HAARAY 208LED LED Solar Motion Light Instruction Manual

June 16, 2024
HAARAY

LED SOLAR MOTION LIGHT
Instructions

 208LED LED Solar Motion Light

Thank you very much for purchasing HAARAY’s LED solar outdoor light.
Please read this “Instructions” carefully before use.

PACKING LIST

HAARAY 208LED LED Solar Motion Light - packing list

INSTALLATION

Wall Mount:
Step 1: Drill out the holes with a drill bit and put the plastic wall plugs into the holes.
Step 2: Secure the bracket to the wall with screws.
Step 3: Buckle the light onto the bracket.
HAARAY 208LED LED Solar Motion Light - packing list 1 Stick in the Ground :
Step1: Assemble the bracket, ground spike and stake together.
Step2: Insert the stake into the ground.
Step3: Buckle the light onto the bracket.

HOW TO USE

When you receive the product, the default mode of the light is OFF, please select the mode you want through the power/mode button on the back of the light to be able to use it properly.
*OFF Default mode
Mode 1: From night to dawn, the light automatically turns on at 50% brightness until the power runs out.
Working State
Mode 2: Turn on the strong light when motion is detected, and turn to 30% dim light after 20 seconds when people leave.
Working State
Mode 3: Turn on the 100% strong light when motion is detected and turn off after 20 seconds when people leave.
Working State**

WARM TIPS

  • Please make sure the spot light is installed under direct sunlight where there is no shade or eave to shelter the solar panel.
  • Please put the light under direct sunlight for 1-2 days to charge before the first use.
  • when the solar panel is illuminated, the light will be off! Also, when charging the solar panel, the light will not work.
  • In winter, it is normal to not get enough energy from the sunlight, so the brightness is usually lower and the working time at night is shorter.
  • Please clean the solar panel regularly to ensure the efficiency of charging.

PRODUCT SPECIFICATIONS

Solar Motion Light

Battery Type| 18650 Lithium-ion
Detection Distance| 16-26ft
Charging Time| About 8 hours
Size| 11.25.74.7in
Net Weight| 1.51b/pcs
Material| ABS+PC
Waterproof Rating| IP65
Lumen| 2100
Mounting Height| 6-8ft
Ambient temperature| Charge: 32°F-113°F Discharge: 14°F – 140°F
Power Source| Solar Powered
Battery
Battery capacity| 2200mAh
Voltage| 3.7v
Lifetime| > 500 times
LED
Light Color| white
Color temperature| 6500 – 7000K
Quantity| 208
Lifetime| >50000h

SAFETY PRECAUTIONS

  1. If you find the battery has bad smell, heat or deformation, please turn the power mode to OFF and stop using it and contact us.
  2. It can resist ordinary rain and wind, but please do not let the product soak in water.
  3. Please do not look directly at the LED light when lighting up. There is a risk of eye injury.
  4. The sensitivity of the sensor cannot be adjusted, and the sensitivity of the sensor may change depending on the environment in which it is used.

FAULT CAUSE ANALYSIS

Issue possible cause Solution
The light didn’t turn off The angle and height of the PIR detector are not
within the sensing range. Try to adjust the angle of the sensor ball so that

it is within the height and range of motion sensing.
The light stays on during the day| The location is dark| Please change the Installation
to a brighter place than the
current location.
The light is not working| The switch is OFF.| Press the light mode switch
(1, 2 or 3 times).
The solar panel is surrounded
by other light sources.| Block/change the location
of the solar panel.
After purchase, does not charge.| Charging for more than two days in fine weather and more than four days in cloudy weather.Please start using it.
Not used for a long time.| Please charge it once a month.
Insufficient power.| Change the angle and location of
the solar panel.Please make sure
the sunlight hits efficiently.
The solar panel is dirty.| Clean the solar panel.
Battery break/inside request.| Please contact the seller.
Others issues| Mode reset, Blinking| Please contact the seller.

PRECAUTIONS FOR MAINTENANCE

  • Do not apply strong impact to the product body such as dropping or striking.
  • When not used for a long time, turn OFF the light, and remove the light from its installation location.

WARRANTY

At the same time, you can also get more promotion information about our products by following our brand flagship store.
If you have any questions,you can contact our customer service support team: [email protected].
We offer a minimum 6-month warranty service for products with quality issues.

Monday ~ Friday
9:00~18:00
HAARAY-US Customer Support
Email: [email protected]

[email protected]

Read User Manual Online (PDF format)

Loading......

Download This Manual (PDF format)

Download this manual  >>

HAARAY User Manuals

Related Manuals