eta 0111 Induction electric cooker User Manual

eta 0111 Induction electric cooker

OPERATING INSTRUCTIONS

Dear customer, thank you for purchasing our product. Prior to putting this device into operation, please read these instructions for use carefully and be sure to store well these instructions along with the warranty card, receipt and, if possible, also the product packaging and its inner contents.

SAFETY PRECAUTIONS

• Before the first use, read the instructions for use carefully, look at the picture and store the instructions for use for the future. Consider the instructions for use as a part of the appliance and pass them on to any other user of the appliance.

• Check whether the data on the type label correspond with the voltage in your socket. The power cord plug has to be connected to the properly connected and grounded socket according to the national standard.

• This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision. Children younger than 8 years must be kept out of reach of the appliance and its power cord.

• If the power cord of the appliance is corrupted, it has to be replaced by the manufacturer, its service technician or a similarly qualified person so as to prevent dangerous situations.

• CAUTION – Do not use the appliance with an external time switch, remote control or any other part that turns the appliance on automatically as there is a risk of fire if the appliance is covered or improperly placed at the moment it is turned on.

• Never immerse the appliance into water or any other liquid (not even its parts)!

• Before replacing accessories or accessible parts, before assembly and disassembly, before cleaning or maintenance, or after finishing your work, turn off the appliance and disconnect it from the mains by pulling the power cord from the power socket!

• Never use the appliance if its power cord or plug is damaged, if it does not work properly, if it fell down and was damaged or if it fell to water. In this case take the appliance to a special service to check its safety and proper function.

• WARNING: The appliance and its exposed parts become hot when used.

• WARNING: Unattended cooking on the cooktop using fat or oil may be dangerous and result into fire.

• NEVER attempt to extinguish the fire with water. Always turn off the appliance first, and then cover the flames, for example by a pot lid or a fire blanket.

• ATTENTION: The cooking process must be under your continuous supervision. Short-time cooking processes must be supervised uninterruptedly.

• WARNING: Fire hazard: do not put any items on the cooktop surface.

• WARNING: If the surface is cracked, switch off the appliance to prevent electric shock.

• Switch off the appliance after use by its control button, and do not rely on the pan detector.

• While using the appliance, the induction zone of the cooktop is not heated. Only the bottom of the vessel is heated, from which the cooktop induction zone takes heat as a secondary effect.

• Do not put any metal utensils on the induction plate (e.g. lids, spoons, knives, etc.). They may heat up once the appliance is switched on and cause burns!

• Pay careful attention when handling the appliance to avoid injury, (e.g. burns, scalding).

• The appliance is intended for home use and similar (in shops, offices and similar workplaces, in hotels, motels and other residential environments, in facilities providing accommodation with breakfast). It is not intended for commercial use!

• Do not plug the fork of the supply cord into the power outlet and do not unplug the cord with wet hands or by pulling by the supply cord!

• The appliance is not intended for outdoor use.

• The appliance must not be used in damp or wet environments and in any environment with the danger of fire or explosion (spaces where chemicals, fuels, oils, gases, paints and other flammable or volatile materials are stored).

• Do not place the appliance on unstable, fragile or flammable surfaces (e.g. glass, paper, plastic, wooden varnished boards and various fabric/table cloths).

• Use the appliance in the working position only at places with no risk of turning over and in sufficient distance from heat sources (e.g. heater, stove, cooker, oven, grill), flammable objects (e.g. curtains, drapes, etc.) and wet surfaces (e.g. sinks, wash basins, etc.).

• To avoid injury (burning), do not move the appliance when it is hot!

• In regard to fire safety, the appliance complies with EN 60 335–2–6. Within the meaning of the standard, this appliance may only be operated on a table or on a similar surface provided a safe distance is maintained from flammable materials, i.e. at least 500 mm
  in the direction of the main heat radiation and 100 mm in the other directions.

• Never put any foreign items, such as wires, in the air intake or air outlet.
  There is a risk of electric shock.

• Persons with a cardiac stimulator or an infusion pump may only operate the induction zone cooker under the precondition that their implants comply with Regulation 2004/108/EC. Scientific tests have proven that induction heating poses no risk for them. Nevertheless the persons using cardiac stimulators should keep a distance of at least 60 cm from the cooktop, if it is switched on.

• Do not heat up any unopened cans on the cooktop. Cans might explode during heating. Therefore always remove the can lid before you start warming up the can content.

• Do not place the appliance too close to other appliances that might respond to the magnetic field (e.g. radio, DVD, CD and cassette players, etc.).

• Never cover the appliance. Otherwise there is a risk of fire.

