TruSens N-200 Smart Humidifier User Guide
- June 5, 2024
- TruSens
Table of Contents
N-200 Smart Humidifier
User Guide
WELCOME TO COMFORTABLE INDOOR AIR.
Control your air and achieve your optimal humidity with TruSens. Real-time
feedback from a remote SensorPod” helps your humidifier monitor and adjust to
your ideal moisture levels.
WARNING
Before the operation, follow these steps and read our TruSens Owner’s
Manual at www.trusens.com/support/owners-
manuals/
Included in your box
1 Humidifier+ Power Cord
1 Sensor Pod + 2 AAA Batteries
1 Water Filter
1 Absorbent Aromatherapy Pad
Directions for use
WARNING
Always unplug the humidifier before removing the water tank. Empty all water
before cleaning the water tank, replacing the filter, or moving the
humidifier. Only place the water tank on a hard, solid surface; do not place
it on carpeting.
Prepare the water filter ,
Remove the plastic bag from the filter.
For optimal performance, submerge the filter in a bowl of water for l hour.
Install the water filter
a) Unscrew the grey cap. b) Secure the filter onto the grey cap. c) Tightly
secure grey cap with filter onto water tank until indicator meets lock symbol.
Failure to properly tighten the grey filter cap may result in leaking. The
return water tank is on top of the base.
Fill the water tank
Remove the water tank lid and fill with room temperature water (preferably
distilled) with the pitcher.
WARNING
Do not pour water into the mist outlet or directly into the base/reservoir.
CAUTION: Heavy object. To avoid injury always fill the tank from the top
and use care when lifting.
Set up
Place the humidifier on a dry, firm, flat surface that is free from
obstructions.
Note: Failure to properly tighten the grey filter cap may result in leaking.
Open lid of battery chamber found on SensorPod (bottom) and insert 2 AAA
batteries (provided).*
SensorPod will automatically begin monitoring if the humidifier is on.
For optimal results, place SensorPod on a tabletop or counter across the room,
within line of sight of the humidifier.
Control the humidifier with the touch buttons on SensorPod. 
Control Panel
| Power on/of
---|---
| Fitter change Indicator
| Tmer: 2h/4h/8h/12h
| Target Humidity: decrease/increase
| Misting Speed Settings: l/2/3/AUTO
| Dimmer: on/off
Aromatherapy Use
Locate the Aromatherapy Tray (back of the base) and pull down the lid. Add a few drops of essential oil* to the absorbant aromatherapy pad (provided) and close tray.
- Only use 100% natural essential oils.
WARNING
Do not add essential oils to the water tank. Do not use synthetic fragrances.
Cleaning Instructions
We recommend you clean weekly for optimal performance.
Refer to the Owner’s Manual for detailed instructions.
WARNING
Unplug the humidifier before cleaning.
Filter Replacement
| Filter Type | Suggested Replacement | Item Number |
|---|---|---|
| Water Filter | 4 months | WSF300-0l |
*Filter Change Indicator on the control panel will glow red to notify you to change.
Change the water filter before restarting after long periods of non-use.
ACCO Brands Australia Pty Ltd I Locked Bag 50, Blacktown BC, NSW 2148
Phone: 1300 278 546 I Email:
[email protected]
Support and Warranty Terms at www.trusens.com
Follow this link for instructions https://www.trusens.com/en-au/support
/humidifier-support/