CASAINC CS-VC109 Handheld Vacuum Cleaner Instruction Manual

: June 5, 2024
: CASAINC

Table of Contents

Product Introduction
Product Operation
Maintenance
TROUBLESHOOTING
Safety Introduction
Product Parameters
Read User Manual Online (PDF format)
Download This Manual (PDF format)

CS-VC109 Handheld Vacuum Cleaner
Instruction Manual
MM CASA INC
CS-VC109

Product Introduction

Main Body
TYPE-C charge cable
2 in 1 flat sucker
Hose suction nozzle
Blowing nozzle

Tips: When cleaning dust, accessories 3,4 can be installed on 1
Tips: When blowing dust, accessories 5 can be installed on 1

Product Operation

Charging
If the battery is not charged at the factory, be sure to fully charge the battery before use.

Place the main body on a horizontal countertop please place the end of the lanyard on the tabletop
Connect the USB cable with the charging port on the main body to start charging, and the power indicator flashes, after full charge, the indicator light is always on.
Charging time: 3.5 hours. Using time: high speed 12 min, low-speed 25mins.

Attention

Do not charge at temperatures below 5 or above 40
When the product is low in power during operation, the power indicator light will flash

Cleaning
To prevent blockage of the air passage, large objects like large paper and packing materials should be removed from the area before starting a cleaning

Press the start button to start cleaning, the power indicator light will always be on.
Press again the start button to stop cleaning, and the power indicator light will off.
Press the speed control button to choose high or low speed when the machine is working.
When the machine is working, the battery indicator is always on. When the battery indicator is flashing, please pay attention to timely charging.

Replacing Accessories
A: replacing 2 in 1 Flat Brush
Insert the flat tube into the suction port in the direction shown in the figure (the larger step of the flat tube faces upward). When you need to use the brush, turn the brush in the direction as shown in the figure, and it can be used when it is turned horizontally.
B: Replace hose nozzle
Insert the flat tube into the suction port in the direction shown in the figure (the larger step of the flat tube faces upward).
C: Replace the blowing nozzle
According to the direction shown in the figure, but the lanyard into the blowing nozzle or remove the lanyard, and put the blowing nozzle on the air outlet.
Replacing battery
Tips: If you need to replace the battery please consult your dealer. The battery is consumable. If the battery life becomes shorter and the charging time becomes longer, please replace the battery pack.
Indicator light description
A. Press the start button, the machine starts working, the power indicator light on, it is low speed now, press the speed control button to change speed.
B. The power indicator lights are flashing when charging, and the power indicator lights will all be on after fully charged; the power indicator light will always be on when fully charged, when the power indicator flash, means low power, please pay attention to charging timely .
C. When the abnormal warning indicator light is on, please clean the machine immediately; It is recommended to clean the machine after each use.

Warning:

The machine must be turned off during charging;
Do not use and store batteries at temperatures below 5or above 40;
When disposing of this product, remove the battery from the device;
Do not modify the device, accessories or replace the power cord or battery;
Battery ModelDYDC-L04 11.1V

Battery recycling:
Waste batteries are important resources. When disposing of the product, do not dispose of the battery at will. Please treat properly in accordance with government regulations to facilitate the recovery to the corresponding waste battery recycling facilities.

Maintenance

Press the dust cup button, the suction mouth will open automatically, and the garbage will be poured out
Put the suction mouth back on
Unscrew the dust cup clockwise (the “O” on the main body is aligned with the “ **** ” on the dust cup), then, take out the dust cup downward
Remove the HEPA filter assembly from the dust cup
Turn counterclockwise and take out the filter, separating the HEPA from the filter
Clean the dust cup, HEPA and filter screen with a brush or paper towel. If necessary, clean with water directly
Remove the back cover by turning it counterclockwise
Remove the outlet air filter cotton and clean it up outlet air filter cotton
After the parts are fully dried, they can be put back according to the disassembly procedure tips It is recommended to carry out the above cleaning work after the dust is dumped each time.

Attention

Please pay attention to sharp objects such as glass to prevent injury.
The parts must be completely dry before installation.
Do not scrub the filter cotton or apply brute force to it
Please make sure that the filter cotton has been installed before assembly.
Do not continue to use when the filter cotton in the dust cup is damaged or if the cleaning and maintenance are not sufficient.

TROUBLESHOOTING

In case of malfunction, please refer to the following table

Problem	Possible reason	Solution

Running time
becomes shorter| The ambient temperature is too high or too low
The battery isn’t fully charged| Use inappropriate environment Please charge the battery
Suction power
becomes weak| Too much dust in the cup
The cotton filter is blocked
The brush or accessory suction port is blocked
Hasn’t been fully dried after washing| Clean in time
Wash the cotton filter
Clear the blockage
Dry the part in a cool place after washing
Can’t charge| The ambient temperature is too high or too low| Charge inappropriate environment ( 5 t -40 t )
Battery leakage| The battery has not been used for a long time| replace battery

*For other malfunctions that cannot be handled, please contact the local after-sales service outlets or call the national service hotline.

Safety Introduction

Only the certified technician may disassemble this product, Users are strictly not allowed to disassemble this product.
This product shall only be charged using the included power adapter, Other power adapters may cause damage to this product.
Do not touch the power cord, plug, or adapter with wet hands.
Avoid curtains, any kind of strings or user/s body part wrapping up on the wheel.
Keep this product away from cigarette stubs, lighters or flame.
To clean the product , this product must be fully charged before any cleaning process.
Do not over-bend the power cord, or place heavy or sharp objects on this product.
This product is intended for indoor use only, do not use this product outdoors.
Do not place objects (e.g. humans) with more than 10KG weight on this product.
Do not use this product in a wet or moist environment(e.g. bathroom).
Before using this product, please remove any fragile objects(e.g. glasses, lamps, etc)from the floor. Also removes any objects that may be wrapped up to the side brushes or may block the suction inlet.
Do not put this product in the position where is east to fall off.
While delivering or if for not using the product for a long time, please turn it off from the bottom.
Before charging, please check whether the power adapter and socket is connected well.
When this product is cleaning the room, please inform other members to avoid causing them to fall.
When the dust bin is full of dust, empty the dust bin before using this product.
This product is functioning at a temperature range of 5℃ to 40 ℃.
Do not use this product in a high-temperature environment.
Please remove batteries from this product before disposal.