JBL Wind 3 Portable Speaker User Guide

June 5, 2024
JBL

JBL logo

byHARMAN
QUICK START GUIDE
WIND3
BCJBL Wind 3 Portable Speaker

Bicycle Mount

JBL Wind 3 Portable Speaker - fig

  1. Install the included mounting bracket onto bicycle handlebars.
  2. Dock/undock the speaker into the mounting bracket effortlesslyJBL Wind 3 Portable Speaker - fig 1

WHAT’S IN THE BOX

JBL Wind 3 Portable Speaker - fig 4

BUTTONS

JBL Wind 3 Portable Speaker - fig 5

*long press to switch EQ between ‘Sport’ and ‘Bass’ mode Answer/ Ignore incoming call: Short press/ Long press End on-going call: Short press

Bluetooth pairing

FM RADIO

  1. Source Switch to FM mode
  2. TUNE DOWN / TUNE UP:
    Press 1x to tune down/up by step manually
    Press 2x to tune to the previous/next preset station
    AUTO SCAN:
    Long press to search for and tune to the previous/next available station automatically

TF / AUX-IN

CHARGINGJBL Wind 3 Portable Speaker - fig 9

WATERPROOF DUSTPROOF IP67

TECH SPEC

Transducer: 43 mm x 47 mm / 1.5″
Output power: 5 W RMS
Frequency response: 110 Hz – 20 kHz
Signal-to-noise ratio: > 85 dB
Battery capacity: 1050 mAh
Battery charge time: 2.5 hours (5 V  1 A)
Music play time: up to 5 hours (dependent on volume level and audio content)
Bluetooth® version: 5
Bluetooth® profile: A2DP 1.3, AVRCP 1.6, HFP 1.7
Bluetooth® transmitter frequency range: 2400 MHz – 2483.5 MHz
Bluetooth® transmitter power: <5 dBm (EIRP)
Bluetooth® transmitter modulation: GFSK, π/4 QPSK, 8DPSK
FM Tuning range: 87.5 MHz – 108 MHz (varies by countries)
Dimensions (W x H x D): 90 mm x 73.2 mm x 35.8 mm
Weight: 0.230 kg
Maximum operation temperature: 45 °C

**** To protect battery lifespan, fully charge at least once every 3 months. Battery life will vary due to usage patterns and environmental conditions.
Do not expose the JBL Wind 3 to liquids without removing cable connection. Do not expose JBL Wind 3 to water while charging. It may result in permanent damage to the speaker or power source. Chemicals, salt or “foreign particles” in your pool or the ocean can damage the waterproof seals or harm the connector surface over time if not rinsed off after use. After a liquid spill or rinse, do not charge your speaker until it’s completely dry and clean. Charging when wet might damage your speaker.
When using an external adapter, the output voltage/ current of the external adapter should not exceed 5V/3A.

The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by HARMAN
International Industries, Incorporated is under license. Other trademarks and trade names are those of their respective owners.

CA_JBL_WIND3_QSG_Global_SOP_V12

Documents / Resources

| JBL Wind 3 Portable Speaker [pdf] User Guide
Wind 3 Portable Speaker, Wind 3, Portable Speaker
---|---

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals