PULSAR DuploH2O Thick Oil Vaporizer User Manual
- June 5, 2024
- Pulsar
Table of Contents
DuploH2O Thick Oil Vaporizer
**User Manual
**
CHARGING THE DEVICE
Plug in the USB-C charging cable provided into the DuploCart H2O vaporizer and
attach it to a 5V 1 A charging brick. Do not let the vaporizer hang while
charging as it could damage the charging Port.
The LED strip will appear solid RED when charging, BLUE when the device is at
medium power, and turn solid GREEN when fully charged.
The device will fully charge in approximately 35-40 minutes.
HOW TO LOAD:
Remove the magnetic bottom Cartridge Magazine from the unit, and attach 1 or 2
cartridges to the device by screwing them into the 510 threaded connections
turning clockwise until fit is snug (DO NOT OVERTIGHTEN CARTRIDGES).
Re-Insert the Cartridge Magazine back into the bottom portion of the unit.
When inserted correctly, the indicator light will light up, signifying a
connection. When only one cart is inserted, only that side of the DuploCarts
indicator light will respond. (MAKE SURE THE MAGNETIC CONNECTION IS SOLID AND
THE MAGAZINE IS SEATED PROPERLY).
HOW TO OPERATE
Powering On – Click the POWER BUTTON 5 times to turn it on.
Battery Level Check – Before the device is turned on, you can click the
power button one time to view the device’s battery level. Green signifies a
full battery charge, Blue signifies a medium charge, and red signifies you
should charge your battery.
Variable Voltage Settings – After powering on, select your voltage
setting by pressing the power button 3 times. This action will cycle you
through the 4 different voltage settings. Choose your setting at this time.
Mouthpiece – The mouthpiece on the DuploCart H2O is easily removable and
swappable from the left or right side of the unit. Either side is
transferrable, depending on your preference.
Operating the Vaporizer – The DuploCart H2O is designed to use one or two
cartridges simultaneously or separately.
Single or Dual Cart Function – You can choose to load and operate only
one cartridge in the DuploCart H2O, or load two cartridges and operate each
independently.
To select which cartridge to operate, push the cartridge shift button. If you
have 2 cartridges inserted, this button will help you shift from one cartridge
to the other or operate both simultaneously. Follow the corresponding lighting
to that particular side of the DuploCart H2O. Both lights present indicate
both cartridges will operate simultaneously. If you only have 1 cartridge
inserted, then only that side will light up and be available for use.
Preheat Function – If cold ambient temperatures cause cartridge contents
to become more solid, the DuploCart H2O is equipped with a 15-second preheat
mode to make oils more viscous for a better vaping experience. Preheat is
recommended under these colder temperatures. To activate, make sure the device
is turned on and press the power button 2 times. The LED band will flash a
variety of colors for 15 seconds. When the flashing ends, your device is
primed and ready to go.
Start Vaping – Once your desired voltage and cartridge setting is
selected, then you are ready to start vaping.
Auto Draw Mode – The DuploCart H2O is enhanced with an auto-draw feature.
Simply pull from the mouthpiece to start vaping. No
button press is required. During auto draw mode, when successfully
implemented, you will see the lights on the light indicator light up when
drawing from the unit. Some oils may be too thick to operate in auto draw
mode. If you find this is true, please refer to button press mode.
Button Press Mode – Simply hold the unit to your lips and press the power
button to start vaping. The indicator lights will be present when the button
is pressed, and the color of the LED will signify your current voltage
setting.
H2O MODE-
- Pull open the Silicone Plug on the bottom of the unit.
- Screw in FULLY ASSEMBLED water pipe adapter (do not overtighten) for 19mm pipes.
- After inserted, you may unthread the OUTER adapter for use with 14mm pipes.
- Place unit onto water pipe (use appropriate configuration for 14mm or 19mm female fittings).
-
- Allow one preheat cycle to prime the cartridge(s).
- Select your preferred heating mode 7. Start your vaping session by pressing the power button and holding or pulling to activate the auto draw feature. The auto draw will activate automatically.
HOW TO CLEAN
- Unscrew cartridges from the bottom magazine.
- Wipe cartridge ports clean with 91% isopropyl alcohol using a dampened cotton-tip swab.
- Wipe any excess oil around the cartridge port and also from the bottom of the cartridges.
- Reassemble unit for use.
LIMITED WARRANTY:
Pulsars products are guaranteed from manufacturer defects or malfunction from
the original date of purchase for a period of 1 year. This limited warranty
protects against manufacturer defects under normal use and does not apply to
normal wear and tear, improper use, accidental damage from dropping or
submerging in liquid, improper cleaning, neglect, or any other damage that is
not a result of defective materials or workmanship. If your device qualifies,
we will replace, at our discretion and expense, any defective parts or
materials. Purchaser must provide a copy of the original dated sales receipt
and may be required to provide shipping to return defective parts or
materials. We intend to complete all replacements within 7 business days,
although this timeframe may vary depending on shipping, replacement part
availability, or other related factors. The lawful and proper use of this
device is a condition of sale. Any improper use of the device will void the
warranty. The warranty is non-transferable. This warranty gives you specific
legal rights, and you may also have other rights, which vary from state to
state.
Sometimes, water and oil DO mix. Get twice the power in your pocket with dual
cart technology.
DUAL AND SINGLE CART FUNCTION Carts do not include Ltd.
4-SETI1NG VARIABLE VOLTAGE WITH “SHIFT’ BUTTON & AUTO-DRAW
INCLUDED ADAPTER WORKS WITH 14MM & 19MM FEMALE FITTINGS
FOR USE WITH THICK OILS
FAST USB-C CHARGING
15-SECOND PRE-HEAT
VOLTAGE SETTINGS:
Green – 2.8V
Blue – 3.2V
Yellow- 3.7V
Red – 4.2V
TECH SPECS:
Height 99mm
Width 47.5mm
Thickness 20mm
Max Cartridge Diameter 11.5mm
Accepts 1.0m1 and 0.5m1 Cartridges
Battery Capacity 650 mAh
15 Minute Auto-Shutoff
Input 5V 1A
PulsarVaporizers.com
#EnjoyHigherCulture
PU-0356-21
Documents / Resources
|
PULSAR DuploH2O Thick Oil
Vaporizer
[pdf] User Manual
DuploH2O, Thick Oil Vaporizer, Oil Vaporizer, DuploH2O, Vaporizer
---|---