• Do not put the cooker on soft surfaces (e.g. carpet) when switched on; the ventilation openings could be blocked.

• Please take care that no dirt gets into the appliance (for example dust clouds, hairs, etc.). If any dirt is sucked and deposited inside the appliance, clean it.

• The appliance is fitted with circuit breakers, which will interrupt power supply in the case of dangerous overheating, undervoltage or overvoltage.

• Do not heat or overheat vessels, if empty.

• Do not put paper or similar combustible materials between the vessel bottom
  and the cooktop. They could ignite and cause fire.

• After use, turn off the appliance by its control button before removing the vessel from
  the cooktop.

• There is a risk of heating up metal necklaces, bracelets or rings.

• Never put the power cord on hot surfaces or do not let it hang over the edge of a table
  or a work top. Plugging or pulling the power cord e.g. by children can result in tilting over or drawing the appliance down and serious injury!

• The power cord must not be damaged with sharp or hot objects, open fire, it must not
  be sunk into water or bent over sharp edges.

• Use this appliance only for the purpose for which it was designed as specified in this user‘s manual. Never use the appliance for any other purpose.

• The producer does not undertake any responsibility for damage caused by improper use of the appliance (e.g. deterioration of food, injury, burning, scalding, fire, etc.) and its guarantee does not cover the appliance in the case of failure to comply with the safety warning above.

FEATURES OF THE DEVICE (pic. 1)

A – Induction cooker

• A1 – Induction heating zone
• A2 – Rotary knob
• A3 – Air outlet
• A4 – Air intake

B – Control panel

• B1 – ON/OFF button
• B2 – Function selection button (POWER/TEMP)
• B3 – Timer button
• B4 – Panel lock button
• B5 – Timer indicator light
• B6 – Lock indicator light
• B7 – Display
• B8 – TEMP temperature indicator light
• B9 – POWER indicator light

PREPARATION

Cookware
Only the cookware with ferromagnetic bottom is suitable for the induction cooking.
The suitable cookware can be easily recognised by moving a magnet towards the cookware base. If the magnet is attracted, the cookware is suitable for induction cooking.

of stainless cookware
Aluminium with a Teflon coat, with an added magnetic layer| Aluminium
Enamel| Glass
Copper with sandwich bottom (with an inserted magnetic layer)| Copper with sandwich bottom (without magnetic layer)
With flat bottom for cookers with flat cooktop| With round bottom (or feet)
With flat bottom (or feet)
With the bottom diameter corresponding to the cooktop diameter (about 12-24 cm)| With the bottom diameter smaller or much larger than the cooktop diameter

Appliance installation and ventilation

• Place the appliance on a stabile, flat, smooth and dry surface.
• Never place the appliance on a combustible surface (such as textiles, carpet, etc.).
• Do not place the induction cooker on a metal surface.
• Keep the minimum clearance of 10 cm from walls or other objects.
• Make sure that the power cord is not damaged or pressed under the appliance, and is not lying on sharp edges, hot or wet surfaces.

Meaning of light/sound signals and codes on the display

• I ndicator light is flashing – the required function can be set;
• Indicator light is steadily lit – the function is on;
• 1 beep = connection to the mains; switching on; operation confirmation; change in the settings;
• Beeps every two seconds – cookware has been removed from the cooker; when an error code appears.

OVERHEAT PROTECTION

The induction cooker is equipped with overheating protection function. If the top plate becomes overheated (with empty pot or pan put on it), a long sound signal will sound. It will automatically shut off after several minutes of cooking. Switch off the appliance, disconnect it from electric power and let it cool down.
If overheating occurs, i.e. if you (contrary to operation manual) heat up an empty pot or a pan made from low-quality material with insufficient deformation resistance, the aforementioned protection may not react correctly. The appliance top plate may be irreversibly damaged.

Error codes

cooking. Bottom diameter should be over 12 cm.
E1| Internal temperature sensor malfunction| Please contact the authorised service centre!
E2| Control panel sensor malfunction| Please contact the authorised service centre!
E3| Source voltage is higher than

270 V

| Switch off the appliance and disconnect it from electric power. Connect the appliance to a stabile voltage source (230 V).
E4| Source voltage is lower than

140 V

| Switch off the appliance and disconnect it from electric power. Connect the appliance to a stabile voltage source (230 V).
E5| Inner temperature is too high| Switch off the appliance and let it cool down before switching it on again.
E6| Thermal fuse automatically stops operation| Check the inlet and outlet ventilation openings to make sure they are not blocked. Let the appliance cool down. If the problem persists, please contact the authorised service centre.
– H –| Temperature on the ceramic plate too high; pot/pan has too high temperature| Wait a few minutes and let the plate or pot/pan cool down

INSTRUCTIONS FOR USE

Plug the power cord into an electric outlet. The appliance will switch to a standby mode
(“OFF” will appear on the display). Then put a suitable cookware on the plate centre.
To switch on the appliance, press B1 “ON/OFF” button. “00” and function indicators will start flashing on the display.

