NETGEAR RBK752 Wi-Fi 6 Router Tri-Band Mesh WiFi System User Manual
- June 5, 2024
- NETGEAR
Table of Contents
NETGEAR RBK752 Wi-Fi 6 Router Tri-Band Mesh WiFi System User Manual
What’s in the box?
-
1x NETGEAR Orbi Wi-Fi 6 router
-
1x Power adapter
-
1x Ethernet cable
Download the Orbi app
Connect your Orbi router
-
Connect the Ethernet cable to your Orbi’s Internet port, then connect the other end to the port labelled LAN1 or GE1 on your Optical Network Terminal – that’s the fibre box usually found on your wall.
-
Connect the power adapter and turn your Orbi on at the wall.
Got extra Orbi satellites? Find a place to plug them in now, or you can set them up later. Orbi satellites must be within range of your Orbi router’s Wi- Fi signal, so don’t place them too far apart from each other.
If you have a landline, connect it to the port labelled POTS or TEL on your Optical Network Terminal.
Connect to your Orbi Wi-Fi network
- Go to the Wi-Fi settings on your mobile device.
- Connect to your Orbi Wi-Fi network. You’ll find the Wi-Fi network name and password printed on the front of your Orbi router.
It may take a few minutes for your network to appear after plugging in your Orbi.
Open the Orbi app and follow the setup instructions
Important: Skip the steps instructing you to disconnect and reconnect your ISP modem. These steps don’t apply – just select ‘Continue’.
That’s it, your Orbi router is up and running!
Customer Sercvice
For NETGEAR’s Privacy Policy, visit www.netgear.com/about/privacy- policy. By using this device, you are agreeing to NETGEAR’s Terms and Conditions at www.netgear.com/about /terms-and-conditions. If you do not agree, contact Slingshot at www.slingshot.co.nz/contact to return your device.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>