ETA051790000 Stormy Bagless Vacuum Cleaner Instruction Manual

ETA051790000 Stormy Bagless Vacuum Cleaner

SAFETY WARNING

GENERAL PROVISIONS:

• Consider the instructions for use as a part of the appliance and pass them on to any other user of the appliance.
• This appliance may only be used by children aged 8 years or older, and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision. Children younger than 8 years must be kept out of reach of the appliance and its power cord.
• Before replacing accessories or any accessible parts, before assembly and disassembly, before cleaning or maintenance, when you let the appliance unattended or if you finish the work with the appliance, switch off the appliance and disconnect it from the mains by unplugging the power cord plug from electrical socket.
• To prevent injury, do not touch the rotating brush with your hands/fingers.
• The appliance is designated to be used indoor only.
• Never immerse the appliance in water (not even partially) and do not wash it under running water!
• When vacuuming certain types of carpets, upholstering fabric, etc., static electricity may be produced. No static electricity discharge is dangerous to health.
• Do not put fingers or other things to input and output vents of the appliance.
• In order to ensure safety and proper function of the appliance, use only original spare parts and accessories approved by the manufacturer.
• Only use this appliance for the purpose it was designed for, as specified in this manual.
• All texts in foreign languages and pictures shown on the packaging or the product itself, are translated and explained at the end of this language mutation.
• The manufacturer is not responsible for damage caused by improper use of the appliance and the accessories and its warranty for the appliance does not apply in situations when the safety warnings above are not complied with.

USE OF THE APPLIANCE:

• The product is only intended for home use and similar purposes (in shops, offices and similar workplaces, at hotels, motels and other residential environments, and in facilities providing bed and breakfast). It is not intended for commercial use!
• Avoid contact with the rotating brush when handling the vacuum cleaner (e.g. with loose clothes, hair, fingers, jewellery, bracelets etc.).
• When carrying, do not hold the vacuum cleaner using the handle of the dust container!
• The appliance must not be used in damp or wet environment and in any environment with the danger of fire or explosion.
• Remote control is ensured by signal transmission (after pressing a button) from the hose handle to the electronic system of the vacuum cleaner through radio waves.
• Do not use the appliance to vacuum water, liquids or aggressive fluids!
• Do not vacuum wet or moist floor coverings, and do not use the vacuum cleaner outdoor!
• Do not vacuum sharp objects (e.g. glass, shatter), hot, flammable, explosive items (e.g. ash, hot cigarette butts, gasoline, thinners and aerosol vapours) or greases (e.g. fats, oils), caustic agents (e.g. acids, solvents).
• Do not use the vacuum cleaner to vacuum dirt produced during/after construction such as plasterboard dust, fine sand, cement, dust from construction, parts of plaster etc.
• WARNING: There is a risk of injury in case of incorrect use (not in accordance with the manual) of the appliance.

ACCESSORIES AND ASSEMBLY OF THE APPLIANCE:

• Do not put the suction nozzle or the tube end or accessories close to eyes and ears and do not insert them into body orifices!
• Do not use the brush for treatment and cleaning animal hairs!
• Do not leave the floor nozzle with the rotation brush on in one place for too long! It could cause damage to the surface vacuumed!

BATTERIES:

• If you are not going to use the vacuum cleaner for a longer period of time, remove the batteries from the remote control.
• Should the batteries leak, remove them immediately. Otherwise they might damage the appliance.
• Do not mix old and new batteries together.
• Do not use rechargeable batteries.
• Do not use batteries of a different type.
• As soon as the batteries are flat, replace them with new ones.
• Dispose of a discharged battery in a suitable way (see par. VII. ENVIRONMENTAL)
• Keep batteries out of reach of children and incapacitated people. A person, who would swallow the batteries, must seek medical help immediately.
• Batteries not intended for this purpose must not be charged..
• The supply terminals must not be short-circuited.

POWER CORD:

• Check whether the data on the type label corresponds with the voltage in your socket. The power cord plug may only be connected to the electrical socket complying with the applicable standards.
• If the power cord of the appliance is corrupted, it has to be replaced by the manufacturer, its service technician or a similarly qualified person.
• Always disconnect the appliance from power by unplugging the power cord from the electrical socket, if the appliance is left unattended and before assembly, disassembly or cleaning.
• Never use the appliance if the power cord or power plug are damaged, if the appliance is not correctly operating or if it has fallen on the floor and been damaged, or if it has fallen into water.
• Do not apply force to unwind the cord beyond the red mark.
• Do not unplug the power plug by pulling the power cord or the vacuum cleaner unit.
• When winding the cord, hold the plug to prevent lashing of the cord around and to prevent possible injury.
• The power cord must not be damaged with sharp or hot objects, open fire, it must not be sunk into water or bent over sharp edges.
• Check the condition of the power cord of the appliance regularly.

EQUIPMENT AND ACCESSORIES

A – vacuum cleaner

1. A1 – ON/OFF ( ) button
2. A2 – power cord winding button
3. A3 – knob for suction power regulation
4. A4 – suction vent
5. A5 – handle
6. A6 – container lock button
7. A7 – depression for attachment of accessories A8 – power cord
8. A9 – rear wheels
9. A10 – exhaust grid
10. A11 – output HEPA filter

B – dust container

1. B1 – holder
2. B2 – cover lock button
3. B3 – cover
4. B4 – suction filter 1
5. B5 – suction filter 2
6. B6 – separator
7. B7 – foam micro-filter

C – accessories

1. C1a – floor nozzle
   • C1b – floor nozzle (2 vacuum cleaning modes)
2. C2 – small turbo brush
3. C3 – turbo brush
4. C4a – parquet nozzle
   • C4b – parquet nozzle (PREMIUM CARE 360°)
5. C5 – nozzle for vacuuming of animal hair C6 – upholstery nozzle
6. C7 – brush
7. C8 – crevice nozzle
8. C9 – long crevice nozzle
9. C10 – suction hose
10. C11 – telescopic suction tube
11. C12 – telescopic suction tube locking C13 – mechanical suction power regulator

D – control panel (ETA4517)

1. D1 – ON/OFF ( ) button
2. D2 – “+” button for suction power setting
3. D3 – “-” button for suction power setting
4. D4 – LED light panel

E – handle with remote control

1. E1 – ON/OFF ( ) button
2. E2 – “+” button for suction power setting
3. E3 – “-” button for suction power setting
4. E4 – squeeze signal lights
5. E5 – battery compartment cover
6. E6 – battery compartment

VACUUM CLEANER PREPARATION

• Remove all packing material, take out the vacuum cleaner and the accessories.
• Remove all possible adhesion foils, stick-on labels or paper from the appliance.

VACUUM CLEANER ASSEMBLY
When assembling the vacuum cleaner, follow the procedure indicated in
Choose appropriate accessories as required). The telescopic suction tube C11 can be set to an optimum length to suit the user´s height.

USE OF VACUUM CLEANER

Before use, unwind (by pulling) the power cable A8 from the vacuum cleaner to a required length and plug the vacuum cleaner to the mains.
CONTROL (ETA0517, ETA1517, ETA2517)

• A1 button
  • vacuum cleaner ON/OFF switch
• A2 button
  • when pressed and held, the unwound part of the power cable rewinds back inside
• Knob A3
  • by turning it to the right, you increase the suction power
  • by turning it to the left, you reduce the suction power

CONTROL (ETA4517)
Control panel D + handle with remote control E

• D1 button
  • vacuum cleaner ON/OFF switch
• E1 button
  • vacuum cleaner ON/OFF switch (the button only works in standby mode)
• D2/E2 button
  • when pressed, the suction power increases
• D3/E3 button
  • when pressed, the suction power decreases
• A2 button
  • when pressed and held, the unwound part of the power cable rewinds back inside

Notes

• Adjust the suction power as you feel it necessary based on the surface being cleaned.
• Before you use the remote control, fit 2 pcs of AAA batteries in it (Fig. 6). Batteries are included in the box.
• If you wish to use the remote control, you must switch ON the vacuum cleaner first by pressing the button A1.
• With the remote control you can switch the vacuum cleaner ON or OFF and regulate the suction power. The light indicator E4 comes on every time the remote control transmits a signal (when a button is pressed).

REMOVING THE DUST CONTAINER AND FILTERS

Caution

• Maximum suction performance can be achieved when the filters are clean and the dustbag is empty.
• Every time you empty the dust container, we recommend that you also clean the filters.
• When you are vacuuming very fine dust, the filter pores might get clogged. This reduces the air flow and the suction performance deteriorates. In such a case, the filters need to be cleaned even though the container is not full yet.

DUST CONTAINER REMOVAL
When taking out the dust container B follow the procedure indicated in Fig. 4. Dispose of dirt contained in the dust container with regular household waste. An emptied and cleaned container is to be put back into the vacuum cleaner in reverse order.
INPUT FILTER REPLACEMENT
To remove the input filter, follow the procedure indicated in Fig. 4. To fit a new input filter in the vacuum cleaner, proceed in reverse order.
OUTPUT FILTER REPLACEMENT
To remove the input filter, follow the procedure indicated in Fig. 3. To fit a new output filter in the vacuum cleaner, proceed in reverse order.

CLEANING AND MAINTENANCE

Treat surface of the appliance with a soft and damp cloth, do not use coarse and aggressive detergents!

Accessories
After any vacuuming it is recommended to check visually the brushes or collectors for possible impurities. If there are some impurities, remove them.

Cleaning the TURBO nozzle C3 (Fig. 8)
Cut the threads and hairs with scissors. Turn on the vacuum cleaner. The cleaner vacuums the cut hairs and threads. In case hairs or threads got tangled up around the attachment of the brush cylinder and cannot be removed with the above-mentioned steps, it is necessary to remove them with a suitable tool (e.g. tweezers). For simpler and more comfortable maintenance, remove the upper cover by releasing the locking latches on the sides. At the same time, make sure no dirt is stuck on the inner side of the nozzle (i.e. turbine). Release the two arrest latches on the bottom side of the nozzle in the direction of the arrow and remove the cover. Clean the space with a suitable tool (e.g. tweezers). Insert the covers back into the nozzle reversely and close it with by folding it up (you hear an audible click).

Dust container
Clean the dust container with a wet cloth. Allow all the parts to dry out properly before re-use.

Input and output filters
Rinse the filter B4, B5, B7 under running water. Allow them to dry out properly before their re-use. Shake out the HEPA filter A11 gently, or blow it out. If the HEPA filter is very dirty, you can rinse it under running lukewarm water. Allow it to dry out properly.

Caution

• Do not clean the HEPA filter or the other filters with any aggressive washing or cleaning detergents or hot water.
• In order to maintain the filtering parameters of the HEPA filter, we recommend that you use a dry method of cleaning.
• If you clean the HEPA filter with water, its filtration properties will deteriorate. The filter cannot be washed more than three times. After that, a new filter needs to be purchased.
• If the filters are not cleaned or replaced, it might result in damaging the vacuum cleaner!

Other parts
Clean the telescopic suction tube C11 and suction hose C10 with a wet cloth. Allow all the parts to dry out properly before re-use.

ENVIRONMENTAL PROTECTION

If the dimensions allow, there are labels of materials used for production of packing, components and accessories as well as their recycling on all parts. The symbols specified on the product or in the accompanying documentation mean that the used electrical or electronic products must not be disposed of together with municipal waste. For proper disposal of the product, hand it over at special collection places where it will be taken over free of charge. Suitable disposal of the product can help to maintain valuable natural resources and to prevent possible negative impacts on the environment and human health, which could be the possible consequences of improper waste disposal. Ask for more details at the local authority or at the local waste collection site. Fines can be imposed for improper disposal of this type of waste in agreement with the national regulations. If the appliance is to be put out of operation, we recommend its cutoff after disconnecting it from power supply and in this way it will not be possible to use the appliance again. Remove a discharged battery and dispose of it in a suitable and safe way through the special collection networks. Never dispose of the battery by burning!

TECHNICAL DATA

References

• eta.de
• ETA Magyarország – ETA HUNGARY
• AEG Hausgeräte | Setzen Sie auf Qualität | AEG
• eta-polska.pl
• ETA - tady je doma
• ETA - tu je doma

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>