Yfw Technology YFWC003 3-In-1 Charging Stand Instruction Manual
- June 5, 2024
- YFW Technology
Table of Contents
Technology YFWC003 3-In-1 Charging Stand
Instruction Manual
Please read the instructions carefully first,in order to install the product correctly for quick use.
Product Introduction:
- Apple Watch Charging stand
- Anti-slip Mat
- AirPods Charger
- Mobile phone Charger
- Mobile phone backrest
- Apple Watch Charger
- Mobile phone baffle
All parts charging mode
iWatch charger assemble
Mobile phone backrest adjustment
Specifications
Product Name: 3 in 1 Charging Stand
Product Material: Plastic. PCB, Rubber, iron block
Input: 9V 2A/9V 3A(Max)
Output: 5V 2A for iPhone/5V 1A for iWatch/5V 1A for AirPods
Frequency: 329.8Khz
Power Interface: Type C
Product Dimension: 180.9-100’113mm
Charging Cable: lm USB Type-C cable
NOTE:
Do not use Apple’s 5v/1A stock charger or a computer’s USB port to power your
charger. quick charge 3.0 wall adapter required for fast charge mode
FCC ID: 2AY3K-YFWC003
Declaration of Conformity
Hereby, Shenzhen Yongfengwang Technology Co., Ltd. declares that the product
type 3 in 1 Wireless Charger is in compliance with the following Directives:
Radio Equipment Regulations 2017, Electrical Equipment (Safety) Regulations
2016, and The Restriction of the Use of Certain Hazardous Substances in
Electrical and Electronic Equipment Regulations 2012. The full text of the UK
declaration of conformity is available at the following internet address:
https://Nwiw.hkIdc.cn/
RF exposure statement:
This device was tested for uncontrolled environment operations. To comply with
RF exposure requirements, a minimum separation distance of 20cm must be
maintained between the user’s body and the product.
Radiated H-field: -23.59dBpNm@lOm
FCC Warning statement:
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received.
including interference that may cause undesired operation.Changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
Note:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates. uses and can radiate radio
frequency energy and. if not installed and used in accordance with the
instructions. may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception. which can be determined by turning the equipment off and
on. the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC RF exposure statement:
This equipment complies with FCC Radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
a minimum distance of 20cm between the product and your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>