RYOBI ACSN02 SKID SHOE REPLACEMENTS User Manual
- June 5, 2024
- RYOBI
Table of Contents
SKID SHOE REPLACEMENTS ACSN02
ACSN02 SKID SHOE REPLACEMENTS
FOR USE WITH RY40807 RYOBI SNOW BLOWER ONLY
**WARNING:**
To reduce the risk of injury, users must read and understand the operator’s
manual for their snow blower and this instruction sheet. Always wear eye
protection with side shields marked to comply with ANSI Z87.1. Ensure
compatibility and fit before using this accessory. Do not use this accessory
if a part is damaged or missing. If you are not comfortable performing any of
the functions described in these instructions, take your unit to a qualified
service center.
WARNING:
Before performing any maintenance, make sure the snow blower battery is
removed to avoid accidental starting and possible serious personal injury.
INSTALLING THE SKID SHOES TO THE BUCKET
See Figure 1.
The skid shoes adjust the height of the scraper from the ground. Before use,
be sure to install the skid shoes onto both sides of the bucket.
- Install two bolts through the holes on the inside of the bucket.
- Align the skid shoes and place them onto the bolts as shown.
- Install a washer and nut onto each bolt and finger tighten.
- Position the skid shoe so it extends slightly below the bottom edge of the bucket. Once in position, securely tighten the nuts.
- Repeat for the other side.
NOTE: Position the skid shoes equally to ensure the scraper is level and approximately 1/2 in. above the ground. See Adjusting/Replacing the Scraper in Maintenance in the operator’s manual.
A – Skid shoe (patin de glissement, zapata de deslizamiento)
B – Bolt (boulon, perno)
C – Washer (rondelle, arandela)
D – Nut (écrou, tuerca)
TTI OUTDOOR POWER EQUIPMENT, INC.
P.O. Box 1288, Anderson, SC 29622 •
1-800-525-2579
www.ryobitools.com
998000921
1-7-22 (REV:01)
Documents / Resources
|
RYOBI ACSN02 SKID SHOE
REPLACEMENTS
[pdf] User Manual
ACSN02, SKID SHOE REPLACEMENTS, SKID SHOE, SHOE REPLACEMENTS
---|---