American International GMK461 Mounting Kit User Manual
- June 5, 2024
- American International
Table of Contents
American International GMK461 Mounting Kit User Manual
DASH DISASSEMBLY INSTRUCTIONS
- Using a soft tool Unsnap the panel above the steering column, then unsnap and remove the panel around the instrument cluster.
- From the area now exposed around the instrument cluster remove (1) 9/32” screw, then unsnap and remove the panel that extends from the instrument cluster to below the radio/climate controls and across the passenger side dash .
- From the area now exposed below the radio/climate controls remove (4) 9/32” screws , then unsnap and remove the panel, unplugging ant harnesses.
- From the area now exposed behind the climate control panel, remove (2) 9/32” screws. Unsnap and remove the radio, unplug any harnesses.
- Remove (3) top clips from the radio. Save for kit installation.
NOTE: For models equipped with OnStar: You will need to relocate the
module(s) somewhere not affecting the radio installation.
NOTE: The Sub Dash will need to be modified/trimmed to fit the radio
chassis to allow room for the aftermarket radio.
KIT ASSEMBLY INSTRUCTIONS
Single ISO Mount Application
- Install the (3) clips removed from the factory radio onto the 3 top post of the GMK461 INNER FRAME.
- Insert pocket into lower section of the brackets.
- Insert ISO mountable radio between ISO mount brackets and loosely attach to sides of the radio using screws provided with radio when possible, or screws supplied with kit.
- Using the OUTER FRAME of the GMK461 as a guide, slide radio forward or backward for desired look and then tighten screws to the radio.
- Slide the radio with pocket and brackets into the GMK461 INNER FRAME
- Insert the GMK461 OUTER FRAME over the radio/pocket.
- Using the (6) screws provided, Install the OUTER FRAME to the rear of the INNER FRAME and radio brackets.
VEHICLE APPLICATION
Chevrolet
2018-19 Equinox
NOTE: The Sub Dash will need to be modified/trimmed to fit the radio chassis to allow room for the aftermarket radio.
DOUBLE DIN INSTALLATION INSTRUCTIONS
Double DIN ISO Mount Application
See Fig B for bracket tab removal.
- Install the (3) clips removed from the factory radio onto the 3 top post of the GMK461 INNER FRAME.
- Remove pocket support tabs from both brackets.
- Insert ISO mountable radio between ISO mount brackets and loosely attach to sides of the radio using screws provided with radio when possible, or screws supplied with kit.
- Using the OUTER FRAME of the GMK461 as a guide, slide radio forward or backward for desired look and then tighten screws to the radio.
- Slide the radio and brackets into the GMK461 INNER FRAME
- Insert the GMK461 OUTER FRAME over the radio.
- Using the (6) screws provided, Install the OUTER FRAME to the rear of the INNER FRAME and radio brackets.
www.aampglobal.com
www.aius.net
2500 East Francis Street Ontario, CA 91761, U.S.A.
Sales: 800-477-2267
Intl: 727-572-9255
Support: 888-228-5560
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>