Yuposl YPF01-B001 Mushroom Automatic Pet Feeder User Manual

Yuposl YPF01-B001 Mushroom Automatic Pet Feeder

Mushroom  Automatic Pet Feeder

• Model: YPF01 &YPF02
• Manufacturer: Shenzhen Connection Technology Co., Ltd Address:5B1203, Shangpinyayuan,Yangmei Community, Bantian Steel, Longgang District, Shenzhen, China
• Made in China
• YPF01&YPF02 V1.0

Please read this manual before using the product and keep it for future reference.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

IN THE BOX

• Automatic Pet Feeder x1
• Stainless Steel Bowl x1
• Bowl Tray x1
• Desiccant x1
• User Manual x1
• Power Adapter x1
• Power Cable x1

PRODUCT OVERVIEW

• 1: Desiccant Holder
• 2: Lid Release Button
• 3: Lid
• 4: Food Tank
• 5: Tank Release Button
• 6: Indicator
• 7: LCD Display
• 8: Operation Panel
• 9: Food Outlet
• 10: Base
• 11: Stainless Steel Bowl
• 12: Bowl Tray
• 13: Cable Slot
• 14: Power Port
• 15: Battery Compartment
• 16: Battery Cover
• 17: Anti-skid Pad

DISPLAY & INDICATORS

• The red light flashes and the screen shows: Low battery, please change the battery.
• The red light flashes and the screen shows: Food gets stuck, please remove the food tank and unclog the food outlet.
• White light stays on: Working well.

Note: To reset the feeder, in the unlocked state, press the Unlock/Return button and the OK/Setting button simultaneously for 3 seconds until all icons on the screen light up, the resetting is complete.

GETTING STARTED

Installation

1. Press the release button to open the lid, and put in the desiccant bag.

2. Add food to the tank.

3. Lock the lid securely.

4. Install the stainless steel bowl and bowl tray.

Power on

Dual Power Modes

• Connect the power cable and install the batteries as a backup in case of power cuts.
• The feeder can run on batteries alone.

Power off

Unplug the power cable and remove the batteries.

Setting the Current Time

Note: The feeder can work well only when the time of the feeder is consistent with the current time.

• After the feeder is powered on, press and hold the Setting Button for about 3 seconds, the hour digit flashes, press the  Up/Down button to set the hour, and then press the Setting Button to confirm.

• The minute digit flashes, press the Up/Down button to set the minute, and then press the Setting Button to confirm.

• The AM icon flashes, press the Up/Down button to choose AM or PM, and press the Setting Button to confirm, that the current time setting is complete.

Setting the Feeding Plan

• Setting the Feeding Time

  • After the current time is set, you can set the feeding time of the first meal.
  • The meal number 1 and the hour digit flash simultaneously, press the Up/Down button to set the feeding time of the first meal, choose AM or PM, and then press the Setting button to confirm.

• Setting the Feeding Portion

  • After the feeding time is set, you can set the feeding portion of the first meal.
  • The meal number 1 and the portion digit flash simultaneously, press the Up/Down button to set the feeding portion of the first meal and then press the Setting button to confirm.
  • The feeding plan of the first meal is set, repeat the above steps to set meals 2-6.

Notes:

• Up to 6 meals can be set.
• The maximum portion per meal is 16. Recommended Feeding Plan

CLEAN AND CARE

• Remove the food tank, stainless steel bowl, and bottom tray.

• Rinse the food tank and stainless steel bowl, detergent can be used, wipe dry or air dry the parts before use.

• Do not wash the base with water, use a dry or wet cloth to clean.

Notes

1. Unplug before cleaning.
2. Do not wash or soak the feeder base in water, as the base contains electronic components.
3. To keep food from moisture, air dry or wipe dry all parts after cleaning.
4. For the health of pets, rinse it thoroughly if detergent is used for cleaning.
5. To keep food fresh, replace the desiccant once a month.

Troubleshooting

3s to enter the setting mode.
| In the locked status, press + or – to check the settings of each meal.
I forget the meal settings.| 1) Please make sure the food in the tank is dry, and food size is within 2-15 mm/0.07-0.6 inches in diameter.
| 2) Check if the chute inside is blocked. If blocked, remove the food tank, and then remove the blockage.
| 3) Check whether the battery level is low, whether the power adapter is connected, and whether a power outage occurs when the power adapter is connected and batteries are not installed.
The food won’t come out.| 1) Please make sure the food in the tank is dry, and food size is within 2-15 mm/0.07-0.6 inches in diameter.
| 2) Check if the chute inside is blocked. If blocked, remove the food tank, and then remove the blockage.
The food amount of each portion is not the same.| The first few portions may vary, but it doesn’t mean it’s faulty. After about 6 feedings, it should be almost even.

Specifications

YPF01:

• Model: YPF01
• Input: AC 100-240V 50/60Hz
• Capacity: 2L/67oz
• Battery Power Option: 3 x D alkaline batteries
• Dimensions: 315x254x168mm / 12.4x10x6.6in
• Weight: 1100g / 2.4lbs

YPF02:

• Model: YPF02
• Input: AC 100-240V 50/60Hz
• Capacity: 4L/135oz
• Battery Power Option: 3 x D alkaline batteries
• Dimensions: 315x314x168mm / 12.4×12.3×6.6in
• Weight: 1200g / 2.6lbs

