KLUS TEPIKO LED Strip Instruction Manual

May 15, 2024
KLUS

KLUS TEPIKO LED Strip Instruction Manual

TEPIKO and PIKO-ZM mounting instructions

TEPIKO

Parts needed to mount the TEPIKO and PIKO-ZM prole

Parts needed to mount the TEPIKO

Materials and tools needed for mounting

  • glue
  • gypsum
  • paint
  • driller

NOTE! All LED strips must be connected to a 12 V or 24 V power supply.

IMPORTANT: The manual presents the simplest mounting procedure.
More mounting procedures and related accessories can be found at klusdesign.eu

  1. Drill a hole in the mounting strip (A).

  2. Insert the large end cap (D) into the mounting strip (A), and then place the protective insert (E) in it.

  3. Connect the power cable and run it through the hole drilled in the mounting strip. Attach the strip to the mounting surface with glue.

  4. Apply plaster finish, covering the wings of the mounting strip. The protective insert protects the inside.

  5. Remove the protective insert (E).

  6. Drill a hole for the power cable in the profile (B).

  7. Insert the clip (H) into the profile (B).

  8. Attach the LED strip (G) with the power cable in the profile (B) using glue. Insert the cover (F) and small end caps (C).

  9. Snap the assembled lighting fixture in the mounting strip.

www.klusdesign.eu

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals