Sunbeam KE7110 Belle-Aqua Kettle User Guide

: June 3, 2024
: Sunbeam

Table of Contents

Sunbeam’s Safety Precautions
Features of your Sunbeam Belle-Aqua™ Kettle
Using your Sunbeam Belle-Aqua™ Kettle
Sunbeam’s 3-Way Safety System
Care and Cleaning
Documents / Resources

BELLE-AQUA KETTLE
User Guide
KE7110

Sunbeam’s Safety Precautions

Important instructions – retain for future use.
SAFETY PRECAUTIONS FOR YOUR SUNBEAM KETTLE.

Always operate the kettle on a flat, level surface.
Boiling water will scald. Do not leave a boiling or hot kettle near or where children may touch it.
Do not leave the power cord near the edge of a bench top where children may touch or pull it.
Boiling water may be ejected if overfilled.
Always ensure the lid is securely closed to ensure the correct operation of the kettle.
Do not operate the kettle without water.
Always turn the power off and unplug the cord while the kettle is NOT in use.
Your kettle must only be used with the power base supplied.
Do not move the kettle while switched on.
Never fill above the ‘max’ indication as hot water may be ejected.
Always store excess cords in the storage facility underneath the power base.
Always be aware of steam being emitted from the spout or lid, especially during refilling.
Do not use the kettle to heat anything other than water.
Avoid spillage on the connector.
Do not use an appliance for any purpose other than its intended use.
The heating element surface is subject to residual heat after use.

Sunbeam is very safety conscious when designing and manufacturing consumer products, but it is essential that the product user also exercise care when using an electrical appliance. Listed below are precautions that are essential for the safe use of an electrical appliance:

Read carefully and save all the instructions provided with an appliance.
Always turn the power off at the power outlet before you insert or remove a plug. Remove by grasping the plug – do not pull on the cord.
Turn the power off and remove the plug when the appliance is not in use and before cleaning.
Do not use your appliance with an extension cord unless this cord has been checked and tested by a qualified technician or service person.
Always use your appliance from a power outlet of the voltage (A.C. only) marked on the appliance.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
The temperature of accessible surfaces may be high when the appliance is operating.
Never leave an appliance unattended while in use.
Do not use an appliance for any purpose other than its intended use.
Do not place an appliance on or near a hot gas flame, or electric element, or on a heated oven.
Do not place it on top of any other appliance.
Do not let the power cord of an appliance hang over the edge of a table or bench top or touch any hot surface.
Do not operate any electrical appliance with a damaged cord or after the appliance has been damaged in any manner. If damage is suspected, return the appliance to the nearest Sunbeam Appointed Service Centre for examination, repair, or adjustment.
For additional protection, Sunbeam recommends the use of a residual current device (RCD) with a tripping current not exceeding 30mA in the electrical circuit supplying power to your appliances.
Do not immerse the appliance in water or any other liquid unless recommended.
Appliances are not intended to be operated by means of an external timer or separate remote control system.
This appliance is intended to be used in households and similar applications such as staff kitchen areas in shops, offices, and other working environments; farm houses; by clients in hotels, motels, and other residential-type environments; bed and breakfast-type environments.

If you have any concerns regarding the performance and use of your appliance, please visit www.sunbeam.com.au or contact the Sunbeam Consumer Service Line.
Ensure the above safety precautions are understood.

Features of your Sunbeam Belle-Aqua™ Kettle

3-Way Safety System.

Automatically switches the kettle off after boiling.
Cuts out for boil-dry protection.
Shuts down in case of overheating.

Sunbeam KE7110 Belle Aqua Kettle - Figure

Using your Sunbeam Belle-Aqua™ Kettle

Before using your kettle.
It is recommended that you clean your kettle before first use by filling the kettle with water, up to the maximum level indicator, boil, and discard.
Using your kettle.

To fill the kettle, remove it from the power base and open the lid by pushing the button on the top of the lid. Alternatively, the kettle may be filled through the pouring spout.
Fill the kettle with the desired amount of water (minimum 1 cup/250ml). Always fill the kettle between the minimum and maximum marks. Too little water will result in the kettle switching off before the water has boiled.
Note: Do not fill the kettle over the maximum level, as water may spill out of the spout when boiling.
Push the lid closed firmly until it locks into position.
Place the kettle on the power base and connect the plug to a 230/240 Volt AC power outlet. Turn the power ON.
Press the ON/OFF switch located on the handle downwards. The light will illuminate to indicate the kettle is heating.

The kettle will switch off automatically once the water has boiled.
Important: Ensure the lid is firmly closed. The kettle will not turn off if the lid is left open. Do not remove the kettle from the power base while in use.
Important: Avoid touching metal surfaces when operating the kettle as these will be hot. 6. Lift the kettle from the power base and pour the water.
Note: Use caution when pouring the water from your kettle as boiling water will scald. 7. The kettle may be stored on the power base while not in use. The kettle will not re-boil until the ON/OFF switch is pressed downward.
Note: Ensure the power is turned off at the power outlet when the kettle is not in use. Should you accidentally allow the kettle to operate without water, it will cut out for boil-dry protection. If this occurs, allow the kettle to cool before filling it with cold water and re-boiling.
Cord Storage Facility. The excess cord can be stored by winding the cord around the storage facility underneath the power base.

Sunbeam’s 3-Way Safety System

Safety is a major consideration in the design of a Sunbeam kettle. This is why we have developed our 3-Way Safety System, which ensures that your kettle will:

Automatically switch off after boiling.
For convenience, safety, and energy efficiency, your Sunbeam kettle features an auto-cut-out device.
Cut-out for boil-dry protection.
If the kettle is operated without water, it will automatically cut out, preventing any damage to the element.
Shut down in case of overheating.
In the event of overheating, the kettle will automatically shut down to prevent further damage. Should this occur, take your kettle to a Sunbeam Service Centre or appointed
Service Agent.

