unitech PA768 Gun Grip User Guide
- May 15, 2024
- unitech
Table of Contents
unitech PA768 Gun Grip
Product Information
Specifications:
- Product Model: PA768 Gun Grip
- Manufacturer: Unitech Electronics Co., Ltd.
- Trademark: Unitech
Product Usage Instructions
Package Contents:
Please ensure the following items are included in the PA768 Gun Grip gift box. Contact your Unitech representative if something is missing or damaged.
- The Bottom Bumper
- The black mylar on the pogo pin (for gun grip)
- The hand strap and fixed arm
Getting Started:
- Remove the Bottom Bumper from the PA768 before use.
- Remove the black mylar on the pogo pin for the gun grip.
- Attach the hand strap and fixed arm.
Assemble with Terminal:
- Align the PA768 with the gun grip and insert from a 45-degree angle.
- Press down on the PA768 until you hear a click sound. Ensure there is no gap between PA768 and the gun grip.
Disassemble with Terminal:
Grab two protrusions on both sides of the gun grip, bend outward while pushing the PA768 upward to remove it from the gun grip.
Safety Instructions:
WARNING!
Handle the battery pack carefully to avoid fire and burns. Do not disassemble, crush, puncture, short external contacts, or dispose of the battery pack in fire or water. Do not attempt to open or service the battery. Dispose of used batteries according to local recycling guidelines.
CAUTION!
To ensure proper unit functionality, keep connectors away from contaminants like dust, grease, mud, and water. Negligence may lead to communication loss, short circuits, or overheating. If the connector is damaged, ensure it is fully repaired before use to prevent short circuits.
FAQ
Q: What should I do if an item is missing from the package?
A: Contact your Unitech representative for assistance if any item is missing or damaged in the package.
Q: How do I dispose of used batteries?
A: Dispose of used batteries according to local recycling guidelines to ensure proper environmental practices.
Package
Please make sure the following contents are in the PA768 Gun Grip gift box. If something is missing or damaged, please contact your Unitech representative.
The Package Content
- PA768 Gun Grip
- Wrist Strap
Getting Start
Please remove the following items from PA768 before using.
- The Bottom Bumper
- The black mylar on the pogo pin (for gun grip)
- The hand strap and fixed arm
Pogo Pin on PA768/Gun Grip
Assemble with Terminal
-
Align PA768 with the gun grip and insert from about 45 degree angle.
-
Press down PA768 until you hear a click sound.
Make sure there is no gap between PA768 and the gun grip.
Disassemble with Terminal
Grab two protrusions on both sides of gun grip, and bent outward while pushing PA768 upward, then you can remove it from the gun grip.
WARNING!
- There is a risk of fire and burns if the battery is handled improperly.
- DO NOT disassemble, crush, puncture, short external contacts, or dispose the battery pack in fire or water.
- DO NOT attempt to open or service the battery.
- Dispose used batteries according to local recycling guidelines in your area.
CAUTION!
To ensure the unit working properly, please keep all connectors away from the
contaminants such as dust, grease, mud, and water. Negligence may cause the
unit to lose communication, short circuit, or overheated. If the connector is
damaged, please ensure the connector is fully repaired before using the unit
to avoid short circuiting.
Copyright 2023 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>