Tribit BTH100 QuietPlus Active Noise Cancelling Wireless Headphones User Manual
- June 3, 2024
- Tribit
Table of Contents
Tribit BTH100 QuietPlus Active Noise Cancelling Wireless Headphones
Packing List
Product Illustration
Turn on/off
To Connect Via Bluetooth
- When the headphones are off, press and hold the power button until the status indicator starts to flash red and blue alternately ( the headphones have now entered Bluetooth Pairing Mode).
- Activate the Bluetooth function on your device and wait for it to search for other Bluetooth-enabled devices.
- Tap the name NTribit QuietPlusH on your device once it appears on the list of available devices. The status indicator will flash slowly and the headphones will make a sound when they have successfully paired to your device.
Aux-in Connection
Connect one end of the 3.5mm Stereo Audio Cable to your device, and connect
the other end to the 3.5mm Stereo Aux-in Port of the headphones. The Bluetooth
headphones will automatically shift from Bluetooth mode into Aux-in mode.
Operation of Buttons
Power Button
- Play/Pause: short
- Answer/Hang up Calls: press short press
- Next Track: press twice
- Previous Track: press 3 times
- Reject Calls: press and hold for 3s
- Voice Assistant: press for 1 s until tone sounds then release
Volume Buttons
Volume+: short press to increase volume or keep it pressed to
continuously increase the volume
Volume•: short press to decrease the volume or keep it pressed to
continuously decrease volume
Connection Conversion between Two Devices
- Pause the playback of current device
- Play the audio file of the second device
How to Charge
Connect one end of USB-C charging cable to a SV power adapter (not included),
and the other end into the headphones. The status indicator will glow red
during the charging process, then turn blue after the headphones are fully
charged ( within 3 hours).
Reset
Please do the following to reset your headphones if the device isn’t working
normally: Connect the headphones to the USB interface of your computer or USB
power adapter via the USB-C charging cable. If the status indicator glows red,
the headphones have been successfully reset.
FCC Statement
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>