eta 2320 90000 PERFECT CARE Hair Dryer Instruction Manual

eta 2320 90000 PERFECT CARE Hair Dryer

Instructions For use

Dear customer, thank you for purchasing our product. Keep these instructions including the warranty, the receipt and, if possible, the box with the internal packing.

SAFETY WARNING

• Before the first use, read the instructions for use carefully, look at the picture and keep the instructions for use.
•  Check whether the data on the type label correspond with the voltage in your socket.
• Never use the appliance if its power cord or plug is damaged, if it does not work properly, if it fell down and was damaged or if it fell into water. In this case, take the appliance to a special service to check its safety and proper function.
• This product can be used by children at the age of 8 years and older and people with reduced physical or mental abilities or lack of experience and knowledge if they are supervised or if they were instructed regarding use of the appliance in a safe way and if they understand possible risks. Children must not play with the appliance. User cleaning and maintenance must not be performed by children if they are younger than 8 year and unsupervised. Children younger than 8 years must be kept out of reach of the appliance and its power cord.
• The dryer must not be sunk in water and it must not be let at places where it could fall into a bath tub or a wash basin. If the dryer fell to water, do not take it out! First of all unplug the power cord from the socket and only then take out the dryer. In this case take the appliance to a specialized service shop to check its safety and proper function.
• If the hair dryer is used in a bathroom, it has to be disconnected from the electric power by unplugging the power cord from the socket because there is risk close to water even if the hair dryer is off.
• For additional protection we recommend installation of current protection (RCD) with the nominal release current not exceeding 30 mA. Ask a control technician or an electrician for advice.
• If the power cord of the appliance is corrupted, it has to be replaced by the producer, its service technician or a similarly qualified person so as to prevent dangerous situations.
• Before replacing accessories or accessible parts, before cleaning or maintenance, turn off the appliance and disconnect it from the mains by pulling the power cord from the power socket!
• Always unplug the appliance from power supply if you leave it unattended.
• The appliance is intended for use in households only and for similar use! It is not designed for use in hair salons or for similar commercial use!
• Do not use the appliance close to water contained e. g. in containers, sinks, bath tubs, swimming pools, etc.
• Do not plug or unplug the appliance from a socket with wet hands and do not pull the power cord!
• Do not let the appliance in operation without supervision!
• Do not put the dryer on hot heat sources (e. g. oven, stove, radiator, etc.)
• Any part of the appliance must not get in contact with places sensitive to heat (e. g. eyes, ears, neck, etc.).
• Be very careful when handling the adapter during drying (it is hot).
• The power cord must not be damaged with sharp or hot objects, open fire and it must no be sunk into water or bent over sharp edges.
• Make sure that the power cord does not hang over the edge of the working table where children could reach it.
• If the dryer was stored at lower temperatures, acclimatize it first, by which you remove stiffness of the lubricating fat in bearings and mechanical resistance of the plastic parts will be kept.
• Holes for air ventilation must not be covered. Also, do not put the dryer in the “on” position on soft surfaces (e. g. bed, towels, sheets, carpet), the duct could get covered. Penetration of dust, hair, threads, etc. to the duct has to be prevented.
• It is not permissible to adjust the surface of the extra attachment (e.g. self-adhesive paper, foils, etc.)!
• Do not insert accessories into any body cavities.
• When the appliance is switched on for the first time, short and slight smoke can come out that does not mean any defect and it is not a reason for claiming a defect of the appliance.
• When the appliance is overheated, the automatic heat fuse is activated and it socket. Remove possible visible obstacles preventing air flow and let the appliance cool down.
• Disconnect the appliance from power supply right after use by unplugging the power cord from the socket and let it cool down before storage.
•  Do not wind the power cord around the appliance, this will extend life of the power
• Never use the appliance for any other purpose than for the intended purpose described in these instructions for use!
• The producer does not guarantee any loss caused by improper handling of the appliance and its accessories (e. g. electrical accident, fire, burn, hair damage) and its guarantee for the appliance does not apply in the case of  instructions above