Care and Cleaning

Always disconnect the kettle from the power outlet before cleaning.
Never immerse the kettle switch area, cord or power base in water, or allow moisture to come into contact with these parts.
Descale Your Kettle Regularly
Mineral deposits in tap water solidify when the water is heated. Lime scale may be white, coloured, or even rusty-looking and is normally visible but phosphate scale isn’t generally visible but may cause the water to appear cloudy when heated. This may cause the interior of the water gauge to discolour, trigger the boil-dry cut-out mechanism or even reduce the kettle’s life.
Even in soft water areas, it is important to descale your kettle regularly to help maintains its lifecycle.
NOTE: Failure to descale products regularly can be deemed as negligent handling and any faults caused by mineral build-up will not be covered by the Sunbeam 12-Month Guarantee. To remove this build-up, use Sunbeam Liquid Descaler, a simple-to-use, non-toxic cleaner available from Sunbeam Appointed Service Agents.
Alternatively:

Fill the kettle with 1 cup of white vinegar and the remainder with water and allow to stand overnight. DO NOT BOIL.
Empty the solution from the kettle. Any stains remaining inside the spout can be removed by rubbing it with a damp cloth. Fill the kettle with clean water, bring it to a boil and then discard the water. Repeat and the kettle will then be ready to use.

To clean the kettle exterior
The plastic surface may be wiped over with a damp cloth and polished with a soft dry cloth.
CAUTION: To prevent damage to the appliance, do not use alkaline, chemical or abrasive cleaners. Use a soft cloth and mild detergent to protect the exterior surface.
To clean the mesh filter
CAUTION: Before removing or refitting the filter, switch off the kettle and empty it. Allow it to cool completely, then unplug the power base from the main supplied socket. Never operate the kettle without the filter fitted. Open the lid. Grasp the top of the mesh filter and pull upwards to remove it. Wash in warm soapy water and dry thoroughly before replacing it in the kettle.
Cleaning the concealed heating element
This kettle features a non-corrosive stainless steel heating element. Over time, the scale may build up on the concealed element inside the kettle, causing discolouration that may have the appearance of rust. Be assured this is not rust. If this occurs clean with a Scotchbrite scourer or similar and a suitable abrasive cleaning cream. Rinse and clean thoroughly with tap water before using your kettle again.

Should you experience any diﬃculties with your product during the warranty period, please contact our customer service line for advice on 1300
881 861 in Australia, or 0800
786 232 in New Zealand.
Australia
www.sunbeam.com.au
1300 881 861
New Zealand
www.sunbeam.co.nz
0800 786 232
This product is covered by a 12-month replacement or repair warranty, which is in addition to your rights under the Australian Consumer Law (if your product was purchased in Australia) or New Zealand Consumer Guarantees Act (if your product was purchased in New Zealand).
Upon receipt of your claim, Crock-Pot will seek to resolve your diﬃculties or, if the product is defective, advise you on how to obtain a replacement or refund.
To assist us in managing warranty claims, we recommend you register your product as soon as practicable after purchase, on our Sunbeam website and upload a copy of your original receipt. View the Support section of the Sunbeam website.
In order to make a claim under our warranty, you must have the original proof of purchase documentation for the product and present it when requested (if not already uploaded to our website).
Should your product develop any defect within 12 months of purchase because of faulty materials or workmanship, we will replace or repair it, at our discretion, free of charge. A product presented for repair may be replaced by a refurbished product of the same type rather than being repaired. Refurbished parts may be used to repair the product.
Our replacement or repair warranty only applies where a defect arises as a result of faulty material or workmanship during the warranty period. Your warranty does not cover misuse or negligent handling (including damage caused by failing to use the product in accordance with this instruction booklet), accidental damage, or normal wear and tear.
Your warranty does not:

cover freight or any other costs incurred in making a claim, consumable items, accessories that by their nature and limited lifespan requires periodic renewal (such as ﬁlters and seals) or any consequential loss or damage; or
cover damage caused by:
-power surges, power dips, voltage supply problems, or use of the product on incorrect voltage;
-servicing or modiﬁcation of the product other than by Crock-Pot or an authorised service centre;
-use of the product with other accessories, attachments, product supplies, parts or devices that do not conform to Crock-Pot speciﬁcations; or
-exposure of the product to abnormally corrosive conditions; or
extend beyond 3 months if the product is used in commercial, industrial, educational or rental applications.

The beneﬁts given to you by our warranty are in addition to other rights and remedies under a law in relation to the product.
In Australia, our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and for compensation for any other foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.
Our goods also come with guarantees that cannot be excluded under the New Zealand Consumer Guarantees Act.
If your warranty claim is not accepted, we will inform you and if requested to do so by you, repair the product provided you pay the usual charges for such repair. You will also be responsible for all freight and other costs.
Should your product require repair or service after the warranty period, contact your nearest service centre. For a complete list of service centres, visit our website or call our customer service line for advice on 1300 881 861 in Australia, or 0800 786 232 in New Zealand.
Need help with your appliance?
Contact our customer service team or visit our website for information and tips on getting the most from your appliance.”
Australia
visit www.sunbeam.com.au
phone 1300 881 861
New Zealand
visit www.sunbeam.co.nz
phone 0800 786 232
Newell Australia Pty Ltd. ABN 68 075 071 233
Sunbeam is a registered trade mark.
Made in China to Sunbeam’s specifications.
Due to minor changes in design or otherwise, the product you buy may differ slightly from the one shown here.
Approved by the appropriate electrical regulatory authorities.
©Copyright Sunbeam 2021.