concept VT 7030 Hot-Air Fan Instruction Manual

: June 5, 2024
: concept

Table of Contents

concept VT 7030 Hot-Air Fan
ACKNOWLEDGMENT
IMPORTANT SAFETY INSTRUCTIONS
PRODUCT DESCRIPTION
OPERATING INSTRUCTIONS
MAINTENANCE AND CLEANING
ENVIRONMENTAL PROTECTION
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

concept VT 7030 Hot-Air Fan

ACKNOWLEDGMENT

Thank you for purchasing a Concept product. We hope you will be satisfied with our product throughout its service life.
Please study the entire Operating Manual carefully before you start using the product. Keep the manual in a safe place for future reference. Make sure other people using the product are familiar with these instructions. concept-
VT-7030-Hot-Air-Fan-1

IMPORTANT SAFETY INSTRUCTIONS

Use the unit only as described in this operating manual.
Remove all the covering and marketing materials from the unit before the first use.
Make sure the mains voltage corresponds to the values stated on the product’s rating plate. Do not connect the unit to adapter plugs or extension cables.
Do not use this unit with any programmable device, timer, or any other product turning the unit on automatically; if the unit is covered or installed improperly, a fire may occur.
Make sure to place the unit on a stable heat-resistant surface, out of the reach of other heat sources.
Close supervision is necessary when the unit is on or plugged into the socket.
Before unplugging the unit from the wall outlet, move the mode selector to the “O” position and then remove the plug from the wall outlet.
Never pull the cord to disconnect the plug from the socket; hold the plug instead.
Do not install the unit directly under the wall outlet.
Keep the minimum safe distance of at least 100 cm between the unit and any flammable materials, such as furniture, curtains, lace, blankets, paper, clothing, and so on.
Keep the air inlet grille and air outlet grille unobstructed (at least 100 cm in front of and 50 cm behind the unit). Warning! The outlet grille achieves an operational temperature of more than 80°C. Do not touch it; there is a danger of being burned!
Do not allow children or unskilled people to handle the unit. Use the unit out of the reach of these individuals.
Persons with limited movement capacity, reduced sensory perception, insufficient mental capacity or those who are unaware of the proper handling should use the product only under the supervision of a responsible person who is aware of these instructions.
Pay the utmost attention when using the unit near children.
Do not cover the unit. There is a risk of overheating. Do not use the unit for drying cloth.
Do not hang anything above or in front of the unit.
Use the unit only as described in this operating manual.
The unit shall be installed in such a way that the plug remains accessible at all times.
The unit may be operated in the upright position only.
Do not use the unit near a shower, bathtub, sink, or swimming pool.
Do not use the unit in an environment with explosive gases or flammable substances (solvents, varnishes, adhesives, etc.).
Turn the unit off, disconnect the power cord from the wall outlet, and allow the unit to cool before cleaning.
Keep the unit clean; prevent foreign bodies from entering the grille openings. This could cause a short circuit, damage to the unit, or fire.
Do not use abrasive or chemically aggressive substances to clean the unit.
Never use the appliance if the supply cord or plug is damaged. Immediately refer to an authorized service center for repair.
Do not use the unit if it does not operate properly if it has been dropped, damaged or exposed to any liquids.
Take the unit to an authorized service center for testing and repair.
The unit is not designed for outdoor use.
The appliance is intended for domestic use only, not for commercial use.
Never operate the appliance with wet hands.
Do not immerse the power cord, plug, or appliance in water or any other liquid.
The unit is designed as an auxiliary heater, not for the purpose of overall heating of an interior.
The unit shall not be mounted on the wall.
The unit shall not be used in any means of transport.
Do not repair the appliance yourself. Refer to an authorized service center instead.

Failure to follow the manufacturer‘s instructions may lead to refusal of warranty repair.

CAUTION
When turning the unit on for the first time or after a prolonged downtime the unit may emit a slight odour. This odour will vanish after a short time.
Note: Do not use the unit in rooms smaller than 4 m2.

PRODUCT DESCRIPTION

Air inlet grille
Air outlet grille
Mode selector
Thermostat regulator
Safety switch against overturning the device
OSC. on/off buttons

OPERATING INSTRUCTIONS

Place the unit on a stable surface or floor to prevent it from tipping over. Remove the entire feed cord from the storage space and uncoil it.
Connect the power cord plug to the wall outlet.
Select the required function using the mode selector:
- 0 = Off
- FAN = Cool air
- 1 = heating capacity (850 W )
- 2 = Full heating capacity (approximately 1500 W ).
You may set the required temperature in the room using the thermostat regulator. When heating function (1) or (2) is selected, the unit will alternately switch on and off, thus keeping the required temperature.
Note: A more accurate temperature can be set as follows:
Set the thermostat to the maximum, and switch the heating to (1) or (2) . When the required temperature has been reached in the room, turn the thermostat slowly to a lower temperature, until the unit switches off.
If you use the fan in the cool air mode , set the thermostat regulator to the maximum.
After use, move the mode selector to the (0) position and unplug the unit from the mains.

Safety switch against overturning the device
Safety switch against overturning stops operation, when the device is overturned or is placed inappropriate manner that undermines security.

Reset instructions

Unplug the heater and wait 20 minutes for the unit to cool down.
After the 20 minutes, plug the unit in again and operate normally.

MAINTENANCE AND CLEANING

WARNING!
Before cleaning the unit, always disconnect the power cord from the wall outlet!
Prior to handling, make sure the unit has cooled down!
The surface of the unit may only be cleaned using a wet cloth. Do not use any detergents or hard objects, as they may damage the unit’s surface!
The air inlet and outlet grilles should be cleaned frequently to ensure proper operation of the unit and to avoid overheating.
Dust accumulated in the unit may be blown out or removed by a vacuum cleaner.
Never clean the unit under running water, do not rinse it, and do not submerge it in water!

REPAIR & MAINTENANCE
Any extensive maintenance or repair that requires access to the inner parts of the product must be performed by an expert service centre.

ENVIRONMENTAL PROTECTION

Packaging materials and obsolete appliances should be recycled.
The transport box may be disposed of as sorted waste.
Polyethylene bags shall be handed over for recycling.

Appliance recycling at the end of its service life:
A symbol on the product or its packaging indicates that this product should not go into household waste. It must be taken to the collection point of an electric and electronic equipment recycling facility. By making sure this product is disposed of properly, you will help prevent the negative effects on the environment and human health that would otherwise result from the inappropriate disposal of this product. You can learn more about recycling this product from your local authorities, a household waste disposal service or in the shop where you bought this product.