eta 0049 Crema Electric Hand Beater Instruction Manual

eta 0049 Crema Electric Hand Beater

INSTRUCTIONS FOR USE

Dear customer, thank you for purchasing our product. Please read the operating instructions carefully before putting the appliance into operation and keep these instructions including the warranty, the receipt, and, if possible, the box with the internal packing.

SAFETY WARNING

• Consider the instructions for use as a part of the appliance and pass them on to any other user of the appliance.
• Check whether the data on the type label corresponds with the voltage in your socket.
• The power cord plug has to be connected to the properly connected and grounded socket according to the national standard.
• This appliance must not be used by children.
• This appliance can be used by persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance.
• Children must be kept out of reach of the appliance and its power cord.
• If the power cord of the appliance is corrupted, it has to be replaced by the manufacturer, its service technician or a similarly qualified person so as to prevent dangerous situations.
• Before replacing accessories or accessible parts, which move during operation, before assembly and disassembly, and before cleaning or maintenance, turn off the appliance and disconnect it from the mains by pulling the power cord from the power socket!
• Always unplug the appliance from the power supply if you leave it unattended and before assembly, disassembly or cleaning.
• Never use the appliance if the power cord or power plug are damaged, if it is not functioning correctly or if it has fallen on the floor and been damaged, or if it has fallen into the water. In such cases take the appliance to a professional service center to verify its safety and correct function.
• Be careful when handling the accessories (immersion blender), the knife is very sharp!
• Be careful when pouring hot liquid into the food processing device or the mixer because it may spurt out of the appliance because of the sudden boil.
• The appliance is intended for home use and similar (in shops, offices, and similar workplaces, in hotels, motels, and other residential environments, in facilities providing accommodation with breakfast). It is not intended for commercial use!
• When the appliance is in operation, prevent pets, plants or insects to get in contact with it.
• Never submerge the drive unit under water and do not wash under running water!
• Do not plug or unplug the appliance from a socket with wet hands and do not pull the power cord!
• Never leave the appliance unsupervised and check it during the whole time of water heating!
• Use the appliance in the working position only at places with no risk of turning over and at a sufficient distance from heat sources (e.g. heater, stove, cooker, oven, grill), flammable objects (e.g. curtains, drapes, etc.), and wet surfaces (e.g. sinks, wash basins, etc.).
• This appliance is not intended for outdoor use.
• The appliance must not be used in a damp or wet environment and in any environment with the danger of fire or explosion (spaces where chemicals, fuels, oils, gases, paints and other flammable or volatile materials are stored).
• Before preparation, remove possible packages from food (e.g. paper, a PE bag, etc.).
• If the propulsion unit is operating, do not remove the accessories.
• The maximum time of processing is 10 minutes. Then wait for 15 minutes, which is necessary for the drive unit to cool down.
• Check if the switch is in the off position before each connecting of the appliance to the el. outlet and always unplug the appliance from the el. outlet after finishing work.
• Due to safety it is not possible to change the attachments while the drive unit is in operation.
• Do not use the accessories in containers, in which you heat food at the same time using heat sources (e.g. heater, electric/gas/induction cooker, hot plate etc.).
• Do not process foods with a temperature over approx. 80 °C (176 °F).
• If the processed ingredients begin to stick on the accessories (e.g. whisks, kneading hooks, blender knife), turn the appliance off and clean the accessories carefully with a spatula.
• Do not mix attachments (whisks B and hooks C). If there are accessories in the propulsion unit (B or C), you can not connect blender D at the same time and vice versa.
• Do not insert accessories into any body cavities.
• Make sure that your hair, clothes, and accessories do not get into the dangerous vicinity of the rotating parts!
• Never insert e.g. fingers, fork, knife, spatula, or spoon into rotating parts of the appliance and the accessories.
• Make sure the whisks do not hit the walls of the utensils during operation or do not get stuck in the thick matter or frozen ingredients.
• Make sure that the power supply cable does not get in between the rotating parts of the appliance.
• The power cord must not be damaged by sharp or hot objects, or open fire, it must not be sunk into water or bent over sharp edges. Never put it on hot surfaces or do not let it hang over the edge of a table or work tables. Hitting, stumbling or pulling the power cord e.g. by children can result in tilting over or drawing the appliance down and serious injury!
• If you need to use an extension cord, it has to be uncorrupted and it has to comply with valid standards.
• Check the condition of the power cord of the appliance regularly.
• In order to ensure the safety and proper function of the appliance, use only original spare parts and accessories approved by the manufacturer.
• Use this appliance only for the purpose for which it was designed as specified in this user‘s manual. Never use the appliance for any other purpose.
• Caution: Do not use the appliance with a program, time switch or any other part that turns the appliance on automatically as there is a risk of fire if the appliance is not covered or placed properly.
• WARNING: There is a risk of injury in case of incorrect use (not in accordance with the manual) of the appliance.
• All text in other languages and pictures are shown on the packaging, or the product itself, are translated and explained at the end of this language mutation.
• The manufacturer is not responsible for damage caused by improper use of the appliance and the accessories (e.g. food deterioration, fire) and its guarantee for the appliance does not apply in situations when the safety warnings above are not complied with.

DESCRIPTION OF THE APPLIANCE

• A – drive unit
• A1 – speed selector
• A4 – handle
• A2 – TURBO button
• A5 – power cord
• A3 – holes for connecting the accessories B, C
• A6 – a cover of the blender drive (only ETA 1049)
• B – whipping beaters
• C – kneading hooks
• D – immersion blender (only ETA 1049)

PREPARATION FOR USE

Remove all the packing material and take out the beater with the accessories. Remove all possible adhesion foils, and stick–them on labels or paper from the appliance. Before the first use, wash the parts that will be in contact with food in hot water with a detergent, rinse them thoroughly with clean water and wipe them till dry, or let them dry. Plug the power cord connector A5 into an electric socket.

Using individual levels, (fig. 2)

USE OF THE ACCESSORIES

Whipping beaters (B)

• Use: Whisking egg whites, mousse, creams, whipping creams, sponge cake dough/ batter, mashes, etc.
• Switch level: 1 – 5, whipping time about 1 – 5 minutes
• Insertion: Insert the beaters to the respective holes A3 in the lower part of the drive to the maximum position. Release the whisks by pressing the release button A1.

Recommendation

• When whipping, use the substances at room temperature.
• First, put liquid ingredients to the bowl and only then put solid ingredients in to achieve the best results.
• First, whip at low speed so that the dough does not splash out. Only then you can go to a higher speed.
• If beating is not optimal, make sure that the beater is not greasy, or add a little lemon juice or salt.
• Cool the cream or whipping cream to at least 6 °C (at least 200 ml) before processing.
• We recommend using a narrow container for whipping cream.
• Never use whipping beaters for mixing tough materials, such as yeast dough.

Kneading hooks (C)

• Use: Preparing spreads, mixing potatoes, spinach, mixing dough, etc.
• Switch level: 1 – 3, kneading time about 1 – 5 minutes.
• Insertion: Mutual position is given by their construction; for this reason, mutual interchangeability of the hooks in the holes is not possible. Insert the hooks to the respective holes A3 in the lower part of the drive to the maximum position. Release the hooks by pressing the release button A1.

Recommendation

• When kneading, use the substances at room temperature.
• First mix yeast in lukewarm milk. As soon as the dough gets into the shape of a ball, stop kneading as you are used to, or leave the dough to rise according to the recipe.
• When preparing the tough dough, we recommend putting loose ingredients in the bowl first for better mixing and then adding liquid ingredients.

Warning

• Switch on the appliance only when accessories B, C, and D are immersed in the processed ingredients.
• The hooks and whisks can be released from the propulsion unit only when the speed selector A1 is in position 0 an M.
• For whipping, only one whipping beater can be used in a suitable container.
• Choose the size of the container according to the amount of the prepared mass.
• When preparing a larger amount of dough (max. 0.5 kg / 1 batch) process it in several batches. Under no circumstances should you prepare more than two batches after each other.
• Various types of flour may differ significantly in the number of liquids needed and the stickiness of the dough may have a major effect on the loading of the hand mixer. If you hear that the hand mixer is being excessively loaded, turn it off, remove half the dough and process each half separately.

An immersion blender (D)

• Use: blending and mixing all kinds of liquids, mayonnaise, dietary and baby food, etc., in another suitable utensil.
• Selector level: M + TURBO button, blending time max. 30 seconds, then wait for 60 seconds, which is necessary for the drive unit to cool down.
• Insertion: Insert the cover A6, and screw the blender D in the opening in the propulsion unit A (1-3 arrows). Proceed reversely when removing from the propulsion unit (4-5 arrows).

MAINTENANCE

Before any handling with the appliance or its maintenance, switch off the appliance and unplug the power supply cord from the electric socket. Do not use rough and aggressive detergents! Clean the drive unit with a soft and wet cloth with a little detergent. Make sure that water does not get inside the appliance. wash the other accessories right after use in hot water with a little detergent added, rinse them with clean water and wipe them till dry (you can also use a dishwasher – not for the blender D). The end with the thread of the blender D must not be immersed during cleaning. Work very carefully when cleaning the blender, the knife is very sharp! Make sure that the cutting edges of the blender do not come in touch with hard objects that blunt them and thus decrease their effectiveness. Some ingredients can color the accessories in some way. But this does not affect the function of the appliance and it is not a reason for a claim. This coloring usually disappears in some time. Never dry plastic moldings over a heat source (e.g. heater, stove, radiator). If the power cord becomes dirty, wipe it with a damp cloth.

Storing the appliance and accessories

• Store the drive unit and accessories at a dry, dust-free place, out of reach of children and legally incapacitated people.

ENVIRONMENTAL PROTECTION

If the dimensions allow, there are labels of materials used for the production of packing, components, and accessories as well as their recycling on all parts. The symbols specified on the product or in the accompanying documentation mean that the used electrical or electronic products must not be disposed of together with municipal waste. For proper disposal, hand them over at the special collection places where they will be accepted free of charge. Suitable disposal of the product can help to maintain valuable natural resources and to prevent possible negative impacts on the environment and human health, which could be the possible consequences of improper waste disposal.

Ask for more details at the local authorities or at a collection site. Fines can be imposed for improper disposal of this type of waste in agreement with the national regulations. If the appliance is to be put out of operation, after disconnecting it from the power supply we recommend its cutoff, and in this way, it will not be possible to use the appliance again. More extensive maintenance or maintenance requiring intervention in the inner parts of the appliance must be carried out by professional service! Failure to comply with the instructions of the manufacturer will lead to expiration of the right to guarantee repair!

TECHNICAL DATA

• Voltage (V): specified on the type label of the appliance
• Input (W):  specified on the type label of the appliance
• Weight of drive unit (kg) about: 1.0
• Size of the product (mm): 150 x 85 x 195
• Noise level: Acoustic noise level of 88 dB(A) re 1pW
• Input in off mode is < 0,50 W.

The manufacturer reserves the right to change the technical specifications and accessories for the respective models. The pictures are only illustrative, the supplied accessory and appliance may differ.

References

• AEG Hausgeräte | Setzen Sie auf Qualität | AEG
• ETA - tady je doma
• ETA - tu je doma

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>