POWER function
Start heating by pressing B2 button. The first press will select the heating mode, depending on the set up output power. B9 indicator will light. The display will show the power setup
„06“. Select the required power from 01 to 10 using the rotary knob. For levels 1 to 6, cyclic switching is applied to achieve lower output power.

TEMPERATURE control function
There is a temperature sensor underneath the ceramic glass plate to detect the bottom temperature of the cookware put on the top plate. User can set the desired temperature, and the thermostat will adjust the current temperature of the cookware bottom to match the set temperature. Once the set temperature is reached, the heating (power supply) will switch off. If the bottom temperature drops too low, the heating (power supply) will be restored. This mode of operation maintains the temperature within the defined interval (± 20% depending on the cookware in use).

The heating mode controlled by the temperature setting may be selected by pressing B2 button again. Temperature will set to 120 °C and B8 indicator will light. Select the desired temperature by the rotary knob in the interval from 60 °C to 240 °C (in increments of 20 °C). To set up the heating timer, press B3 button. B5 indicator will light and the display shows “0:00” (“:” is steadily lit). Turn the knob and select the required cooking time in minutes up to 3 hours (0:01 to 3:00). Confirm the set value by pressing B3 button repeatedly, or wait 5 seconds (“:” will start flashing). After the cooking time is selected, countdown will start. Once the countdown reaches zero, the appliance will automatically shut off.

Note

• If the time setting needs to be re-adjusted, press and hold for several seconds B3 button
• this operation will cancel the previous timer setting.

Automatic turn of when lifting away the dish
When the cooking dish is lifted away from the cooking surface, the unit will TURN itself OFF. If the dish is returned back on the surface within 45 sec, the cooking process will resume with the pre-lifting settings. If the dish is NOT returned back within 45 sec, the unit will TURN OFF completelly.

Locking the controls
The touch buttons B2 and B3 can be locked by pressing the lock button B4. B6 indicator will light. The lock can be cancelled by holding B4 button for about 3 seconds.

MAINTENANCE

Before any maintenance is performed, disconnect the appliance from the mains by unplugging the power cord from the electrical outlet! Only clean the cooker after the surface has cooled down! Do not use harsh and abrasive cleaning agents!
Wipe the appliance with a damp cloth and dishwashing detergent. Remove dirt from the air inlet grid and fan by a vacuum cleaner.  Clean the ceramic glass surface and the control panel with a damp cloth and mild detergent for cleaning ceramic glass surfaces. Please prevent scratching the ceramic glass plate by the cookware bottoms. During the cooker service life, some minor scratches may appear on the top plate, which however do not affect the function and safety of the appliance. This fact will not be acknowledged as a reason for filing a claim.

Storage
Ensure ther ring is cold before storage. Store the ring at a safe and dry place, out of reach of children and incapacitated people.

ENVIRONMENTAL CONSIDERATIONS

If the size of the appliance allows, all the parts contain marking of the materials used for production packaging, components and accessories as well as for recycling. The symbols on the product or in the accompanying documentation mean that the electrical or electronic product used must not be liquidated together with communal waste. To ensure the appropriate liquidation take the used appliance to a collection point where it will be accepted free of charge. Correct liquidation of the product helps to protect valuable natural resources and helps to prevent a potential negative impact on the environment and human health which can be the outcome of inappropriate liquidation of waste. More details can be obtained from your local authorities or the closest collection point. Inappropriate manipulation of such waste can result in a fine according to the national legislation. Any major maintenance or one requiring that any internal parts of the appliance are modified must be made only by a specialised repair shop. Failure to observe the manufacturer’s instructions can void the warranty.

SPECIFICATIONS

• Voltage (V) shown on the type label of the appliance
• Power rating (W) shown on the type label of the appliance
• Induction heating zone diameter (mm) 200
• Size of the product (mm) 75 x 280 x 355
• Approximate weight (kg) 2.4
• Protection class of the appliance Input in standby mode is < 1 W

The manufacturer reserves the right to make minor modifications which have no effect for the product function.

References

• AEG Hausgeräte | Setzen Sie auf Qualität | AEG
• ElektroEko – Odbiór odpadów elektro
• Úvod | ELEKTROWIN, a.s.
• Úvod - Envidom
• ETA - tady je doma
• ETA - tu je doma

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>