adobe AC2 Cam 2 WiFi Indoor/Outdoor Security Camera Instruction Manual
- June 6, 2024
- adobe
Table of Contents
Abode Cam 2
Front of Camera
Get support visit support.goabode.com
For setup instructions, download the Abode app on:
Back of Camera
Bottom of Stand
Pairing Process
- Remove the camera, USB power cable, and USB wall adapter from the box.
- Open the stand so you can access the back of the camera. Thread the cable through the stand and connect it to the USB input.
- Connect the USB cable to the wall adapter and then connect to power outlet. The status LED will light up orange to indicate power.
- Download the Abode app and Mm go to the Devices tab or Settings menu to add a new device.
FCC Warning:
Any Changes or modifications not expressly approve: by the party
responsible for compliance could void the user’s authority to operate the
equipment. This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator & your body.
This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interferenceto radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
ISEDC RSS Warning:
This device complies with ISEDC licence-exempt RSS standard (s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
ISEDC Radiation Exposure Statement:
This equipment complies with ISEDC RF radiation exposure limits set forth
for an uncontrolled environment. This transmitter must not be co-located or
operating in conjunction with any other antenna or transmitter. This equipment
should be installed and operated with minimum distance 20cm between the
radiator & your body.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This radio transmitter has been approved by Industry Canada to operate with
the antenna types listed with the maximum permissible gain indicated. Antenna
types not included in this list, having a gain greater than the maximum gain
indicated for that type, are strictly prohibited for use with this device.
For detailed mounting and operating instructions go to
goabode.com/AbodeCam2
Abode Systems, Inc., 2625 Middlefield Road #900, Palo Alto, California 94306,
United States
© 2021 Abode Systems, Inc. All rights reserved.
V1.0
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>