aigostar 100801WNS LED Strip Light Instructions
- June 3, 2024
- aigostar
Table of Contents
aigostar 100801WNS LED Strip Light
Please read this manual carefully before operating your product. Even you pass your product to others, please also follow the below instructions and operator safety. We do not take responsibility for improper use or not following this operation manual and safety advice lead to damage to property or even injury to persons. Any warranty daim is also determined as void. please check whether the product is complete. If you find any defects, please contact the salesman immediately and make sure the package is ok.
PARTS
- Led strip 5M
- Remote control (CR2025, 3V button battery included)
- Adapter
Note
- The way to test the photoelectricity parameter value of the product: Take 0.5m strip light and test it with12V DC power supply, and read the bare light source data.
- Test conclusion:
- Class I
WARNING:
- THE PRODUCT IS NOT A TOY, PLEASE TAKE THE PRODUCT AND PACKAGE FAR AWAY FROM ADULT OR CHILDREN WHO CAN NOT EVALUATE THE RISK
- THE PRODUCT NEEDS TO INSTALL BY A QUALIFIED ELECTRICIAN AND INSTALLED IN ACCORDANCE WITH LOCAL REQUIREMENTS.
- PLEASE TURN OFF THE POWER SUPPLY BEFORE ANY OPERATIONS.
- THE PRODUCT NEEDS TO BE CLEANED CORRECTLY. AVOID CLEANING THE PRODUCT WITH SHARP OR ABRASIVE DETERGENT.
- ELECTRONIC WASTE AND ELECTRONIC DEVICES CAN NOT DISPOSE OF WITH ORDINARY HOUSEHOLD WASTE.
- THE REMOTE CONTROL CONTAINS NON-RECHARGEABLE BATTERIES, PLEASE MAKE SURE TO KEEP AND DISPOSEIT CAREFULLY. DO NOTTHROW THE BATTERY INTO A FIRE OR IMMERSE IN WATER.
- DO NOT LOOK DIRECTLY INTO THE LIGHT
- PLEASE PUT THE PRODUCT ON DRY SURFACE, AND KEEP A SAFETY DISTANCE AWAY FROM OVEN AND HEATER TO AVOID EXTREME TEMPERATURE ELECTROSTATIC INTERFERENCE, STRONG IMPACT, AND HIGH VOLTAGE.
- ONCE THE PRODUCT BREAKS OR MALFUNCTIONS, PLEASE TURN IT OFF IMMEDIATELY AND CONTACT QUALIFIED ELECTRICIAN OR SERVICE PROVIDER TO DEAL WITH IT.
- 1F FIND LEAKING BATTERY, PLEASE MAKE SURE TO AVOID OUR SKIN, EYES AND MUCOSA TOUCHING THE BATTERY” SACID. IN CASE OF CONTACT WITH SKIN, WASH IMMEDIATELY WITH PLENTY OF WATER.
Parameter
- Battery type: CR2025 3V Button battery
- Remote control range: About 5m
- LED strip: 1P65
- Adapter & Wire: IP20
Installation
- Clean the surface.
- Measure the desired length.
- Cut to size should be operated in the place where marked scissors, and the interval of 100MM can be cut).
- Peel off the protective foil.
- Stick the strip in place
- Connect the strip to the controller.
- Use screws or tape to mount the controller to any surface.
- Connect controller to the DC adapter.
The 2-year quality guarantee under the correct operations.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>