TTArtisan c10 Light Meter (Brass) User Manual
- June 4, 2024
- TTArtisan
Table of Contents
TTArtisan c10 Light Meter (Brass)
Specifications
Material: 6061 Aluminum | Measuring Angle: Approximately 45° |
---|---|
Power Source: CR2032 | Shutter Speed: Ambient 1sec.- 1/2 00J |
Battery Life Around 60h | Measuring Mode: Average Metering |
PRODUCT OVERVIEW
Instructions
Equipment Installation:
Open the package, use a cross screwdriver to unscrew the top right screw at
the bottom, and insert the button battery.
Note: When inserting the battery, first insert it from the end of the battery
compartment with the metal the piece, and then press the other end, the
battery is stuck in the battery compartment and the installation is successful
If it is difficult to install, do not press violently, please adjust the
battery direction and try again.
@Metering Steps:
Set the ISO, aim at the target to be shot. press the metering button, and wait
for 0.5s to complete the metering.
Rotate the aperture dial or the shutter dial until the indicator light turns
green which means an accurate exposure.
As shown in the right figure, the current accurate exposure value is FS.6,
S1/125. Then according to the algorithm, the combination of F and S linked by
the red dotted line above and below the red dot is also the current accurate
exposure. In the case of ISO 400. there are a total of 5 recommended
parameters, as shown in the table below.
Speed (sec) | 1/30 | 1/60 | 1/125 | 1/250 | 1/500 |
---|---|---|---|---|---|
Aperture | F11 | F8.0 | F5.6 | F4.0 | F2.8 |
Metering Button:
Click the button to start metering
If there is no operation within 10 seconds, the indicator will automatically
turn off and wake up by any operation;
If there is no operation within 60 seconds, it will enter sleep mode, and you
need to click the metering button again to wake up
Indicator Light:
Equipment Preservation and Warranty Matters
If the device is not used for a long time, please remove the battery and store
it in a dry place
The warranty is two years from the date of purchase. The following conditions
are not covered by our warranty service
- Counterfeit and anti-control products of our company.
- Accidental or man-made damage, water intake, bumps, etc.
- Unable to provide proof of purchase such as receipts, order numbers, etc.
- The purchase date of the product exceeds the warranty period
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>