BTS38 TRIBIT XSound Go Portable Wireless Speaker Instruction Manual
- June 1, 2024
- Tribit
Table of Contents
BTS38 TRIBIT XSound Go Portable Wireless Speaker Instruction Manual
Hereby, Thousand shores Deutschland GmbH declares that the radio equipment
type Portable Wireless Speaker BTS38 is in compliance with Directive
2074/53/EU.
The full text of the EU declaration conformity is available at the following
internet address: http://files.tribit.com/BTS38-eu-doc.pdf
To Charging The Speaker
When the power is lower than 20%, the red light blinks.
When charging, the red light is always on.
When fully charged (about 4 hours), the red light turns off.
Power On/Off
Short press the power button once to turn on/off the power.
The speaker will automatically shut down when there is no audio input or
operation for 15 minutes.
Pairing
Short press the Bluetooth button once to enter pairing mode.
The speaker can be connected to up to two Bluetooth devices at the same time.
Short press the Bluetooth button twice to disconnect Bluetooth.
Controls
xl : Press once
x2 : Press twice
x3 : Press three times
2s : Press and hold for 2 seconds
Reset : Press and hold the +- button at the same time for 5s
Stereo Mode
- Turn both speakers on;
- Long press the Bluetooth button of Speaker A for 5s, and let go when you hear the voice announcement;
- Short press the Bluetooth button of Speaker B, then both speakers will announce the voice at the same time to indicate the success of TWS.
Safety Precautions
- Do not place the speaker in a place where it is easy to fall.
- Do not disassemble, repair or modify this product by yourself.
- Keep the speaker away from extreme temperatures.
- Do not use the speaker in an outdoor thunderstorm environment.
- Do not use any corrosive cleaners or other chemical solutions to clean the speaker.
- 72-month warranty.
Specications
Bluetooth Version : V5.3
Output Power : 28W
Bluetooth Protocol: A2DP, AVRCP.HFP,HSP
Frequency Response Range: 80-20KHz
Frequency Band Range : 2402-2480MHz
Maximum Transmission Power : e;6dBm
Battery: 2000mAh2
Play Time: 24 hours(At 60% volume)
Charging Time : About 4 hours
Waterproofing Grade : IPX7
Size: 175mm x 59mm x 56mm
Weight: 380g
FCC Statement
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These mits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 75 of the FCC rules.
Operation is subject to the following two conditions (l)this device may not
cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
IC Caution
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions: (7) This device may not
cause interference, and (2) This device must accept any interference,
including interference that may cause undesired operation of the device.
FCC SAR Information Statement
IC SAR Information Statement
