MXN81C Auto Heated Infra Red Color Camera Instruction Manual

MXN81C Auto Heated Infra Red Color Camera

Contents

Features

• Best picture quality (in combination with a Digital LCD monitor)
• High-resolution CMOS camera (1.23Mega pixels)
• 1/3.2″ Color CMOS high-resolution Image sensor
• IP69K Waterproof Rating
• Diagonal 130″ Viewing
• Normal/Mirror Image switching
• Ultra low light performance
• Automatic Electronic Iris
• Built-in Microphone
• Built-in IR LED’s
• Built-in Automatic Heater (below +10″C)
• Temp. -40″C – S0″C
• Vibration resistant
• Waterproof screw type connector (IP67), 4-pin mini-DIN.
• E-mark.

Technical Specifications

• Image Sensor
  • 1/3.2″ Color SONY CMOS(Exmor)
• Scanning System
  • PAL, 1.23Mega pixels(1280×960 )
•  Resolution
  • 750 TV Lines
• S/N ratio
  • Minimum 45dB (at AGC off)
• Minimum Illumination
  • 0 lux (IR LED’s on)
• Power supply
  • DC 9-48V
• Power Consumption
  • DC 12V, 220mA(Heater on)
  • DC 12V, 132mA(Heater off)
• Operating Temperature
  • -40·c to +80·c
• Field of View angle
  • 130″ (Diagonal), 102.2″ (Horizontal ), 72.8″ (Vertical)
• Dimensions
  • 95.9(W) x 43(H ) x 62 .8(0) mm
  • 109.2(W) x 85.5(H) x B0(D ) mm (incl.bracket & sunvisor )
• Weight
  • 326 g (total weight incl. bracket & Sunvisor: 464 g)

Front View

Rear View

Installation

CAMERA ASSEMBLY

1. Fix the supplied mounting bracket to the vehicle.
2. Fix the bracket with camera and sun-shield according to the drawing.
3. Adjust the vlewln9_!!’_gle of the came!• and fasten the screws firmly.

Cable grommet

Drill a suitable hole (approx. 9 19mm) and insert the cable grommet.
Just before final fixation, please apply a proper sealant (for prevention) between the hole and the grommet and also between the cable and the grommet.

Securing cable connection

1. Match the arrow marks and press the connectors together. 
2. Screw the camera connector up clockwise. 
3. Tighten cable connection firmly In order to prevent water Ingress.
   Note! The -warranty will not be valid if the problem Is related to moist and corrosion in -the connector.

Wiring to Monitor

Run the cable from the camera to the monitor.

Caution

1. Before making the connection, disconnect the ground. terminal from the battery to avoid short circuits.

2. The plugs should be fully inserted Into the connectors or jacks.
   A loose connection may cause malfunctioning of the unit.

3. A damaged cable may affect the operation of the camera and may even cause a malfunction of the camera or monitor: Avoid a damaged cable!

4. Protect the cable by using a guide tube, or pipe or run the cable inside the vehicle as much as possible. Caution! Run the cable In natural shapes In order to prevent cable breaks.

5. Preferably use an acid-free grease in between the waterproof screw type connectors and tighten them firmly each other.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>