eta 3174 INESTO Electric coffee maker Instructions
- June 5, 2024
- ETA
Table of Contents
eta 3174 INESTO Electric coffee maker
INSTRUCTIONS FOR USE
Dear customer, thank you for purchasing our product. Please read the operating
instructions carefully before putting the appliance into operation and keep
these instructions including the warranty, the receipt and, if possible, the
box with the internal packing.
SAFETY PRECAUTIONS
- Read the instruction manual carefully, inspect the illustrations and store the manual before first use.
- Check if the information on the label corresponds with the voltage in your electric outlet.
- Do not plug or unplug the supply cord with wet hands or by pulling by the cord!
- The product is intended for home use and similar (in shops, offices and similar workplaces, in hotels, motels and other residential environments, in facilities providing accommodation with breakfast). It is not intended for commercial use!
- This product can be used by children at the age of 8 years and older if they are supervised or if they were instructed regarding use of the appliance in a safe way and if they understand possible risks. Children must not play with the appliance. User cleaning and maintenance must not be performed by children if they are younger than 8 year and unsupervised. Children younger than 8 years must be kept out of reach of the appliance and its power cord
- The device may be used by persons with reduced physical or mental abilities or lack of experience and knowledge only if they are under supervision or they have been instructed about using the appliance safely and understand the potential dangers. Children must play with the appliance.
- Never use the appliance if the supply cord or plug is damaged, if it is not working properly or has fallen on the ground and become damaged or dropped into water. In such cases take the appliance back to the service where they will check its safety and correct functions.
- If the supply cord of the appliance is damaged, it must be replaced. by the manufacturer, its servicing technician or similarly qualified personnel to avoid hazardous situations.
- Before replacing accessories or accessible parts, before assembly and disassembly, before cleaning or maintenance, turn off the appliance and disconnect it from the mains by pulling the power cord from the power socket!
- Always unplug the appliance from power supply if you leave it unattended and before assembly, disassembly or cleaning.
- When the appliance is in operation, prevent pets, plants or insects to get in contact with it.
- Do not pour sparkling, hot, and boiling water, milk, mineral water, and other liquids in the tank. Use only cold drinking water
- Do not immerse the coffee maker in water and other liquids (not even partially)! Use the device in its operating position in places where there is no danger of toppling, in sufficient distance from heat sources (e.g. stove, el./gas cooker) and damp surfaces (e.g. sink, basin).
- This appliance is not intended for outdoor use. Do not use the drive unit for heating a room!
- The product may not be used without the filter B1 (filter sieve)!
- Do not use the appliance with a program, time switch or any other part that turns the appliance on automatically as there is a risk of fire if the appliance is not covered or placed properly.
- The appliance is equipped with the heat safety lock which disconnects power supply if water boils away or if an empty appliance is turned on. If it happens, unplug the appliance from power supply and let it cool down. Do not fill the appliance with cold water in order to cool it down quickly. It could reduce life of the heating element.
- Due to production tests, the internal container can be misted up. Do not consider it to be a defect when purchasing the appliance.
- It is not allowed to modify the surface of the appliance in any way (e.g. using a selfadhesive wallpaper, foils, etc.)!
- According to the type of your appliance, the surface kettle is glass. These material are very fragile, pay special attention when handling, operation, maintenance and storage to avoid injury. Never use the kettle if it is broken, cracked or shows signs of any damage or fissure.
- Do not expose the appliance to atmospheric effects (sunshine, rain) and temperatures under 3 °C.
- Whenever you fill the container with water during heating and empty the container after heating, unplug the appliance from the electric power.
- If the appliance was stored at lower temperatures, acclimatize it first, by which you remove stiffness and mechanical resistance of the plastic parts will be kept The product is equipped with a safety fuse which protects it against overheating.
- Do not carry the appliance when it is hot; there is a risk of getting burned and scalded in the case of possible tilting.
- The appliance is portable and it is equipped with a movable connector with a plug which ensures double-pole disconnection from power supply. If you need to use an extension cord, it has to be uncorrupted and it has to comply with the valid standards.
- Do not cover the heating plate and do not place any flammable objects on it, it is intended only for heating coffee contained in a glass kettle.
- Do not leave an empty glass kettle on the heating plate when the coffee maker is on. Do not put a hot glass kettle on a wet or cold surface.
- Do not use the kettle for heating any other drinks on other heat sources.
- Do not use the glass kettle if it is cracked or its handle is loose or damaged
- There must be water in the coffee maker before operation ( max. 1.5 I ).
- Do not open the coffee bin during operation.
- Use the appliance only with accessory intended for this type of device. Any other accessories could cause electric shock, injury or fire. Pay attention not to cause any injury while operating the coffee maker (e.g. by steam, hot coffee.
