Breville Express Impress Espresso Machine Instruction Manual
- May 15, 2024
- Breville
Table of Contents
Wheel Set
Installation Instructions for the Barista Express Impress
Express Impress Espresso Machine
IMPORTANT:
Disconnect your machine from its power source and allow the machine to cool
completely before moving forward with your installation.
STEP1
Remove the drip tray, accessory tray and water tank from your machine.
STEP 2
Gently rest your machine onits side, providing access to the bottom of the
machine.
To protect the machine, and to catch residual water from the water tank’s
inlet, lay a towel on your workstation before tipping the machine.
TIP: Instead of laying the machine on its side, You can also access the
bottom of the machine by (carefully) hanging one side of the machine over the
edge of a countertop. and working from the floor, one side of the machine
atatime.
STEP 3
Using a Philips screwdriver, remove the existing rubber feet from the back
corners of the machine.
Replace with the matching wheel assembly and secure with the factory screws.
CAUTION: Do not over tighten screws.
STEP 4
Remove the factory front foot by removing the two screws holding it n place.
Find the matching Crema foot and separate the rubber insert from the foot’s
base by pulling the two pieces apart.
Attach the base of the Crema foot using the factory screws.
CAUTION: Do not over tighten screws.
Align the plugs on the rubber insert with the holes in the base and press
firmly.
Repeat for the second foot assembly.
STEP 5
Replace your drip tray, accessory tray, water tankand…
..Get Rollin!’