SAFETY INSTRUCTIONS

• Dispose of all packaging materials properly. Some items may be packed in plastic bags; these bags could cause suffocation. Keep them away from children and pets.
• Do not use the feeder with pets that are not able to reach the food tray or with any physical disability.
• Do not immerse the base part in water at any time as it may damage electronic components like the control panel.
• Do not use the feeder outdoors. Check its operation frequently to be sure it is dispensing properly.
• Do not use wet, canned or moist food.
• Do not disassemble the feeder other than as instructed in this user manual.
• Only use accessories recommended or sold by the manufacturer. The use of accessories not recommended or sold by the manufacturer may cause an unsafe condition.
• Do not modify the pet feeder.
• Examine the feeder after installation. Do not plug in if there is water on the power cable or plug.
• To avoid tripping, always position the power cable out of the way of foot traffic.
• Do not install or store the pet feeder where it will be exposed to weather or temperatures below 4°C (39.2°F).
• Use D alkaline batteries to power the feeder. Do not use rechargeable batteries.
• Check the batteries regularly. Before leaving for an extended period, always replace batteries with new ones.
• Do not lift the pet feeder by the lid, food tank, or food bowl. Lift and carry it using both hands and the base, while keeping the feeder in an upright position.
• Suitable for dry food only, with kibble sizes ranging from 2-15mm (0.07-0.6in) in diameter. Larger kibble may get stuck at the food outlet.
• Do not put your fingers into the food outlet or let your fingers touch the rotor.
• Power off the device when it’s not in use.

WARRANTY

• 12-month warranty
• For guidance on product use, please contact our customer service team via email: [email protected]

FCC statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

• this device may not cause harmful interference, and
• this device must accept any interference received, including interference that may cause undesired operation.

Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE:

This equipment has been tested and found to comply with the limits for a Class B digital device, under Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used by the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
• This device and its antenna(s) must not be co-located or operated in conjunction with any other antenna or transmitter.

Radiofrequency exposure statement

To maintain compliance with the FCC’s RF Exposure Guidelines, this equipment should be installed and operated with a minimum distance of 20cm from your body.

Frequently Asked Questions

Yuposl YPF01-B001 Mushroom Automatic Pet Feeder: How do I reset the feeder if needed?

To reset the Yuposl YPF01-B001 Mushroom Automatic Pet Feeder, in the unlocked state, press the Unlock/Return button and the OK/Setting button simultaneously for 3 seconds until all icons on the screen light up.

How can I set the current time on the Yuposl YPF01-B001 Mushroom Automatic Pet Feeder?

After the Yuposl YPF01-B001 Mushroom Automatic Pet Feeder is powered on, press and hold the Setting Button for about 3 seconds. The hour digit will flash. Use the Up/Down button to set the hour, then press the Setting Button to confirm. Repeat for minutes and AM/PM.

Can I set multiple feeding times and portions with the Yuposl YPF01-B001 Mushroom Automatic Pet Feeder?

Yes, you can set up to 6 meals with different feeding times and portions using the Yuposl YPF01-B001 Mushroom Automatic Pet Feeder. Follow the instructions provided in the user manual to customize the feeding plan.

What is the maximum portion size per meal for the Yuposl YPF01-B001 Mushroom Automatic Pet Feeder?

The maximum portion per meal for the Yuposl YPF01-B001 Mushroom Automatic Pet Feeder is 16. Ensure that the portion size you set is suitable for your pet's needs.

How do I clean the Yuposl YPF01-B001 Mushroom Automatic Pet Feeder?

To clean the Yuposl YPF01-B001 Mushroom Automatic Pet Feeder, remove the food tank, stainless steel bowl, and bottom tray. Rinse the food tank and stainless steel bowl with detergent if needed. Do not wash the base with water; use a dry or wet cloth to clean it. Ensure all parts are dry before reassembly.

What type of batteries should I use for the Yuposl YPF01-B001 Mushroom Automatic Pet Feeder?

Use D alkaline batteries to power the Yuposl YPF01-B001 Mushroom Automatic Pet Feeder. Do not use rechargeable batteries.

How often should I replace the desiccant in the Yuposl YPF01-B001 Mushroom Automatic Pet Feeder?

It is recommended to replace the desiccant in the Yuposl YPF01-B001 Mushroom Automatic Pet Feeder once a month to keep the pet food fresh and free from moisture.

Can I use wet or canned food in the Yuposl YPF01-B001 Mushroom Automatic Pet Feeder?

No, the Yuposl YPF01-B001 Mushroom Automatic Pet Feeder is designed for dry food only. It is not suitable for wet, canned, or moist food.

What should I do if the buttons on the Yuposl YPF01-B001 Mushroom Automatic Pet Feeder do not work?

If the buttons on the Yuposl YPF01-B001 Mushroom Automatic Pet Feeder are unresponsive, press and hold the Unlock Button for 3 seconds to enter the setting mode. In the locked status, press + or - to check the settings of each meal.

What if the food gets stuck in the Yuposl YPF01-B001 Mushroom Automatic Pet Feeder?

If food gets stuck in the Yuposl YPF01-B001 Mushroom Automatic Pet Feeder, please remove the food tank and unclog the food outlet. Ensure that the food in the tank is dry and within the recommended size range.

How can I check the battery status on the Yuposl YPF01-B001 Mushroom Automatic Pet Feeder?

The battery status is indicated by the red light on the feeder. If the red light flashes and the screen shows Low battery, please change the battery, it's time to replace the batteries.

Can I use rechargeable batteries with the Yuposl YPF01-B001 Mushroom Automatic Pet Feeder?

No, it is recommended to use D alkaline batteries with the Yuposl YPF01-B001 Mushroom Automatic Pet Feeder. Rechargeable batteries are not suitable for this device.

Video-Yuposl Automatic Cat Feeders

Download The PDF link:Yuposl YPF01-B001 Mushroom Automatic Pet Feeder User Manual

Reference:Yuposl YPF01-B001 Mushroom Automatic Pet Feeder User Manual- device. report

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>