- The supply cord must not be damaged by sharp or hot objects, naked flame and must not be immersed in water. Check the supply cord regularly.
- Do not use the appliance for any other use than the one it is intended for and described in this manual
- The producer does not guarantee any loss caused by improper handling of the appliance and its accessories (e.g. burning, scalding, breaking of the glass kettle, fire) and its guarantee for the appliance does not apply in the case of non-compliance with the safety instructions above.
Features of the device (pic. 1)
A coffee maker
A1 water tank lid
A2 water tank
A3 watermark
A4 heating plate
A5 ON/OFF switch
A6 control pane
A7 supply cord
B removable filter holder with automatically closing valve DRIP-STOP
B1 – filter
C glass kettle with lid
CONTROL FEATURES FUNCTIONS
HOUR | hours setting button |
---|---|
MIN | minutes setting button |
PROG | automatic coffee preparation setting button (timer) |
ON/OFF | start / stop button |
AUTO | automatic coffee preparation (timer) indicator |
RUN | coffee preparation indicator |
Digital clock works with the time mode indicator within the range of 24 hrs. When plugging the coffee maker in, the display will show 12:00.
Note
In case unusual characters appear on the display, unplug the appliance from
the outlet and plug it in again.
Hours setting
Press PROG ( CLOCK is displayed). Set the correct time by pressing or
holding down the HOUR button.
Minutes setting
Press PROG ( CLOCK is displayed). Set the correct time by pressing or
holding down the MIN button.
Note If you are setting the hours and minutes at the same time, you can press the PROG button only 1x. The display must always show CLOCK.
Setting the timer
Press the PROG button twice (TIMER is displayed). Set your desired time of
coffee preparation by pressing the HOUR and MIN buttons. Then press the
ON/OFF button twice (the red indicator AUTO will light up). The timer
function is programmed.
Turning on the coffee maker
Press the ON/OFF button and the device starts operating (the ON indicator is
on).
Turning off the coffee maker
Press the ON/OFF button twice and the coffee maker will turn off (the RUN and
AUTO indicator will switch off).
INSTRUCTIONS FOR USE
Remove all packaging material. Remove all adhesive foils, stickers or paper from the appliance. Place the coffee maker on a flat, stabile, smooth and clean desk at least 85 cm high, out of reach of children and persons mentally incompetent (see par. I. SAFETY CAUTION ). Allow free space for enough ventilation. Make sure that the supply cord is not damaged and does not go over any sharp or hot surfaces. The el. outlet must be easily accessible in order that the coffee maker can be easily disconnected from the el. outlet in case of danger. Plug the fork of the supply cord A7 into the outlet. Set the actual time. Rinse the water system before first use. Fill the tank with water to measure 12, turn the device on (without the filters and coffee). Pour the water out of the kettle and repeat approx. twice after the cycle is finished.
Filter
The device is equipped with a permanent filter B1 , in which ground coffee
is put. If you wish to use paper filters, we recommend paper filters size
no. 4 or 1×4 which are commonly available in all domestic
appliances shops. Do not forget to bend the edges of the paper filter before
putting it into holder B to avoid tearing and creasing. Dispose of the used
paper filter with the coffee with other common waste.
Coffee preparation
Tip out the A1 lid. Fill the A2 tank with fresh cold drinking water in
such amount that corresponds with your consumption. Tip out the holder by
pulling it slightly B. Using the measure, pour the desired amount of
ground coffee into filter B1 and close the holder with a snap.
Put the kettle C on the heating plate A4 and make sure that the container
lid is closed. The coffee maker is set to operation by pressing the ON/OFF
button on the control panel A6. The preparation and heating mode is
indicated by the indicator light. After the preparation is finished, the
coffee maker switches automatically into the heating mode and will keep the
coffee hot. If you wish to turn the coffee maker off, press the ON/OFF
button twice and the indicator light will switch off.
Note
The appliance is not active if the indicator lights AUTO or RUN are not on.
Make sure you do not leave the timer set by accident! The appliance could turn
on without water!
Unplug the appliance from the outlet after the making of coffee is finished!
Pausing the coffee preparation
It is possible to take out the glass kettle C for a while (max. 30 seconds
) anytime during the process of preparation and pour a cup of coffee.The
Drip-Stop valve ensures that there will be no coffee dripping from the
kettle on the heating plate. It is necessary to have the kettle lid closed for
its proper function.
Attention: After the preparation, the coffee in the kettle may have different quality and taste than coffee from the first cups prepared before pausing the process.
Recommendation
- We do not recommend heating prepared coffee for longer than 1 hour.
- If you wish to prepare another kettle of coffee immediately, let the coffee maker cool off for approx. 10 minutes. Dump the used coffee from the filters, rinse it and put it back. Rinse the glass kettle and put it back on the heating plate. Repeat the process of preparation.
- If you wish to re-heat already prepared coffee, you may put the kettle into a microwave.
Automatic coffee preparation feature
This feature enables you to preset your desired time of coffee preparation.
Pour water into the tank put the filter with coffee into the holder and set
the timer. The AUTO indicator will light on the control panel so that the
coffee preparation begins at a set time.
NOTICE
- If you wish to use the timer function, make sure correct time is set on the clock.
- If it should come to power supply failure, the clock and the timer need to be set again.
MAINTENANCE
Unplug the appliance from an electric outlet before each maintenance and clean only after the appliance has cooled off! Pull the B holder and B1 filter out of the coffee maker. Holder, filter and glass kettle can be washed in a dishwasher. Put the filter holder back into the coffee maker ( make sure it is inserted correctly ). Other parts of the coffee maker (housing, heating plate) should be cleaned with a damp cloth. Do not use rough and abrasive cleaning agents (e.g. sharp objects, scrapers, diluents or other dissolvents ). Some foods may discolor the accessory. This has no impact on the function of the appliance and can not be a reason for refund. This discoloration usually disappears with time. Never dry the plastic die- cast over a heat source (e.g. stove, cooker, radiator ).
Removing calcic sediments
In case of significantly longer time of coffee preparation, it is necessary to
carry out cleaning of the water system from calcic and mineral sediments which
are contained in drinking water. These sediments may be removed with a water
solution with agents intended for these purposes. After finishing the
cleaning, do not forget to rinse the water system of the coffee maker with
clean drinking water at least 3 times to remove potential remnants of the
cleaning agent used. In case of very thick sediments, you can repeat the
process. Carry out the cleaning regularly , approx. 2-3 times a year with
water hardness up to 18 °DH (22,5 °Clarke) a 4-5 times a year with water
hardness over 18 °DH (22,5 °Clarke). You may find out the information on water
hardness at your water mains administrator or at a hygienic station. Never use
a descaling agent based on mineral acids such as sulphuric acid, hydrochloric
acid, sulphamic acid and acetic acid (e.g. vinegar). These descaling agents
may damage your ETA coffee machine.
ENVIRONMENT
Printed signs of materials used for manufacture, packing, components and accessories, as well as their recycling, are on all the pieces if their dimensions enable it. The symbols on the product or in the accompanying documentation mean that the used electric or electronic products must not be disposed together with municipal wastes. Please, hand them over to the collection points designed for their correct disposal, where they will be accepted free of charge. By correct disposal of this product you can help to preserve valuable natural resources and help to prevent possible negative impacts to the environment and to human health, which could be the results of incorrect waste disposal. For further details ask the municipal authorities or the nearest collecting point. Penalties can be charged for incorrect disposal of such wastes, according to national regulations. If the appliance is to be put out of operation definitely, we recommend cutting off the feeder cable, to disable its use.
Expert service must do the large maintenance or to intervene into inside
parts of the appliance!
Non-observance of the instructions of the manufacturer cancels the right for
guarantee repair!
TECHNICAL DATA
Voltage (V) | found on the product label |
---|---|
Input (W) | found on the product label. |
Maximum volume of water (l) | 1.5 |
Maximum volume of coffee (g) | 60 |
Time of heating when the water and coffee
content is full (min.) approx.| 12
Weight (kg)| 1.5
Protection class of the appliance| I.
Size of the product (cm)| 41 x 49 x 65
Input in standby mode is| < 1,00 W
EC declaration on conformity was issued for the product. Regarding EMC, the
product conforms to the Council Directive No. 2004/108/EC as amended and
regarding the electric safety, the product conforms to the Council Directive
No. 2006/95/EC as amended.
The product is in compliance with the Regulation of the European Parliament
and Council
No. 1935/2004/EC on materials and articles intended to come into contact with
food.
The manufacturer reserves its right for unimportant deviations from the
standard design without influence of the product function.
DO NOT IMMERSE IN WATER OR OTHER LIQUIDS
TO AVOID DANGER OF SUFFOCATION, KEEP THIS PLASTIC BAG AWAY FROM BABIES AND
CHILDREN. DO NOT USE THIS BAG IN CRIBS, BEDS, CARRIAGES OR PLAYPENS. THIS BAG
IS NOT A TOY.
NOTICE
Documents / Resources
| eta
3174 INESTO Electric coffee
maker
[pdf] Instructions
3174, INESTO Electric coffee maker, Electric coffee maker
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>