Autige W77 3 In 1 Magnetic Wireless Charger User Manual
- June 1, 2024
- AUTIGE
Table of Contents
Autige W77 3 In 1 Magnetic Wireless Charger
Device Layout
Horizontal/Vertical Mode
Folded Mode
The content of this manual and product specifications are subject to change without notice.
Product Parameter
- Product Name: 360°Rotating 3in1 Nightstand
- Wireless Charger
- Product Size: 828632mm
- Product Weight: 197g
- Product Material:ABS+PC+Silicone
- Input: 9V/2A 12V/2A
- Mobile Phone Output: 15W/10W/7.5W/5W
- Headphone Output:3W
- iWatch Output: 2.5W
- Charging interface: Type-C
- Compatibility: support mobile phones, Airpods, and iWatch that comply with the Qi standard.
Steps for usage
The device is connected to the power supply through the charging cable, and then it can be powered on. when charging the mobile phone, place the mobile phone in the mobile phone charging area to start charging, the magnetic wireless charging will automatically locate itself by magnetic force. When charging the Apple Watch, place the Watch flat in the charging area to start charging the Watch. When charging the Airpods, place the Airpods flat in the charging area to start charging ;
Special Note
- When charging the iWatch, recommended to use flat and vertical charging at 90*. Do not select 30″, as charging may not be possible at this angle.
- Recommended to use the supplied charging cable for power supply, and not to use the original iPhone cable.
- Please use a qualified PD protocol or QC protocol power charger, otherwise may lead to unstable or abnormal blink.
- Please do not use the mobile phone protection shell with a metal back or the mobile phone protection shell which thicker than 4mm.
Packaging accessories
- 3 in 1 wireless charger *1
- USB-C charging cable *1
- Manual *1
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible forcompliance could void the user’s authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radiofrequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Consult the dealer or an experienced radio/TV technician for help.
- The FCC certification of this device refers to RF exposure testing performed in typical operating conditions, where a person is no closer than 20 centimeters from the device surface at all times, except for non-repetitive patterns with transient time intervals in the order of a second. Only in the stated conditions, the device is shown to fully comply with the FCC RF Exposure requirements of KDB 447498.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>