KLUS PUSZ-ZM-1 Power Supply Suspension Set Instruction Manual
- June 1, 2024
- KLUS
Table of Contents
KLUS PUSZ-ZM-1 Power Supply Suspension Set
Product Specifications
- Product Name: Fastener set PUSZ-ZM-1
- Model Number: C28130
- Contents:
- 1x Screw M6x45
- 1x Drywall anchor M6x37
- 1x Nail anchor M6x60
- 1x Connector conductive
- 1x Pressure screw M6x6
- 1x Fastener masking cover
- 1x Conical spring
- 1x Power connector dia. 6
- 1x Pad M6
- 1x Pressure screw M6x70
- 1x PUSZ head
- 1x Sleeve for the cable clamp
- 1x Conductive terminal block with screws
- 1x Nut M3
- 1x Locking washer M3
- 1x Power connector dia. 3
- 1x Pad 3,2
- 1x PUSZ-ZM hook
Product Usage Instructions
Mounting Procedure
- Refer to the detailed mounting procedures and related accessories on www.KlusDesign.eu for specific instructions.
- Ensure all components are securely fastened according to the provided specifications.
- Use appropriate tools for installation to prevent damage to the product.
Safety Precautions
- Wear appropriate safety gear, such as gloves and goggles, when handling the product.
- Avoid over-tightening screws to prevent damage to the components.
- Keep small parts away from children to avoid choking hazards.
Maintenance
- Regularly inspect the installed fasteners for any signs of wear or loosening.
- Tighten any loose components immediately to ensure stability.
FAQ
- Q: Are additional mounting procedures available?
- A: Yes, more mounting procedures and related accessories can be found on the official website at www.KlusDesign.eu.
- Q: How do I know if I am using the correct fastener?
- A: Refer to the product manual or contact customer support for assistance in identifying the correct fastener for your specific application.
- Q: Can I reuse the fasteners?
- A: It is recommended to use new fasteners for each installation to ensure optimal performance and safety.
Parts And Tools
Fastener set PUSZ-ZM-1 (ref. C28130)
- 1.1 Screw M6x45
- 1.2 Drywall anchor M6x37
- 1.3 Nail anchor M6x60
- 1.4 Connector conductive
- 1.5 Pressure screw M6x6
- 1.6 Fastener masking cover
- 1.7 Conical spring
- 1.8 Power connector dia. 6
- 1.9 Pad M6
- 1.10 Pressure screw M6x70
- 2.1 PUSZ head
- 2.2 Sleeve for the cable clamp
- 2.3 Conductive terminal block with screws
- 2.4 Nut M3
- 2.5 Locking washer M3
- 2.6 Power connector dia. 3
- 2.7 Pad 3,2
- 2.8 PUSZ-ZM hook
IMPORTANT: Not all possible mounting procedures are presented here.
More mounting procedures and related accessories can be found at
www.KlusDesign.eu.
Drawings in these instructions are simplified and only approximate the actual
shapes.
Installation Instructions
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>