DESCRIPTION OF THE APPLIANCE AND ITS ACCESSORIES

• A – hair dryer

  • A1 – temperature and air flow intensity regulator position 0 – off
    position I – medium temperature and air flow intensity
    position II – medium temperature and maximum air flow intensity
    position III – maximum temperature and air flow intensity

  • A2 – handle

  • A3 – hanging loop

  • A4 – power cord

  • A5 – joint (for tilting the handle when the dryer is transported or stored)

  • A6 – button (by pressing and holding the button, heating of the outgoing air is interrupted and thus the air temperature is reduced, which enables quick cooling and fixation of hair in the final hair styling)

• B – concentrator (used for concentrating air to the specific place)

• C – case

Instructions For use

Remove all packing material and take out the dryer with its accessories. Remove all possible adhesion foils, stick-on labels or paper from the appliance. Lift off the handle A2 to the operating position so that its arrest is ensured. Plug the power cord A4 to a socket. Put the adapter B on the dryer.
Hair drying
For quick hair drying, turn the switch A1 to the position of the maximum temperature and the maximum air flow. For drying short hair or for finishing hair drying, set the switch to the lower positions. Direct the outgoing air to hair while keeping the dryer handle in the distance of 10 to 15 cm from the head and move it evenly. In drying with hot air flow, take out excessive humidity from hair using a brush or fingers. If you have long hair, bend your head so that the hair falls down freely from the scalp and face. After you have finished drying, cool down the dryer by turning the A2 switch to the cool air position and then turn the A1 switch to the 0 position.

MAINTENANCE

Turn off the appliance before each maintenance, unplug the power cord from the power supply and let it cool down! Wipe the dryer surface with a wet soft cloth. Remove possible impurities from the grid (e.g. using a brush). Cleaning dust and impurities settled inside the hair dryer can be made by their vacuuming or blowing out. Do not use rough and aggressive detergents! Maintenance only includes mechanical cleaning.

ENVIRONMENT

Printed signs of materials used for manufacture, packing, components and accessories, as well as their recycling, are on all the pieces if their dimensions enable it. The symbols on the product or in the accompanying documentation mean that the used electric or electronic products must not be disposed together with municipal wastes. Please, hand them over to the collection points designed for their correct disposal, where they will be accepted free of charge. By correct disposal of this product you can help to preserve valuable natural resources and help to prevent possible negative impacts to the environment and to human health, which could be the results of incorrect waste disposal. For further details ask the municipal authorities or the nearest collecting point. Penalties can be charged for incorrect disposal of such wastes, according to national regulations. If the appliance is to be put out of operation definitely, we recommend cutting off the feeder cable, to disable its use. Expert service must do the large maintenance or to intervene into inside parts of the appliance! Non-observance of the instructions of the manufacturer cancels the right for guarantee repair!

TECHNICAL DATA

• Voltage (V) given on type label
• Absorbed power (W) given on type label
• Weight (kg) approximately 0,4
• Protection class of the appliance II.
• Size of the product (cm) 19 x 8 x 25
• The product has received ES declaration of conformity according to Act as amended.
• The product matches the requirements of the below statutory order as amended.
• Committee Regulation No. 2006/95/ES as amended, setting the technical requirements of the electrical appliance as low.
• Committee Regulation No. 2004/108/ES as amended, setting the technical requirements of products in terms of their electromagnetic compatibility

The manufacturer reserves the right to make insignificant changes to the standard design that do not affect the function.
DO NOT IMMERSE IN WATER OR OTHER LIQUID TO AVOID DANGER OF SUFFOCATION, KEEP THIS PLASTIC BAG AWAY FROM BABIES AND CHILDREN. DO NOT USE THIS BAG IN CRIBS, BEDS, CARRIAGES OR PLAYPENS. THIS BAG IS NOT A TOY.

References

• Úvod | ELEKTROWIN, a.s.
• Úvod - Envidom
• ETA - tady je doma
• ETA - tu je doma

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>