + 11 hours of continuous diffusion at 400ml/hour
- Automatic shutoff device when the water reservoir is empty
- Automatic shutoff device when the water reservoir is lifted up
- Quiet operation (≤35dB)
- Air humidifier
- Eliminates electrostatic charges
- Improves ambient air quality
Fitting the demineralisation filter
Attach the demineralisation filter to the inner wall of the reservoir lid by turning it clockwise as shown in Figure 3, item (h). Conversely, to remove the demineralisation filter, turn it anticlockwise.
Instructions
- Place the New Vapolux humidifier in the room half an hour before turning it on so that it can adjust to room temperature.
- Make sure it is always placed on a hard, flat and horizontal surface, items Always keep it away from walls and heat sources such as stoves, radiators, etc.
- Make sure the device is clean before starting to use it.
- Remove the reservoir using its handle, item and keep it upside down, item Turn the reservoir lid in an anti-clockwise direction to open it, items Then pour clean and fresh, distilled or demineralised water into the reservoir. Replace the lid and turn clockwise to close it tightly, items finally, fit the reservoir correctly onto the base of the device, items
- Make sure your hands are completely dry when connecting and disconnecting the device and if they are not, then dry them.
- The humidifier is now working. The control panel of the device Figure is identical to the remote control
- Press the “ON/OFF” button to switch on the device Once the device is activated, you will be able to programme the various functions of the device as required.
To do this, press buttons:
- “Ion” to produce negative ions in order to neutralise the electrostatic charges
- “Max/Min” for adjusting the level of vapour emission intensity
- “Humidity” for adjusting the level of relative humidity in the room in which the device is placed If you do not press this button the device will be in manual mode, i.e. it will continue to emit the mist until you stop it or while there is water in the reservoir. Conversely, if you press this button, the device will go into AUTO mode and will only stop when it has reached the programmed level of relative humidity. To exit from this AUTO mode, you must go through the maximum programmable level of 90%.
- “Timer” for adjusting the length of vapour emission To exit this mode, you will need to go through the maximum programmable period of 12 hours.
Important notes
- Only use clean, fresh, distilled or demineralised water to avoid any malfunction.
- Do not pour water into the diffuser sprinkler tip to prevent malfunction and fire risk
- Make sure the reservoir lid is tightly closed after filling so as to avoid leakage or potential electric shocks.
- The reservoir must be kept clean. If the sprinkler tip emitting cold mist is dirty, clean it with a brush or damp cloth.
MAINTENANCE AND STORAGE
If the water contains too much calcium and too much magnesium, it may deposit a “white powder” in the device. If this foam is deposited on the transducer (white ceramic ring emitting ultrasounds , this will prevent the New Vapolux humidifier from working properly.
Care
We recommend:
- Using clean, fresh, distilled or demineralised water each time it is used.
- Cleaning the reservoir every 2 days and cleaning the transducer every week.
- Cleaning the device (see explanations below) and making sure that all its parts are completely dry when it is not in use.
To clean the transducer (white ceramic ring
- Put 2 to 5 drops of vinegar on its surface and leave them there for 2 to 5 minutes
- Brush the foam off the surface with a soft brush. Do not use a hard tool to scrape the surface.
- Rinse the reservoir of the base in clean water.
- Do not use soap, solvent or spray cleaner to clean the transducer.
To clean the water basin
- Clean the basin with water using a soft cloth and vinegar if there is foam or limescale deposits on the inside.
- Rinse the basin in clean water.
To clean the cool mist emission nozzle of the device
- Clean this with a brush or damp cloth.
- Rinse the nozzle in clean water.
Storage
Having cleaned and dried the device, store it in a dry, cool place out of the reach of children
TROUBLESHOOTING
In the event of a malfunction, under normal conditions of use, please refer to the following chart:
ADVICE REGARDING THE DISPOSAL OF WASTE
All the packaging is composed of materials that pose no hazard for the environment and which can be disposed of at your local sorting centre to be used as secondary raw materials. The cardboard may be disposed of in a paper recycling bin. The packaging film must be taken to your local sorting and recycling centre. When you have finished using the device, please dispose of it in an environmentally friendly way and in accordance with the law.
LIMITED WARRANTY
LANAFORM guarantees this product against any material or manufacturing defect for a period of two years from the date of purchase, except in the circumstances described below. The LANAFORM guarantee does not cover damage caused as a result of normal wear to this product. In addition, the guarantee covering this LANAFORM the product does not cover damage caused by abusive or inappropriate or incorrect use, accidents, the use of unauthorized accessories, changes made to the product or any other circumstance, of whatever sort, that is outside LANAFORM’s control. LANDFORM may not be held liable for any type of circumstantial, indirect or specific damage. All implicit guarantees relating to the suitability of the product is limited to a period of two years from the initial date of purchase as long as a copy of the proof of purchase can be supplied. On receipt, LANAFORM will repair or replace your appliance at its discretion and will return it to you. The guarantee is only valid through LANAFORM’s Service Centre. Any attempt to maintain this product by a person other than LANAFORM’s Service Centre will render this guarantee void
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>