SAVAGE 62037 Port-A-Stand and Vinyl Background Kit User Manual

June 5, 2024
SAVAGE

SAVAGE 62037 Port-A-Stand and Vinyl Background Kit

SAVAGE-62037-Port-A
-Stand-and-Vinyl-Background-Kit-product

SETUP

SAVAGE-62037-Port-A-Stand-and-Vinyl-Background-Kit-
fig-1
SAVAGE-62037-Port-A-Stand-and-Vinyl-Background-Kit-
fig-2

  1. Loosen handle located at top of legs on the upright stand (A).
  2. While grasping upright (A) center column, and stand leg, extend stand legs outwards.
  3. Continue extending legs until horizontal supports are parallel to the ground. Tighten handle. Repeat steps 2-3 with the second upright (B).
  4. Extend crossbar (C) by grasping on either side of telescopic sections and twisting in opposite directions until the desired width is achieved. Lock in place by twisting in another direction.
  5. Position uprights (A,B) desired width apart (slightly wider than backdrop width).
  6. Completely loosen small handles off both ends of crossbar, in order to place crossbar (C) end collar over upright (A) top stud. Tighten the handle to secure it.
  7. Slide backdrop core onto crossbar (C) until crossbar extends through the opposite side.
  8. Place remaining crossbar (C) end collar over upright (B) top stud. Tighten the handle to secure it.
  9. Starting with the uppermost collar, extend uprights (A, B) to the desired height.
  10. Repeat step 8 on the opposite upright, ensuring crossbar (C) is level and secure. It may be necessary to raise uprights in smaller increments on each side, back and forth to extend it smoothly.
  11. Carefully sweep/drape out your backdrop until it reaches the desired length.
    Your Port-A-Stand is now ready for use.

PRECAUTIONS

  • The maximum weight limit is 25 lbs. (11.34kg)
  • It is best practice to use a sandbag around the base of each upright for added stability

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals